Question about 2006 Mitsubishi Lancer Ralliart

1 Answer

Oil signal flashes red but engine has enough oil

When accelerating signal turns off

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

When was the last oil change done? If the oil pressure sending unit leaking?

Posted on Jan 14, 2013

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

On my trip form Houston to San Antonio last saturday around 2pm in the afternoon, While driving at over 70 mph constantly for about 1 hour the engine light came on and the red flash siymbol came on in my...


go t auto zone and have them run a diagnostic for free when the light is on , that will tell you the problem easy , or you can buy an OBD scanner,

Jul 25, 2011 | 2004 Dodge Ram 1500

1 Answer

My 2003 dodge stratus idles rough like it might die out then when you start pressing the gas to accelerate it has a tough time accelerating right away but then when it starts goin it gets smoother also...


check or replace fuel filter for clogging up. if it does clog up, then you will not get enough fuel to engine to run it properly. it will stall at stops, and be very sluggish on takeoff. check fuel pressure if need be. could also be a bad catylist convertor. so check above first. Rent a fuel pressure guage from advance or oreilley's and check fuel pressure if needed. they will tell you the proper fuel pressure for your car.

May 03, 2011 | 2003 Dodge Stratus

2 Answers

The change oil light came on. on my friends 2002 monte carlo ss so i gave it an oil change and a new filter . the light won't go off.


The "Oil Change Reminder Light" has to be reset.

To reset the oil change reminder light with the accelerator pedal, turn the ignition switch to the ON position. Do not start engine. After turning the ignition ON, depress the accelerator pedal fully to the floor and let it up again 3 times within 5 seconds. The oil change reminder light should flash a few times to let you know that it is resetting. If it does not flash, turn the switch OFF and repeat the procedure. After it flashes, turn the ignition switch OFF. Then start the engine. The light should come on for a bulb check then go out and stay out.

Apr 12, 2011 | 2002 Chevrolet Monte Carlo

5 Answers

Whats the purpose of an oil pressure switch can it determine weather oil leaks from your grand prix or not?


The oil pressure switch or sending unit is a unit that receives an electrical signal showing what your cars oil pressure is.And yes it does partially does let you know when there is a problem somewhere in the oil system.For example if your filter gets clogged up your oil pressure will go down and then go up when you accelerate.If there was a leak in the system first you would probably see the leak And if the oil pump or oil pump shaft were to break you would have no oil pressure.So you can see the importance of having an oil pressure switch.I feel there are 2 guages that are important to watch are your oil guage and water temp guage they can tell you allot about how your car is operating.

Feb 09, 2011 | 1997 Pontiac Grand Prix

2 Answers

Oil maintenece light is on. Oil level is good. Could a clogged filter make this light go on?


This should only be indicating time for an oil change. Now, if the red, check engine light comes on, then you have an oil/engine problem.

Possibly the maintenance light wasn't reset when the last change was done. If you don't have the owners manual to check, I found a referenced method (below) to reset it through AMSOIL synthetic oil products. Good Luck

To reset Engine Oil light. Turn the ignition key to RUN with the engine off. Fully press and release the accelerator pedal three times within five seconds. If the Change Engine Oil light is flashing, the system is reset. The light will flash for up to 30 seconds or until the ignition is turned off. If the light comes on again and stays on for 30 seconds at the next ignition cycle, it did not reset. You will need to reset the system again.

Feb 09, 2010 | Saturn L-Series Cars & Trucks

2 Answers

How to reset change oil light on 01 Buick Century


How to Reset the GM Oil Life System
After changing the engine oil, the system must be reset.
1. With the engine off, turn the ignition key to RUN.
2. Fully push and release the accelerator pedal slowly
three times within five seconds.
If the CHANGE OIL SOON light flashes,
the system is resetting.
3. Turn the key to OFF, then start the vehicle.
The oil life will change to 100 percent.
If the CHANGE OIL SOON light comes back on,
the system has not reset. Repeat the procedure.

Dec 07, 2009 | 2001 Buick Century

3 Answers

How do i reset the oil light on a 03 saturn vue? i did the turn the key and press the gas peddle 3 times and that didn't work.


The procedure you used is for the 2006 > Vue, and will not work on your 2003. For the 2002-2005 Saturn Vue V4 or V6 - Under the hood you will see a black fuse box behind the battery. Open it up and you will see a red button, it is small and looks like a fuse but on the top it will say Oil-Res. Turn on the ignition & press and hold that button for about 10 seconds. You may want to have a friend sit in the driver's seat and watch for the indicator to start flashing, which indicates you've activated the reset. Turn off the ignition and that will reset the Oil light.

Nov 16, 2009 | 2003 Saturn VUE

2 Answers

Reset oil change message.


YOU TURN IGNITION TO RUN POSITION..ENGINE OFF..PRESS ACCELERATOR 3 TIMES WITHIN 10-15 SECONDS..RELEASE AND TURN KEY OFF..THEN START VEHICLE,IT SHOULD BE RESET

Jul 11, 2009 | 2008 Chrysler Sebring

1 Answer

How do I clear the " change Oil" dash light after an oil change?


  1. Turn the ignition to ON; do not start the engine.
  2. Fully depress and release the accelerator pedal slowly 3 times within 5 seconds.
  3. If the CHANGE OIL indicator flashes, the system is resetting.
  4. Turn the ignition to OFF after the indicator has finished flashing, then start the vehicle. If the CHANGE OIL indicator comes back on, the engine oil life monitor has not reset; repeat the procedure.

Jun 28, 2009 | 1998 Oldsmobile Intrigue

Not finding what you are looking for?
2006 Mitsubishi Lancer Ralliart Logo

108 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8518 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...