Question about 2006 Chevrolet Impala

Open Question

2006 chevrolet impala keyless remote will not work

The fob battery has charge, but still won't work with car even when close up.

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: Remote start and door locks will only work from 10 feet or less

i had the same problem... go through the menu until you see reprogram remote. hit the check mark button and hold the lock and unlock button until the horn honks. key has to be on car not running though. You will eventually have to do it again but for some reason it will work for a while.

Posted on Feb 04, 2009

  • 33 Answers

SOURCE: remote keyless entry not working

KEY FOBS FOR THIS MODEL MUST BE PROGRAMED USING A TECH 2 SCAN TOOL SO IT MUST BE DONE AT THE DEALERSHIP FOR ABOUT HALF HOUR LABOR HOPE THIS HELPS

Posted on Mar 28, 2009

  • 71 Answers

SOURCE: 2006 Chevy Impala - Can't Clear Replace Battery in Remote Alarm

There is a fault code present and you will have to take it to a dealership for them to use a Tech II and read the code.

Posted on Jun 21, 2009

  • 7 Answers

SOURCE: program a keyless remote on a 2006 impala

push relearn again then press and lock and unlock for about ten seconds till u hear beep

Posted on Jul 15, 2009

  • 1 Answer

SOURCE: Key remote stopped working

I HAD THE SAME PROBLEM, CHANGED OUT BATTERIES IN MY REMOTES AND HAD THEM TESTED AND THEY WORKED FINE. THEY DEALERSHIP STATED IT WAS NOT UNDER WARANTY AND IT WOULD COST $600 TO FIX IT. YOU CAN ONLY REPLACE IT THRU A CHEVY DEALERSHIP. KIND OF A SCAM!

Posted on Sep 08, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How many wire harness clips connect to rcdlr module on 2007 impala besides the antenna


2007 Chevy Impala Keyless Entry: Keyless Entry Only ...

www.2carpros.com/questions/2007-chevrolet-impala-chevy-keyless-entry
Dec 30, 2010 - CHEVY KEYLESS ENTRY ... 2006-2007 Chevrolet Impala, Monte Carlo ... Remove the clips holding the RCDLR antenna wire at the RCDLR module and along the "A" pillar. 5. ... Connect the new antenna to the RCDLR antenna module. 11.... The existing antenna is grounded into another wiring harness.

TPMS and key FOB range problems - LS1TECH

ls1tech.com/forums/ls4.../719926-tpms-key-fob-range-problems.html
May 24, 2007 - 2006-2007 Chevrolet Impala, Monte Carlo ... Remove the clips holding the RCDLR antenna wire at the RCDLR module and along the "A" pillar.

Buick Workshop Manuals > Lucerne V6-3.8L (2007 ...


Dec 01, 2015 | 2007 Chevrolet Impala

1 Answer

ADDING KEYLESS ENTRY OPTION TO 2002 CHEVROLET IMPALA


If it is built without it then all you can do is this: http://www.bulldogsecurity.com/Products/453055507-model-ke1702-vehicle-keyless-entry-system.aspx If it is built with it then the ones you bought will not work. you will have to goto the dealer and get them programmed for the car. you cannot do it yourself

Mar 12, 2014 | 2002 Chevrolet Impala

1 Answer

2000 toyota avalon keyless remote won't open/close the car; checked with Auto Zone, fob is responding which means it is no battery, tried reprogaming and it stops when tried using fob, what else should...


2000 Avalon keyless remotes stopped working: solution Both keyless remotes for my 2000 Avalon stopped working. The batteries were good (I checked them with a volt-ohm meter). The Toyota dealer determined that the remote used most was defective and it tried to initialize the receiver in the car. This caused the second remote also not to work. The dealer reset the receiver (reinitialized it after first unplugging it), replaced the defective remote with a new one, and reprogrammed both remotes. Total cost: $225 labor, 164 for new remote. Later, another remote went bad. I just stopped using it.

Dec 13, 2012 | 2000 Toyota Avalon

1 Answer

I replaced the battery in my key fob and now the remote start will not work it pops the trunk open. How do i get the remote start to work again?


If it pops the trunk then the unit is still programmed correctly to the vehicle. I would open it and check the buttons and ensure you didn't pinch them and they are still making contact with the pads inside key fob. Probably just stuck after closing the remote.

Nov 11, 2011 | 2006 Chevrolet Impala

1 Answer

Servicing battery charging system. car won't start. 2006 chevy impala.


Check the battery terminals for cleanlyness and tightness.
Check the voltage when stopped, it should be 12 volts.
Check the voltage with the motor running, it should be 14 volts. If not the alternator is not charging.
If the battery voltage is low then it may need replacing.

Sep 05, 2011 | 2006 Chevrolet Impala

1 Answer

My remote keyless entry won't work. It does work if my car door is open. Very strange. Any suggestions?


on this model you can go through the onboard computer where it tells the tire pressure oil life ect. and change options on your impala keyless system. make sure the keyless entry is turned on. i hope this helps any other questions post back to me.

Aug 25, 2011 | 2007 Chevrolet Impala LS Sedan New Cars

1 Answer

The keyless remotes are not working at all and I have tried new batteries and they still are not working.


There is a web site for free that will tell you how to program you remotes.look up remote keyless entry replacement's

Aug 05, 2011 | 2006 Chevrolet Impala

1 Answer

I have a 2006 Chevrolet Impala I lost my keyless remote, my battery is dead when I try to charge it my alarm goes off. How can I stop it my alarm from going off and get my car to crank?


You need to leave the charger on while the alarm is going off and put the key in the ignition and turn it on and off 5 times the alarm should turn off . Don't try to start it just turn it on till the light in the dash come on the turn it . 3 to 5 time of this should reset the alarm.

Apr 28, 2011 | 2006 Chevrolet Impala

2 Answers

Keyless entry for my 07 Chevy Impala works on and Off


my 2006 impala keyless remote dont work i change the battery still the same problem the spare remote same problem how to solve this problem

Jul 21, 2009 | 2007 Chevrolet Impala LS Sedan New Cars

3 Answers

Remote start and door locks will only work from 10 feet or less


i had the same problem... go through the menu until you see reprogram remote. hit the check mark button and hold the lock and unlock button until the horn honks. key has to be on car not running though. You will eventually have to do it again but for some reason it will work for a while.

Dec 04, 2008 | 2006 Chevrolet Impala

Not finding what you are looking for?
2006 Chevrolet Impala Logo

Related Topics:

78 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...