Question about 1989 Subaru Gl Wagon

Open Question

Remove rear brake drum 1989 subaru - 1989 Subaru Gl Wagon

Posted by Anonymous on

Ad

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
techbuster
  • 5081 Answers

SOURCE: how do you remove rear brake drums on 1999 subaru impreza

u need to remove small rubber dust cover from back side of brake backing plate. then with a sturdy but small screwdriver,thru this hole, u need to locate auto adjuster plate inside drum, u push small driver against this so it is pushed off the adjuster cam, then with flat screwdriver, or adjusting tool, at same time as u are holding adjuster plate, back off adjuster wheel as far as it will go this is akward to do, but brakes need to be backed off to enable drums to be removed drums wear and develop a lip on edge u should then be able to slide drum off. if still hard tap with a hammer while pulling drum

Posted on Jul 03, 2009

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you replace rear brakes on a 1989 ford bronco II


The easiest and simpleist way is to jack the truck up, block it and remove both wheels and drums. Do one side at a time and use the other side as a reference. Both sides have to look exactly the same when you are done.

Sep 03, 2014 | 1989 Ford Bronco II

1 Answer

What tool do I need to remove the keeper screw from rear brake drum 2005 subaru forester


Joan , does it look like a Phillips screw driver tip ,if so the tool is a hand held impact driver that you strike with a hammer 15.-20.00 some are just tight from rust, this tool comes with bits that will fit , make sure that the one you need is included with your purchase,you can get one at most part stores ,or like auto zone will rent you one for a very small fee.

Aug 28, 2014 | 2005 Suzuki Forenza

1 Answer

Stuck rear drum brake.


Try disconnecting the brake line to the rear pass side wheel cylinder the brake lines might be clogged or the cylinders are going bad

Jan 26, 2014 | 1995 Subaru Legacy

3 Answers

My rear drub wont go back on after replacing pads


Loosen the rear emergency brake cable. This will alow you more travel to compress the pads onto the rotor.

Apr 17, 2010 | 1987 Subaru Gl 4WD

1 Answer

Can u adjust brakes on this car?


Rear brake's you can, front no self adjusting, rear,s some have a slot in back of wheel with screw driver you can adjust and some you have to remove rear brake drum to adjust, but yes you can adjust rear brake only.

Mar 25, 2010 | 1983 Subaru Gl Wagon

1 Answer

1989 chevy 3500 4x4 454 rear brake drum removal. Does the axle bolts need to be removed


Can you tell me which type of axle you have?

Full Floating Axles To remove the drums from full floating rear axles, use the Axle Shaft Removal & Installation procedure in Section 7. Full floating rear axles can readily be identified by the bearing housing protruding through the center of the wheel.


Semi-Floating Axles
  1. Raise and support the rear end on jack stands.
  2. Remove the wheel.
  3. Pull the drum from the brake assembly. If the brake drums have been scored from worn linings, the brake adjuster must be backed off so that the brake shoes will retract from the drum. The adjuster can be backed off by inserting a brake adjusting tool through the access hole provided. In some cases the access hole is provided in the brake drum. A metal cover plate is over the hole. This may be removed by using a hammer and chisel.
314894f.gif
You may have to back off the automatic adjuster before you can pull the drum from the brake assembly

To install, reverse the removal procedure.

Dec 01, 2009 | 1989 Chevrolet C/K 3500

1 Answer

How do i change the back brakes


lift the rear of the carthen remove rear tires and take the drums off to expose the brake shoes. the shoes should be at a minimum of 1.5 times thicker than the backing plate that the brake material is bonded to. if it is rear disk the thickness still holds the same.good luck.

Jul 28, 2009 | 1989 Nissan Maxima

1 Answer

Rear wheel locks up when appling brakes


Hi, check wheel for bad/leaking brake wheel cylinder. An easy way to do this without removing wheel is to look at the outside of the drum from the backside for any brake fluid. If the backside of the drum looks wet, replace wheel cylinder. If it looks dry, remove tire and drum to inspect wheel cylinder for any brake fluid. If rubber boots on end of wheel cylinder appears to be dry, adjust rear brake turning adjusting screw (long bar on bottom with a "star" in center), replace drum, if you cannot put the drum back on easily, back up the screw you turned until the drum goes on easily but without too much slack, start car, apply brake, check drum to see if it can come off easily, if not, repeat until drum is snug, but not tight.
New rear wheel cylinder part avg.: $25-$35 ea.

Jul 08, 2009 | 1989 Lincoln Town Car

1 Answer

How do you remove rear brake drums on 1999 subaru impreza


u need to remove small rubber dust cover from back side of brake backing plate. then with a sturdy but small screwdriver,thru this hole, u need to locate auto adjuster plate inside drum, u push small driver against this so it is pushed off the adjuster cam, then with flat screwdriver, or adjusting tool, at same time as u are holding adjuster plate, back off adjuster wheel as far as it will go this is akward to do, but brakes need to be backed off to enable drums to be removed drums wear and develop a lip on edge u should then be able to slide drum off. if still hard tap with a hammer while pulling drum

Jul 03, 2009 | 1999 Subaru Impreza

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

42 people viewed this question

Ask a Question

Usually answered in minutes!

Top Subaru Experts

yadayada
yadayada

Level 3 Expert

76051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8265 Answers

Are you a Subaru Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...