Question about 2000 Toyota Land Cruiser

1 Answer

Lack of pulling at all speed - 2000 Toyota Land Cruiser

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

  • Contributor
  • 2 Answers

Land Cruiser are notoriously underpowered. Make sure your not towing in overdrive. If this dosnt help then inspect your trailer. You need to pull the bearings and inspect everything so you at least know that it isn't the trailer thats weighing you down.

Posted on Jan 14, 2013

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Suzuki ignis 2002. I have a problem when the car is cool the transmission is ok, the speed past easy. when it run for a while it stay in one speed the 1 speed. Any idea what the problem is


get it serviced? yet? pops to mind first.
get it scanned yet?
your mech will drive it. and see if
1: transmission is messing up, (lots of ways there)
2: or engine power is lacking, or misfiring,
that takes hands no testing. we can do that here, nor tell you.

the top reason is, lack of service.
no car drives for ever, lacking service, zero.

Feb 21, 2016 | 2004 Suzuki Ignis

1 Answer

Diesel lack of power


Check and clean air filter.

Mar 25, 2014 | 2007 Mitsubishi Outlander XLS

1 Answer

Nissan d40 manual stx deisel runs fine revs right out but lacks power it used to have under load


Unlikely as the check will only point to an actuator sensor problem. Check the intercooler hoses are tight and check the intercooler for holes/cracks where there may be a loss of boost. Check that the turbine vanes are free to move by pulling on the actuator rod . If it doesn't move then the vanes facing the turbine are stuck and the variable effect is not working. Most small turbos have vanes that direct low speed exhaust onto the turbine wheel earlier to give boost at low rpm and the vane angle alters as the exhaust speed increases to give more torque to the turbine blades. This action is controlled by an actuator located in between the shells of the turbo and the actuator is controlled by vacuum hose connected to a electronic module operated by a sensor.. Check the hose as they become brittle from the heat and crack off.

Jan 26, 2014 | 2007 Nissan Navara 2.5

1 Answer

Engine cranks but won't start, Has OBD II code of P0172. Can hear the fuel pump and have checked the purge solnoid. Prior to this, the rpms were raising,but lacked power. Have pulled O2 sensor pri


Trouble Code: P0172

Fuel System Rich (Bank 1)

Possible Causes:


Base engine "mechanical" fault affecting one or more cylindersEVAP system component has failed or canister fuel saturatedFuel control sensor is out of calibration (i.e., ECT, IAT or MAP)Fuel system supplying too much fuel at idle speed or at cruiseFuel injector(s) is leaking or stuck partially open (one or more)HO2S is contaminated, deteriorated or it has failed.Ok Rusty,your mission is to figure and fix,got to go to work in the morning,good luck,this message will self distruct when repair is made.

Jan 06, 2013 | 2004 Chevrolet Cavalier

1 Answer

My 2000 Audi A6 lacks power at times when I pull out and I'm petal to the metaling it; than in a few seconds or so it bosts up to speed ;like it should. This happend a little more when I have my


do a little tune up.like change air filter and fuel filter,clean fuel injectors,have fuel pressure checked should be 55 - 61 psi.if fuel pressure lower than normal that will cause low power on take off.your vechicle call for higher fuel pressure.

Dec 17, 2012 | 2000 Audi A6

1 Answer

Engine lacks power when trying to pass no problm slowly getting up to speed but when I give it more than half the gas pedal it realy lacks power


LACK OF POWER CAN BE CAUSED BY MANY THINGS.LIKE STOPPED UP FUEL FILTER. TRANSMISION SLIPPING DUE TO LOW FLUID OR CLOGGED FILTER,RESTRICTED EXHAUST SYSTEM CAUSED BY CLOGGED MUFFLER OR CLOGGED CATALYTIC CONVERTER.

Aug 21, 2011 | 1994 Buick Regal Gran Sport

1 Answer

My rear end chatters around corners and if im pulling a trailer my abs light and the wrench shaped light will come on in my 2004 f150 fx4 supercrew


If you have a locking rear diff,it could be the clutches on the side gears or lack of fluid and special additive. Sounds like the wheel speed is off enough on corner,to set the ABS light,when it chatters. Don't over look parking brake and rear caliper issues.

Mar 10, 2010 | 2004 Ford F150

1 Answer

I think I have a timing issue. My car takes a second to start up and the car jolts when it changes gears. Also, my steering wheel shakes left and right when I'm driving at low speed


Ok,

same car with the AC problem. Timing is not going to make this all happen.

  • If its jaulting as an automatic, through the gears, then probably check and change the fluid and the filter in the transmission. Usual jolting is from lack of fluid pressure, caused by lack of or blocked filter.

  • Start up could be anything from a weak battery to lack of fuel/choke. Try a new fuel filter, air filter element, check your oil and change the spark plugs.

(Symptoms of bad ignition timing are misfire and run on also extreme lack of power and rough idle. The car will also shudder and keep running a few seconds after the key is switched off.)

  • The steering shaking from left to right at low speed could be a few things. Is it only happening at low speed? Sometimes its hard to tell at high speed as it is happening so fast the frequency is almost unable to be felt. However when you brake it should be pretty strong if its a mechanical fault, ie disc warped or bent wheel.
#Check your power steering fluid and hoses for leaks

Mar 04, 2010 | 1995 Honda Accord

1 Answer

Starts O.K. Lacks pulling power. Will not rev to full power.


check for a clogged exhaust look at catalytic converter it could be stop up.

May 24, 2009 | 1999 Suzuki Vitara

Not finding what you are looking for?
2000 Toyota Land Cruiser Logo

Related Topics:

127 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7710 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...