Question about 2001 Chrysler Town & Country

Open Question

Replacing blend door in 2001 Chrysler Town & Country

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

emissionwiz
  • 75077 Answers

SOURCE: i have a problem with power sliding doors on 2001 Chrysler Town and Country limited

do you mean they are sticking?

Posted on Oct 20, 2008

blueextc3221
  • 15935 Answers

SOURCE: Where is the factory amp

The amp relay is in the Relay/Fuse box located under the hood. The amp relay is the one labeled NBS which stands for Name Brand Speakers. If you are trying to install an after market radio in a 2001 Chrysler Town and Country, you may notice that no sound comes from the speakers. This is because the single wire that is connected to the factory radio sends a signal to the Bus which tells the relay to turn on - powering the factory amp.

I bypass this by running a wire from the red Acc power wire on the radio to the relay. Connect the wire to pin number 87 on the relay. When standing in front of and facing the van, pin number 87 is the pin, on the NBS relay, which is closest to you and furtherst right.

Are you looking to replace the amplifier? or bypass the speaker wires??

Usually factory amplifiers in vans are under the P/S Front seat. However they can be up under the dash as well (P/S).

If you're looking for it because it is not turning on - check the relay (as above).

Thanks for using FixYa - a FixYa rating is appreciated!

Posted on Jan 31, 2009

keemo68
  • 1263 Answers

SOURCE: radiator fan relay,2001 chrysler town country

the relay is located in the power distribution box under the hood the relay will be a square black or gray cube just pull out and make sure you rerplace it with the same type relay. refer to your owners manual for any questions regarding the fuses and relays

Posted on May 08, 2009

alicantecoli
  • 22095 Answers

SOURCE: Chrysler trouble code U110C on 2005 chrysler town

encrypted software ,dealer only----yes i know you are showing a reading but it doesnt mean anything or if it does it shows a different code .so your snap on or mac tools scanner is a waste of time and money.Nearly all new motors from 2005 are using encrypted software to stop general mechanics like me from working

Posted on Sep 12, 2009

  • 1619 Answers

SOURCE: Chrysler Town & Country Minivan Rear Drum Brakes

remove tire remove center pin and nut if needed and any othe bolts then pull straight off. Make sure parking brake is released or drum will not come off.

Posted on Apr 16, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2001 Chrysler Town and Country heater is working fine on the driver side, but blows out cold air on the passenger side. Help


I have seen this quite a bit. This issue is caused by the blend door for the climate control system. Those doors were not that well constructed and end up breaking to the point where the climate system can no longer operate the door. This can be a very difficult to repair because it requires dash removal to get access to the appropriate door. This condition can easily be verified by a dealer test with scan tool. If you would like to replace yourself I would recommend contacting dealer for a copy of the removal and repalcement procedure for the passengers blend door. I hope this information was helpful.

Feb 22, 2011 | 2001 Chrysler Town & Country

2 Answers

2001 chrysler town country limited. Check engine light is on with a code P740. transmission shifts very well .What is up with this code and what needs to be replaced? also the ac is cold on the passenger...


P0740 Torque Converter Clutch Circuit Malfunction, it could be a sensor starting to go bad, have the code cleared and see if it happens again, have you ever had your transmission fluid replaced, (do not have it flushed) might want to do that as a Preventive Maintenance item.

A/C problem could be the A/C controls on the dash are not working properly, the doors inside the dash are not closing completely, letting warm blended air in on the driver's side.

May 25, 2010 | 2001 Chrysler Town & Country

1 Answer

The back door latch does not open the door or unlock it 2001 Chr


Replace the latch mechanism. There is a short in the latch. It happened on both of my vans. The latch costs about 90-100 dollars, if memory serves... 3 bolts, a wire connection, and the manual latch bar. Very easy, shouldn't take more than 5 minutes to switch out.

Jan 24, 2010 | 2001 Chrysler Town & Country

1 Answer

I lose power to the door locks on my 2001 chrysler


more than likely this is caused by a bad ground wire located within the door locks wiring harness

Jan 16, 2010 | 2001 Chrysler Town & Country

1 Answer

2001 Chrysler town and Country tire size


the sticker on the drivers door or door jamb will have that info. plus it is on the side of the tire, starting with P___-__-__

Sep 23, 2009 | 2001 Chrysler Town & Country

1 Answer

Describe your 2001 Chrysler Town &


Shouldn't set off air bag if you are taking off door panel. You could always disconnect negative battery cable to be extra careful. I have replaced both passenger and drivers windows with battery connected. Take your time in removing door panel so avoid breaking plastic retaining clips.

One nasty part of this job is removing bolts that hold window motor to the door. They have a rubberized nut on the backside. Sometimes you can hold them with vise grips. I've found if I just pull the motor really hard the bolt and nut slides out of rubber guide.

It is also a little tricky to remove the unit and reinstall it in the door. Just be patient and take your time.

One tip is to leave the door panel off after you install the new door motor/regulator unit. Simply plug in the window switch and make sure all is functioning correctly and then install door panel.


I buy the replacement window units online and save big bucks over the dealer.

Jul 18, 2009 | 2001 Chrysler Town & Country

2 Answers

Describe your 2001 Chrysler Town &


like a gas pump? it means you need gas....

Jul 08, 2009 | 2001 Chrysler Town & Country

1 Answer

Blowing cold air when heat is on


air blend door jammed, or you have lost vacumn to the diaphram that opens and closed that door.

Nov 22, 2008 | 2001 Chrysler Town & Country

Not finding what you are looking for?
2001 Chrysler Town & Country Logo

Related Topics:

79 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...