Question about Cars & Trucks

1 Answer

Why hazard lights won't turn off

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 234 Answers

Relay is stuck on. Replace the indicator relay.

Posted on Jan 14, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

SOURCE: TURN SIGNAL, BRAKE & HAZARD LIGHTS

No Turn Signal Operation (blinker)The turn signal lights in your car are a basic electrical system that controls the front and rear blinker lights to alert the intended direction of the vehicle. We have listed some of the most common problems and repair troubleshooting tips below:
Troubleshooting Procedure
To start troubleshooting this problem:

  • Turn the key to the on position (do not start engine)
  • Inspect the system fuse located in the fuse panel and replace if needed. If you cannot find the location of the blinker fuse consult your owner's manual or an online repair manual
  • When a blinker flasher fails it can cause blinker lights to say on, not blink, or not go on at all. To test the blinker system flasher, remove the flasher unit and insert a jumper wire between the two terminals. If blinker stays on in both directions without blinking, replace the flasher. If you cannot find the location of the blinker flasher consult your owners manual or an online repair manual.
  • 1b7f814.jpg

Posted on Jul 09, 2009

  • 74 Answers

SOURCE: left turn signal won't work

depending on year,and model.... i would inspect hazard switch. if not a bad switch,a poor connection would be what i would look for.

Posted on Sep 16, 2011

johnf1aresti
  • 1098 Answers

SOURCE: turn indicator lights show parking lights & tail lights don't work

check for any blown bulb or fuse

Posted on Sep 28, 2012

ivan_whisker
  • 1013 Answers

SOURCE: Hi, my 2007 Chevy equinox is having a lot of

have you checked fuses and relays as they all seam to be from the same fuse as 1 fuse or relay runns numerus things not sure on model but thats where i would start hope this helps ivan

Posted on Oct 01, 2012

  • 366 Answers

SOURCE: I have a 1998 Chevy Z71 and I broke my hazard

Pull the wires off the back of your hazard button ,isolate them with tape or terminal block until you replace your broken hazard button. Replace the fuse you took out.

Posted on Nov 10, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 1998 Chevy Z71 and I broke my hazard light button. My hazard lights won't go off so I had to pull the fuse out but now I don't have brake lights or turn signal lights. What should I do?


Pull the wires off the back of your hazard button ,isolate them with tape or terminal block until you replace your broken hazard button. Replace the fuse you took out.

Nov 10, 2012 | Cars & Trucks

1 Answer

Hi, my 2007 Chevy equinox is having a lot of problems; my turn singnals won't come on, my hazard lights won't come on and high beam and fog lights won't work somebody please help with this...


have you checked fuses and relays as they all seam to be from the same fuse as 1 fuse or relay runns numerus things not sure on model but thats where i would start hope this helps ivan

Oct 01, 2012 | Cars & Trucks

1 Answer

Brake lights 65 mustang stopped working.I wondered can the issue be in steering column


On a "one brake light bulb per side" setup,the brake switch feeds 12v to the turn/hazard switch,and the switch will apply 12v to both when no turn signal activated,the right only when the left signal is on,the left only when the right signal is on,and none when the hazards are on.With this in mind,it IS possible that the turn signal switch or wiring is the issue.If you are still running the original switch,try removing the switch and cleaning/regreasing the contacts(or look for something obviously worn or broken).If the switch is bad-hey,you got almost 50 years out of it! I'll bet you won't get that much longevity out of anything built now!
'

May 31, 2012 | Ford Mustang Cars & Trucks

1 Answer

I have a 2004 Silverado 1500. The rear lights won't turn off, pulled all the fuses associated with lights and they still don't turn off. In addition my right turn signal doesn't flash, both the...


Not sure, but I've heard a bad hazard switch can cause strange problems.
Also, if your truck has a body control module that controls interior and lights, that may be your problem, too. Good luck.

Jan 26, 2012 | 2004 Chevrolet Silverado 1500 Crew Cab

1 Answer

I changed the fuse as the turn lights and hazard lights were not working but all other light including brake and interior worked. Now the hazard light stays on and I cannot turn it off. can you Help p


if your hazard lights stay on, you may have a problem with the hazard switch on your stearing collum. try moving it back & forth several times, eg. on, off, on, off always ending @ off & see if that works. they do get sticky @ times. your brake lights will work but your turn signals won't work properly with the hazard switch turned on. let me know if problem persists & will see if i can help you more. good luck.

Nov 24, 2011 | 1999 Saab 9-5

1 Answer

Brake lights & Hazzard lights don't work; fuse ok... High mounted center brake light works... Turn signals work...suspect problem is multifunction lever Power drain to battery constant...2...


As for the brake lights push brake pedal down while pushing on and wiggling the hazard switch.If the brake lights come on then replace the multi-function switch.

Aug 10, 2011 | 1997 Oldsmobile Bravada

1 Answer

Hazard light won't shut off


My 2009 Mercedes s 550 hazard light won't turn off

Jul 08, 2011 | 2007 Mercedes-Benz S-Class

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

182 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...