Question about 1993 Mazda MPV

1 Answer

2002 mazda mpv ignition switch off/engine keeps running/help

Got to work, turned off ignition switch, engine kept running. Re-inserted key and turned switch off again, engine stopped running. Engine seems to be running fine but check engine light is on.

Posted by on

  • hx35543 Jan 23, 2009

    can you be a little more specific.

  • Anonymous Mar 17, 2014

    2009 Mazda 6, When parking, the engine can accelerate to the point that i have to close the ignition switch.

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Change the part

Posted on Jan 23, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2002 mazda mpv key won't come out


shift interlock is not working at shifter key wont turn to come out unless signal from switch tells it is in park.

Aug 03, 2012 | Cars & Trucks

1 Answer

1993 mazda mpv. i have to disconnect the battery because the headlights will turn on by themselves, also the warning lights are like a disco ball. also there is a problem with the ignition cause if the...


loose connection and you verified it with the ignition switch your describing a electrical problem in the ignition switch itself the electrical part

May 08, 2011 | 1993 Mazda MPV

3 Answers

2002 mazda mpv, key stuck in ingition and it is in park , but the key wont turn all the way to lock, it will only go as far as acc?


Mazda MPV have problems with failing gear shift change assembly ( includes park sensor micro switch)

Pull the fuse for the hazard lights ( 10amp) - if the key comes out, then the switch is defective.

Fix the problem by installing a new change lever assembly - part number for 2000 and 2001 MPV's is LC62-46-10XE with MSRP of $246.90. 2002-2004 would be a LD47-46-10XB with MSRP of $250.40.

May 23, 2010 | 2000 Mazda MPV

1 Answer

96 mazda mpv minivan 165k mi. Ran fine until one day just died.Had towed home.3 mech.tried diagnose gave up wouldn't start-turns over-no start. Last mech.replaced timing belt&idle pulley. Still no...


I was browsing unsolved problems. If you still have the problem, I'll try to help you. But it's going to be awhile trying to communicate back and forth. First...Check the engine for spark. Take off a plug wire and stick a screw driver in the wire end and place the metal part of the screw driver next to something on the van that's metal. Have someone crank it over for just a second or two and see if a small spark jumps from the screw driver to the metal part. I'll check back for your answer.

Mar 05, 2010 | 1996 Mazda MPV

2 Answers

Car was stolen ignition was ripped out of 2002 grandam, now car won't start with ignition and security light keeps flashing


groan.....gunna need a bit more info. but i'll try. What portion of the ignition was ripped out? The tumbler + switch? If so, you might need to get the car's system resent to recognize that it has a new ignition put in. Sime vehicles have a theft prevention system in place to prevent the vehicle from running if its been hot wired. Your best bet would be to replace the damaged ignition components (You did not mention if you did or not). If it still doesn't work after you have replced all of the ignition components. You can try to reset the vehicle (doesn't work on all) disconnect negative battery terminal and go back into vehicle and press down the brake pedal for about 30 seconds then reconnect battery and try it....good luck, hope this helps

Aug 17, 2009 | 2002 Pontiac Grand Am

4 Answers

Key in mazda mpv stuck in ignition


If you remove the fuse for the flashers, the key will come out. I keep the fuse handy in case I need to use the flashers and I'll just plug it back in!

May 19, 2009 | 2002 Mazda MPV

3 Answers

Program remote control for mazda mpv 2002


Courtesy of: forums.mazdaworld.org

Try this, it works on several 2002 models:


Step 1: Open drivers door and leave open.

Step 2: Lock and unlock the drivers door using the power door lock switch on the door.

Step 3: Insert key into the ignition.

Step 4: Turn key to on position and return to off position. (IMPORTANT - use ON position NOT ACC position). Do this 3 times within 10 seconds. Leave key in the ignition.

Step 5: Open and close the drivers door 3 times. (Door should be left open after this step).

Step 6: ECU should respond by locking and unlocking the doors.

Step 7: Press any button on remote #1. ECU responds by locking and unlocking the car doors.

Step 8: Press any button on remote #2 (etc.) Each time the ECU will respond by locking & unlocking the doors.

Step 9: Remove the key from the ignition and the ECU will respond a final time with a series of door locks and unlocks. You're done

Dec 06, 2008 | 2000 Mazda MPV

1 Answer

1996 Mazda MPV will not start


It sound like you need a new starter. I am not not sure why they serviced the distributor, but you mentioned the engine doesn't turn over. The only other thing could be a bad neutral safety switch or ignition switch. Have someone check the "signal" wire to the starter for switched power( power when you turn the key to start position). If power is present, I'd replace the starter. If not, check Ign. switch or neutral safety switch. I hope this helps

Nov 18, 2008 | 1996 Mazda MPV

1 Answer

REPAIR MANUAL NEEDED!!!!


The 2002, 2003 and 2004 Mazda MPV's all use the same Ford 6 cyl. 3.0 duratec engine. The Ford Escape and Mazda Tribute of those years use the same engine. Therefore if you need an inexpensive engine repair manuel for your 2002 MPV, get the Haynes ($20.00) 2001-2007 Escape/Tribute manuel. Mazda sells the a MPV shop manuel for $180.00. I also own a 2002 Mazda MPV LX. 75k miles.

Jun 16, 2008 | 2002 Mazda MPV

Not finding what you are looking for?
1993 Mazda MPV Logo

382 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...