Question about Cars & Trucks

1 Answer

I have a 03 Toyota Camry, when driving about 60 and pressing on the gas it stopped accelerating. I could not accelerate above 55 - 60. At slow speeds it seemed to accelerate fine. No loud noises just a humming when trying to accelerate

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Cars & Trucks Master
  • 2,007 Answers

If there are no engine lights on, i would try changing the fuel filter first.

Posted on Jan 14, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 114 Answers

SOURCE: loud hum from front end-99 blazer 4x4

Sounds like the front hub bearing assembly.

Posted on Jan 22, 2009

michigan man
  • 3533 Answers

SOURCE: 1985 Toyota Camry sluggish acceleration

check the fuel filter and when was the last time you had a tranny service done and a tune up also check the drivebelt

Posted on Feb 06, 2009

  • 1 Answer

SOURCE: Slow acceleration from stop and when driving (trying to pass)

I have the same car. So far no problems with the Transmision. I had the Trans oil change out every 60 K Sure sounds like you need to get the Transmision checked. Is the fault light on. I have invested ina fault code reader sure is worth it. 
Good luck.  Vilmos

Posted on Mar 03, 2009

relaga58
  • 158 Answers

SOURCE: Humming noise comming from front left wheel area of 03 Sebring

it may be just sound of uneven wear of tyres

Posted on May 09, 2009

ourhowse
  • 2007 Answers

SOURCE: loud clicking noise which the clicking noise getss faster as i accelerate

From what you are describing it sounds like it must be a valve lifter sticking. Try putting a cup of transmission oil in your crankcase, or pick up some suitable additive from your local parts store. I wish i could hear it and give you a better idea. Maybe let them listen to it at the parts store, and they can determine if it's a lifter or not. Let me know how you make out.

Posted on May 21, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How long is complete drive cycle for a 98 chevy blazer s-10 4.3


what do you mean by complete drive cycle as it is unknown terminology

Nov 18, 2017 | Cars & Trucks

1 Answer

What is the drive cycle for a 2003 Nissan Sentra SE?


Take extra caution while performing dirve cycles on public roadways. Drive cycles can be difficult to follow under normal driving conditions. Begin by: - Start the engine. Idle the engine in drive for two and a half minutes with the A/C and rear defroster on. - Turn the A/C and rear defrost off, and accelerate to 55 mph at half throttle. - Hold at a steady speed of 55 mph for three minutes. - Decelerate (coast down) to 20 mph without braking or depressing the clutch. - Accelerate back to 55 to 60 mph at ¾ throttle. - Hold at a steady speed of 55 to 60 mph for five minutes. - Decelerate (coast down) to a stop without braking. If all other emissions systems are functioning properly, completing the drive cycle above will set the "readiness flags" required to pass the smog check. It will not hurt to perform the drive cycle 2 or 3 times before the smog test.

Oct 06, 2016 | 2003 Nissan Sentra

1 Answer

Car hesitates / surges at 45 to 55 mph, intermittently.


There was a problem with dirty or clogged fuel injectors in 2006. This was significant enough for Toyota to issue a Factory Service Bulletin (FSB) and later revise it.

Jan 14, 2014 | 2000 Toyota Camry Solara

1 Answer

Toyota Camry 2l CSx flat roads ruining well. but when driving small gap or hill engine stop. at this time engine can start and accelerate 3000 RPM "N" position. But "D" position...


there is a problem in your gear shifter located insde your transmission. have a transmission expert check your transmission, since this is not a DIY job.

Aug 11, 2011 | 1988 Toyota Camry

3 Answers

My 1995 toyota Camry check engine light came on


be sure that the valve cover gasket is good also,,, if its leaking it floods out the top portion of the plug and wire, and will cause the motor to miss .

Jul 31, 2010 | 1995 Toyota Camry

2 Answers

Accelerator got stuck while passing a truck.


When you passed the truck... I guess you couldn't tell if the pedal was stuck since you were focused on braking.

When you brake, your brakes will overcome the acceleration of the car causing it to slow down, but like you describe, the second you let go of your brake, your car accelerates again.

It would sound like either the throttle pedal (gas pedal), the throttle line (connects pedal to throttle assembly) or your throttle assembly (on the engine) may be sticking....

Sep 03, 2009 | 2008 Toyota Camry

1 Answer

Engine bogs when flooring the pedal from a dead stop


try looking for an air hose that my be faulty, of has just been knocked of on its last service

Jun 04, 2009 | 1994 Toyota Camry

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

90 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

79847 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

john h

Level 3 Expert

14309 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...