Question about 1989 Ford Crown Victoria

2 Answers

Tail light problel

1992 crown victoria tail light not working

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 1 Answer

Have you checked your grounds each corner has it on ground wire which is attached to the body close by

Posted on Dec 19, 2011

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 840 Answers

You need to get into trunk take the interior trim cover off the side light is off on. then take the back of the bolts out and pull the light out should be any fix

Posted on Jan 24, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1989 crown victoria tail light just stop woriking


CHECK FOR THE BULBS PROBABLY YOU WILL HAVE A BRAKE LIGHT BULB WIRE BROKEN.JUST RENEW THE BULBS.

Aug 29, 2012 | 1989 Ford Crown Victoria

1 Answer

Where is the headlight fuse located on a 92 ford crown victoria?


If you are keeping this vehicle and do your own work on it, I 'd recomend going to ebay and buying a original Ford EVTM (electrical vacuum troubleshooting manual) for your specific vehicle. It is a very simple and well illustrated book to understand.
I have one for my 1992 crown vic. It show a 40 amp fuse in the engine compartment fuse box for the lights.

Mar 31, 2012 | 1992 Ford Crown Victoria

1 Answer

No tail lights


check tail light fuse, under TAIL

Jul 05, 2010 | 1993 Ford Crown Victoria

1 Answer

Hi, How do I replace the tail light bulbs in my '97 Crown Victoria? Thanks


Sedans
  1. Remove the screw(s) and wing nut retainers at the rear of the luggage compartment and push the trim away from the back of the light.
  2. Remove the wing nuts retaining the light assembly to the vehicle and the retaining nut from either side of the luggage compartment and pull the light body assembly from the vehicle.
  3. Turn the bulb socket(s) counterclockwise to the stop and remove the socket(s) from the light assembly. Remove the bulb(s) from the socket(s).
  4. Installation is the reverse of the removal procedure.
56c16fa.gif
Push the trim away from the back of the light—1992-98 Crown Victoria

f147c29.gif
The rear tailamp assembly is held by various fasteners

da5bd90.gif
Remove the wing nuts retaining the light assembly to the lower back panel—1992-98 Crown Victoria

e896b59.gif
Remove the nut retaining the light assembly from the side of the luggage compartment

2e1520f.gif
Pull the light assembly away from the vehicle—1992-98 Crown Victoria

Oct 12, 2009 | 1997 Ford Crown Victoria

1 Answer

No check engine light


THE ENGINE HESITATES WHEN IDLING AND GOING SLOW AND EVEN THE ENGINE GOES DEAD. I TOOK TO THE SHOP TO CHECK OUT, BUT THE ENGINE LIGHT WAS NOT ON AND THE MECHANIC COULD NOT DIAGNOSE THE PROBLEM. PLEAS HELP!

Apr 25, 2009 | 1992 Ford Crown Victoria

1 Answer

Parking lights and tail lights not working


I found out that if I pull the headlamp switch a little bit that the tail lights will then work for some reason

Apr 09, 2009 | 1992 Ford Crown Victoria

1 Answer

1992 crown victoria stalls


I had the same problem until I cleaned the throttle body--Problem went away.

Jan 04, 2009 | 1992 Ford Crown Victoria

1 Answer

Tail lights not working while drive. brake,blinkers work


i have a crown victoria with brake lights no tail lights could you help me?

Nov 19, 2008 | 1989 Ford Crown Victoria

1 Answer

Problem with Fuse #9-tail lights&instrument panel illumination


there is an electrical short somewhere you have a power wire touching the car's body. Is there tail/brake lights in the trunk lid? if yes, check around the trunk hinge, the wiring sometimes follows the hinge back to the rest of the car and everytime you open the trunk, you are bending these wires unitl one of them snaps.

Nov 18, 2008 | 1992 Ford Crown Victoria

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

240 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

60541 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21927 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...