Question about Cars & Trucks

Open Question

1987 nissan hardbody pickup..both doors stuck closed..WILL unlock..wont open..peeled back door panel..all rods and actuators in place and moving..no binding..door wont open

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: 2004 Nissan Murano, back door can't open

I had a similar problem with a sienna and sometimes the cable ( inside the door) between the handle and the latch gets stuck in the sleeve. Kind of like the brake cable on a bike.
take the panel off by removing all the screws you can see on the panel and pull the panel off. There will be plastic pins holding it. Some of them may pop off and some will break off.
Drip oil down the sleeve so the cable slides freely. I used bike chain oil. Do not use WD40. This is **** and will not work for very long. Try the handles a few times before you put the panel back.

Posted on Mar 03, 2009

Ad
  • 70 Answers

SOURCE: Sliding door won't unlock so I can't open it.

I saw this before and a wire was touching metal. It causes the door lock to mess up and stay locked you have to find the wire The one I saw was touching the metal plate on the door cover handle. A wise friend told me he has see it happen and he has found the wire that causes the trouble.

Posted on Mar 22, 2009

mcgyver468
  • 710 Answers

SOURCE: Saturn SW1 (97) outside RR door handle wont work,

YOU SHOULDN'T SEE THE INTERIOR ROD MOVE BECAUSE THE OUTSIDE HANDLE HAS IT'S OWN ROD THAT CONNECTS TO THE DOOR RELEASE THAT IS REALLY SHORT. IT MOVES DOWN WHEN THE HANDLE IS PULLED UP. TAKE OFF THE THREE SCREWS THAT HOLD THE DOOR CATCH ON THE DOOR AND YOU WILL SEE THIS SMALL ROD. I HOPE THIS HELPS YOU. LET ME KNOW. GOOD LUCK

Posted on May 03, 2009

  • 1 Answer

SOURCE: How do you remove the door panel of a 1995 Nissan XE Pickup

Not sure about the 95, but to remove it on my 94 i just pulled on once corner till the fastener poped out, then worked slowly around removing each fastener. Be careful as the the door pannel is quite flimsy but if the 95 is the same as the 94 it should be fairly easy to remove.

Posted on May 21, 2009

  • 35 Answers

SOURCE: 1997 F150 Pickup door wont open

I believe there is a cable which connects the handle to the latch, they are pron to breaking.

Posted on Jun 21, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Cannot open rear drivers side door from outside or inside. door panel is off, door is closed. child lock is on. tried pulling cable, wont move. tried lifting up the child lock with a thin blade


Sounds like the lock mechanism is stuck on the locked position. Since you didn't specify make and model this is a best guess. Make sure the lock is in the unlock position and try manipulating the rod connected to the outside handle (since child lock is on the inside handle won't work)

Oct 07, 2016 | Cars & Trucks

1 Answer

I hve a 2007 nissan altma and the front passenger door wont open. I replaced the locking assembly, and as soon as i closed the door it locked again. When I press the unlock button it moves but nothing...


sounds like the actuator in the door that locks and unlocks the door is jammed or too weak to move the lock assembly to fully lock/unlock positions. the linkage may be in a bind that can cause the same problem.

Jun 14, 2012 | 2007 Nissan Quest 3.5 Minivan

1 Answer

The passenger door on my 1991 Honda wagon will not open. It has power locks. They work. The door handle does not release the latch that holds the door closed. How do I get it free again?


the electric actuator has a rod connected to it in order to unlock door , rod could have came off or actuator is clicking but not working.(moving) while have to remove panel to watch operation of lock.

Mar 28, 2011 | Honda Accord Cars & Trucks

1 Answer

07 tahoe 3 doors work fine 1 wont unlock or open at all


These vehicles have weak door lock actuators.the door in question will need a new lock actuator.It comes with the door latch assembly.remove the door panel,disconnect all wiring and cable to inside door handle,peel back insulation glued to door,next remove rod coming from outside door handle from latch,remove wiring connector from latch,remove three screws holding latch in.carefull y guide latch out.

Dec 07, 2010 | Chevrolet Tahoe Cars & Trucks

2 Answers

Actuator on drivers door not locking or unlocking door.can hear the actuator work but not driving latch.


It needs replacing,it is weak,or it has came loose,pull the door panel to inspect the situation.

Jun 06, 2010 | 1998 Jeep Cherokee

3 Answers

Rear door stuck on 1997 Pathfinder...Have


go inside, lift on handle, then beat the **** out of the door pounding it like your trapped in it trying to get out. latch mechanism is probably corroded and froze shut. once open, spray with wd40 and work the lever a lot. then get door panel off to see if handle is broken inside

Jun 16, 2009 | Nissan Pathfinder Cars & Trucks

1 Answer

2000 nissan pathfinder back doors will not open


Are the doors manual or auto? Are your door lock actuators engaging when you hit the open/close button? Did you check all your fuses to make sure there all good? If every thing is checking good, and the door wont open from inside or outside, then your problem is : Inside your door are a series of rods, one goes from your inner door handle straight to the door lock assembly (it is dislocated from opening the door roughly) and one goes from the actuator to the door lock assembly which I believe also is dislocated, only way to fix this problem is to weasel your way through the edge of the door panel with a very long screwdriver (16-20") and a light and try to trigger the mechanism directly on the lock to open. This is alittle tricky and might require a trained technician to perform because with the door closed your panel might not come off which will raise the risk of destroying your door panel, in the long run paying a little money could save you a lot more if you break that panel!

Nov 14, 2008 | 2000 Nissan Pathfinder

2 Answers

Door will not open on Buick Regal 95


you need a long screw driver, 10mm, phillips, torxs bits, trim panel popper and a pocket screw driver. if you can hear the actuator working thhere is a plastic replacement boot. pop up the switch cover from the fron. remove the rear reflector/light remover 10mm bolts(3). remove the torx and the open handle cover. then use the trim panel popper and remove the panel. then take the long screw driver and follow tow lock rods to the ned then twist the screw driver. two more rods need to be removed at the back. one has a adjustment. do adjusted it! then remove the torx 30 latch in the outer door part. remove the latch. then two torx 10 on the actuator remove them. at this point you will see a pastic rod that is not connected because the boot came off or the actuator is bad. install the new boot in the latch then take the place rod or the actuator push it into the boot at a 45deg. then swing it down. o ya make sure the gears are aligned top all of the way to the right and the bottom to the left i think. its the same as when you pull it a part. also do not over tightend the actuator to the latch. have fun

Aug 05, 2008 | 1995 Buick Regal

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

62 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...