Question about Cars & Trucks
Fuel pump not working on ford windstar2002
.Here's a picture of it.1999-2003 Reset Button location
The switch is located inside the jack storage compartment found at the right rear corner of the vehicle. Remove the cover and it is behind the thin "foam" covering inside the compartment towards the rear of the vehicle.
It has a red button on the top of the switch, make sure the button is fully depressed. If it is and the vehicle still won't start check fuel pressure at the rail (there is a port on the rail which is under the hood on the engine) with a fuel pressure gauge. If the pressure is ok (about 30 psi) the problem is most likely not fuel system related.
The emergency fuel pump cutoff switch, also known as the inertia switch, cuts power to the fuel pump in the event of an accident - even a slow speed one - any sudden "jolt" can trigger the switch.
Posted on Jan 14, 2013
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: 1996 windstar relay
The fuel pump power on the Windstar is controlled by a component called a Constant Control Relay Module (CCRM).
Its located located on the driver's side of the engine compartment.
Posted on Oct 22, 2008
go to www.motorcraftservice.com then click on the owner guide and put in your truck information
then choose the 1st owner manual printing and should be between page # 184 to 200.
Good luck and I hope this will awnser your question.
Posted on Nov 08, 2008
in the mass fuse box, under the dash, unless you have the manual you will not beable to tell wich one it is.. get a chiltons repair manual or a haynes...
Posted on Nov 26, 2008
JUST RELEASE THE PRESSURE AT THE FUEL PRESSURE TEST PORT ON THE FUEL SUPPLY RAIL THAT SUPPLIES THE INJECTORS, IT IS A METAL VALVE LIKE A TIRE VALVE, THAT IS THE FACTORY RECOMMENDED METHOD..
Posted on Mar 11, 2009
Tips for a great answer:
Jan 22, 2017 | 2003 Ford Windstar
Jul 03, 2015 | Ford Cars & Trucks
Oct 23, 2012 | 2002 Ford Windstar Cargo
Aug 10, 2010 | 1996 Ford Windstar
Jul 03, 2009 | 1998 Ford Windstar
Nov 21, 2017 | Dodge Cars & Trucks
248 people viewed this question
Usually answered in minutes!