Question about 2002 GMC Yukon XL

Open Question

2002 Yukon XL 1500 radio reception is terrible.

Has constant static. Is it possible to replace the antenna adaptor cable and connector myself?

Posted by on

4 Suggested Answers

old marine
  • 1456 Answers

SOURCE: 2001 gmc yukon xl 1500

Check to see if the power steering pump is still turning. If you have a broken drive belt (serpentine belt or "fan" belt), and the pump doesn't turn, you have no power assist. If the pump is still turning, check the fluid level in the reservoir.

Posted on Oct 31, 2008

aaangie220
  • 202 Answers

SOURCE: windshield wiper motor

under the plastic cowl that the windshield wipers are on top of. removal of the wipers is nessecary. then removal of the cowl is next. and underneath all that should be the motor.

OR sometimes it is mounted on the firewall in the engine bay on either side usually can't miss it.

Posted on Feb 09, 2009

  • 297 Answers

SOURCE: poor radio reception

could be or the station you have on.in between towers you will get static.

Posted on Jul 15, 2009

  • 8 Answers

SOURCE: I would like to change the fuel filter on my 2002

The location is on the driver side frame rail on the inside a few feet from the fuel tank forward. You need remove the negative terminal from the battery then open the gas cap to relieve the pressure then loosen the filter ie.open end wench or crecent wrench discard filter make sure the flow indicator is going the correct way away from tank. Tighten new filter connect, battery terminal, prime fuel lines by switching the key forward a few times then start. Good Luck

Posted on Nov 02, 2010

Testimonial: "Thanks Ryan I will give it a try!"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

AM and Fm radio reception poor. Suspect bad ground since radio and antenna have both been changed. The static sound while on AM increases when I press the accelerator. How do I isolate an intermitt


static sound on AM band can be reduced by the adding of a capacitor to the alternator terminal. Check the coax cable especially the outside braid is connected to the body for earth

Jan 07, 2014 | 2002 Toyota Highlander

1 Answer

I installed an aftermarket stereo on my 2006 Kia Sedona and now the FM reception is terrible


the cable that plugs in for the aerial could be a extension piece and puilling the old radio out could have unplugged this extension?

Dec 20, 2012 | 2006 Kia Sedona

1 Answer

Acura mdx am radio problems- terrible am reception- lots of static in 2003 acura mdx. how to fix


there is a tsb on this one..this issue is most of the time linked to poor contact ,corrosion in the wiring of the antenna, damaged or loose antenna. It is located on the rear of the roof and to access the wiring, the head liner must be pulled down.

Jul 19, 2010 | 2004 Acura MDX

1 Answer

I need an audio wiring schematic for 2002 yukon, or lead me to where i can find it. Thanks


2002 GMC Yukon Car Stereo Wiring Guide
Car Radio Battery Constant 12v+ Wire: Orange
Car Radio Accessory Switched 12v+ Wire: Yellow
Car Radio Ground Wire: Black
Car Radio Illumination Wire: Brown
Car Stereo Dimmer Wire: Gray
Car Stereo Antenna Trigger Wire: N/A
Car Stereo Amp Trigger Wire: N/A
Car Stereo Amplifier Location: N/A
Car Audio Front Speakers Size: N/A
Car Audio Front Speakers Location: N/A
Left Front Speaker Positive Wire (+): Tan
Left Front Speaker Negative Wire (-): Gray
Right Front Speaker Positive Wire (+): Light Green
Right Front Speaker Negative Wire (-): Dark Green
Car Audio Rear Speakers Size: N/A
Car Audio Rear Speakers Location: N/A
Left Rear Speaker Positive Wire (+): Brown
Left Rear Speaker Negative Wire (-): Yellow
Right Rear Speaker Positive Wire (+): Dark Blue
Right Rear Speaker Negative Wire (-): Light Blue

rate pls

Feb 26, 2010 | 2002 GMC Yukon XL

2 Answers

I have a 2001 yukon and i need to replace they entire antenna from the antenna base to the radio I can't figure how to route the new cable.


This will require dash removal, the factory routing for the cable is behind and above the airbox. The easiest way to do it if you have not already pulled the old one out is to attach a piece of 16 guage wire to one end of the factory cable before you pull it out, and then when you pull out the old cable it will in turn pull the 16 guage wire through in its place. At this point attach the new cable to the 16 guage wire and pull the 16 guage wire through which will in turn pull your new cable through. If you have already pulled the old cable out and want to install the new through the same route then you will have to remove the airbox, or you can just reroute the new cable.

Nov 22, 2009 | 2002 GMC Yukon XL

1 Answer

Do you have a pdf showing howt to remove the radio on a 2002 yukon xl


this very simply have done it many times. the trim that goes around the whole drivers cluster, rado, and HVAC controls pulls off straight towards the rear of the vehicle, use a upohlestry tool or carfully with a screwdriver, it comes off, you may have to move the tilt steering down and shift the gear slector to low range when you remove it (makes it easier) PARKING BRAKE ON WHILE DOING THIS. This exposes the radio and there should be four 7mm hex head screws, remove those, then pull the radio straight out, undo the connectors and radio antenna.

Oct 02, 2009 | 2002 GMC Yukon XL

1 Answer

No AM radio reception in my 2002 Audi A4


do you get any stations, even weak stations on the AM band?  If not you have a bad radio and need replacement.  Try having someone hold the antenna as you scan the AM band.

Apr 01, 2009 | 2002 Audi A4

2 Answers

Replace factory radio on 2002 yukon xl


all you gotta do is carfully pry the dash panel off (prying from the far left end is easiest) completely remove panel. then there are 2 clips that hold the factory sterio in place. push on the both clips while pulling the radio out. simply disconnect the wiring harness from the back of the radio. using an adapter avaliable at your local radio shop (scosche p/n gm02, mdarb and gm1483b) wiring harness, dash install kit, and antenna adapter. then simply match the colors on the new radio's harness to the adapter harness, crimping each connection with a "but plug". then simply follow the instructions included with the dash install kit to assemble the kit.connect the antenna adapter to radio, plug in all cables. test to see if everything works properly before the final install. install sterio into dash install kit, re installing kit where origional radio was. then simply put the panel back in its place by firmly pushing on it untill it snaps into place. then enjoy your new radio!

Dec 29, 2008 | 2002 GMC Yukon XL

2 Answers

Radio Problem


This id a classic antenna ground problem, check it out by plugging in a test antenna, I will bet it corrects the problem

Oct 13, 2008 | 2003 GMC Yukon XL

Not finding what you are looking for?
2002 GMC Yukon XL Logo

Related Topics:

70 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...