Question about 2006 Chevrolet Trailblazer

Open Question

Front passenger seatbelt jammed on a 2006 Chevy Trailblazer

The belt won.t retract fully so I can pull it back out

Posted by Anonymous on

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 4793 Answers

SOURCE: Need 3 point front seat, sensored seatbelts for '06 Trailblazer

for starters seatbelts do not have abs,you just need to get seatbelts that fit the anchorages so if chevy also make a trailblazer for another badge chances it will also fit(chevrolet in the uk sourced from korea)

Posted on Mar 20, 2010

  • 1915 Answers

SOURCE: 2004 chevy tahoe, the seatbelts

you should pull the belts all the way out to make certain that they are not folded over themselves-check to make sure there is not something in the locking mechanism causing this, and if necessary take the vehicle to the dealer to have them check it-usually safety related devices are covered under extended warranty terms and it may get repaired for free.

Posted on Mar 16, 2011

  • 5501 Answers

SOURCE: how to get passenger door open on 2006 chevy cobalt with seat belt stuck in door?

This is going to sound a little odd, but properly jack the car and then try opening this door. Put the jack in the recommended jacking spot on the passenger side.

Imagine that the back and front ends of the car are compressing the center of the car. By lifting one end or the other, the center may shift. Otherwise you do not have a frame, but the engine cradle may have a support located closer to the center of the vehicle. Do not jack the sheet metal, but you may catch the cradle and apply lift there.

You may notice by putting in a piece of cardboard in the doorjam on whether there is an increasing gap as you jack the car.

Posted on Apr 07, 2012

  • 73 Answers

SOURCE: I have a 2002 Chevy Tahoe and the 3 point seatbelt on the rear passenger side rear seat has been pulled out all of the way and now it won't retract back into it's holder. Is there an easy wa

The re-tractor is called an Inertia Reel. There on the side, remove the cover and there is a trigger release on most. If the spring is broken, you will need to replace the reel. Check at a local junk yard for the best price.

dc don

Posted on Sep 03, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I fix a stuck retractable seat belt?


You can't it is not designed that way. The seatbelt mechanism is damaged and needs to be replaced.

Feb 21, 2016 | 1999 Chevrolet Blazer

1 Answer

How do u fix a front seat seat belt retractor that is jammed inside the front right side of a 2006 trailblazer??


Some times you can't. However, using a long thin screwdriver and inserting it into the ratchet assembly you may be able to move the ratchet mechanism to release it. Look for any debris or a twist in the belt that may be causing the assembly to jamb

Aug 29, 2015 | 2006 Chevrolet Trailblazer

1 Answer

I have a 2002 Chevy Tahoe and the 3 point seatbelt on the rear passenger side rear seat has been pulled out all of the way and now it won't retract back into it's holder. Is there an easy wa


The re-tractor is called an Inertia Reel. There on the side, remove the cover and there is a trigger release on most. If the spring is broken, you will need to replace the reel. Check at a local junk yard for the best price.

dc don

Sep 03, 2012 | 2002 Chevrolet Tahoe

1 Answer

Need 3 point front seat, sensored seatbelts for '06 Trailblazer


for starters seatbelts do not have abs,you just need to get seatbelts that fit the anchorages so if chevy also make a trailblazer for another badge chances it will also fit(chevrolet in the uk sourced from korea)

Mar 20, 2010 | 2006 Chevrolet Trailblazer

1 Answer

'06 Volvo V50 drivers seat belt is jammed, there is no play in the belt and the ratchet locks immediatly no matter how gently it's pulled. Same problem with passenger side the day before but it righted...


I solved this on my 95 volvo 850 glt as follows:

pull the seatbelt pilar cover off from the door jamb. this runs vertically up the pilar between the front an back door (beside the front seats. Once opened loosen the belt by gently pulling the belt upward toward the roof. You'll have to do this sometimes in small increments. Once the seatbelt is pulled out all the way, spray small amount of lubricant into the joint where at the top of the belt spool. Also use a screw driver to push spool upward while pulling the belt. At first it's only going to release a little but eventually the lubricant will work its way into the seam at the top of the belt spool and loosen up the stuck inertia catch. Until it completely loosens you might have to remove the pilar cover again and work the seatbelt out (also use the screw driver technique described above) in order to use the seatbelt. When parking, I would relatch the seatbelt and pull the slack up around the back of the head rest. After a day or so it worked normally.

good luck and don't give up.

Feb 07, 2010 | 2008 Volvo V50

2 Answers

How do you fix a stuck seatbelt in front seat passenger side? The seatbelt has retracted but will not release outwards to enable its use. We have pulled off interior cover of the seatbelt to get access to...


this is a simple repair many dont know. remove or pull off plastic pillar post cover, seatbelt probably twisted inside. twist it back around so it runs flat and lube slightly with a light lube spray on metal gearing. i had the same problem w mine pk

Jan 16, 2010 | 1998 Ford Taurus

1 Answer

Front seatbelt jammed


If the seat belt has jammed, you may just need to replace the mechanism- you want it to do its job correctly when you need it
For your information,--You may need to replace the mechanism for the seat belt. If the impact restraint system has encountered what they refer to as a stage one deployment due to a minor accident, the seat belt locks up, and even though the airbag(s) hasn't deployed, there are frame sensors that may need replacing reset.
We encountered this with my daughter's 05 Focus and needed to replace the belt assembly, and a couple sensors on the frame..


Dec 13, 2009 | Ford Taurus Cars & Trucks

1 Answer

Passenger side seatbelt loose


clean seat belt with suitable cleaner. most of the time it doesnt slide through top piviot due to dirt build up

Jun 07, 2009 | 2001 Toyota 4Runner

1 Answer

I have a 2006 Ford Explorer and the passenger seatbelt won't retract; so passenger cannot use the seatbelt. Subsequently, the seatbelt chimer never goes off. How can I correct this?


will have to take the side panel off where the belt is located make sure no twists are present. if not pull it hard and see if it retracts, if it still does not retract you may have to replace the unit.
the retraction spring in the unit is broken, or the lock mechanism has failed.

Apr 30, 2009 | 2006 Ford Explorer

Not finding what you are looking for?
2006 Chevrolet Trailblazer Logo

Related Topics:

268 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75824 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8215 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...