Question about Cars & Trucks

1 Answer

My 2002 monte carlo 3.4, shift knob cracked internally, there's a plastic piece down the center visibly broken thats changes the gears under the handle knob. How can I find that plastic piece? or

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.


    An expert who has answered 20 or more questions within one hour.


    An expert who has answered 20 questions.

  • Expert
  • 73 Answers

Check with your local junk yard and ask them about it or go to an auto parts store

Posted on Jan 14, 2013

Testimonial: "Thank you, Im mainly trying to see if its at all possible to replace that inner piece rather than the whole console."

6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 68 Answers

SOURCE: The low coolant light stays on in my 2002 monte carlo

Ur coolant level sensor might need changing. If not, the circuit associated with the coolant level sensor needs to be inspected

Posted on Jan 27, 2009

  • 19396 Answers

SOURCE: 2002 monte carlo ss

The fuel filter is located in the pressure line that runs from the fuel tank to the engine, near to the fuel tank.
Keep the engine off for few hours before replacing the filter, to get rid of some pressure in the lines.

Posted on Feb 27, 2009

  • 6982 Answers

SOURCE: plastic sleeve on shift linkage cable is broken

You cannot take the sleeve off. It comes with a new cable. Shift cable is enough for any parts man to know what you need. Generally this item is a dealer part.

Posted on Mar 26, 2009

  • 298 Answers

SOURCE: 2002 chevy monte carlo won't start

this vehicle is equipped with a factory anti theft system if when you try to start the engine and the anti theft light is on then the starter won't start even if your check engine light is not on you would have to scan the body module to pin point the problem to see if it's the anti theft system or the starter, go to a auto parts store like auto zone or pep boys or western auto these store offer free scanning to there customers. if this information has been helpful please let use know good luck

Posted on Jul 28, 2009

  • 6 Answers

SOURCE: how do I change the coolan sensor in a 2002 Monte

the low coolant sensor is on the side of the radiator about 3 04 inches below the radiator cap. Yuo can unclip the wire and then there is a clip I think or it may just push in with an o ring around the nipp;e. So you will have to wiggle it out. I have the same problem. I just unplugged the damn thing. (disconect the wire)


Posted on Nov 22, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

Where can i find a shift lock solenoid for my 2002 monte carlo ss? i have searched for days on internet and cant find anything.

just because you disconnected the shift cable from the trans doesnt mean the car is now out of gear. The interlock switch is located next to the shifter in the center console. Remove the bezel around the shifter and you should see a small tab that reads (shift interlock) pull it out of its holder and the shifter should once again move

Jun 18, 2015 | 2002 Chevrolet Monte Carlo

1 Answer

How to get trans out park when stuck

Chrysler doesn\'t sell this part alone, they sell the whole Shifter Box for over 200 dollars. Autozone sells this piece(park lockout mechanism) and its made from metal, I replaced it on my daughters 300 a few months ago

Procedure is as follows: Just stick a long screwdriver through the square hole just above the shift gear knob, not where the rubber surround is but above that after you take off the silver chrome plate surrounding the shift knob of course. line the screw driver up with the little cable you will see down in there about 3 inches push that to the left and pull your shifter knob to the right YOU NEED TO HAVE YOUR FOOT ON THE BREAK while you do this, if it doesn\'t work its because the spring that is attached snapped the hook off the pink plastic part, try the following

1 Break down that center console!, if you need to move the car immediately to get home or to your garage or shop then its not a problem if you have a few tools, start popping the trim off the shifter assy, pull up and out on the small storage compartment to the right of the shifter, this will uncover a small pink lever (which will get you at least on the road but may not work if this is broken , it was on my daughters car), if it is you need to go deeper! Take out the rubber mat directly under the ash tray and cigarette lighter, this will expose two philips head screws, undo them, move through trim with a flathead and keep prying trim off until you have the shifter assy visible, if your shift knob is giving you problems, try sliding the very bottom chrome plastic trim down then the knob up as you spread the white plastic at the base of the leather.

2 Ok your down to the shifter, now with the key in and the car running press and hold the pink lever on the right side of the shifter, there is also second pink part( this is the cheap piece of junk that has you doing what your doing) on the front of the shifter assy, press this pink part as well and as always with your foot on the brake try to shift, you should be in good shape, now to limp back to your proper repair facility of choice (your house) Shift into drive and only reverse if you need to, when you park leave in neutral and hit the parking brake,

May 31, 2014 | Chrysler 300C Cars & Trucks

1 Answer

My 2004 Honda accord. the gear shift knob the release button broke and I can't get it into gear

All you really need to do is take out the broken know, make sure their aren't any broken pieces inside the shifter handle and use you finger to push the lever down so it could shift, thats it. :-)

Jun 10, 2012 | 2004 Honda Accord

2 Answers

How do you remove the plastic monte carlo raised letters?

they stick on with double sided tape,they will be hard to get to stick back,and tape is hard to get off of car,you wowld be better off to order new ones

Feb 13, 2010 | 2002 Chevrolet Monte Carlo

2 Answers

2002 ls monte carlo "shudders" between 2,000-2400 rpm.....

My monte carlo would hit 2nd gear and bog down and not shift properly until it got to the last gear. I had the catalytic converter replaced and that fixed that problem. (It also created another, but not near as bad)

May 20, 2009 | 2002 Chevrolet Monte Carlo

1 Answer

The low coolant light stays on in my 2002 monte carlo

Ur coolant level sensor might need changing. If not, the circuit associated with the coolant level sensor needs to be inspected

Jan 27, 2009 | 2002 Chevrolet Monte Carlo

1 Answer

How to get off the shift knob

there is staple clip on the side of the shifter knob that can be pryed out with a small scew driver. good luck from schleck

Sep 03, 2008 | 1985 Chevrolet Monte Carlo

1 Answer

2002 Monte Carlo

Sounds like a transmission modulator. Its on the back of transmission with the vacuum line running to it.
Check to see if you have the vacuum undone or broke on intake or trans

Jul 30, 2008 | 2002 Chevrolet Monte Carlo

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

135 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides