Question about Dodge Pickup

Open Question

2004 dodge ram 1500 5.7 hemi po172 po113 codes no fuel pressure

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

dustyboner
  • 331 Answers

SOURCE: Diagnostic code P2299 for 2004 Dodge Ram 1500 5.7 hemi?

P2299-BRAKE PEDAL POSITION / ACCELERATOR PEDAL POSITION INCOMPATIBLE

Set Condition:
The PCM recognizes a brake application following the APPS showing a fixed pedal opening. Temporary or permanent. Internally the PCM will reduce throttle opening below driver demand. One trip fault and the code will be set within 5 seconds. ETC light will illuminate, the light will only stay illuminated while DTC is active.




Possible Causes

DRIVER PRESSING ACCELERATOR PEDAL, THEN PRESSING BRAKE PEDAL, AND CONTINUES TO HOLD THEM DOWN SIMULTANEOUSLY

STOP LAMP SWITCH

APP SENSOR


The most likely cause of this DTC is Brake Torquing the engine by pressing the Accelerator pedal and the pressing the Brake Pedal.

Posted on Jul 17, 2008

  • 66 Answers

SOURCE: Need diagram to install serpentine belt on 2004

There should be a diagram under the hood on the fan shroud or radiator support. If not, let me know and I see if I can find one. For the most part, if the pulleys it rides on are grooved, the belt ribs ride on it, it the pulley is smooth, the back side rides on it. From a picture of the alternator I have, from the passenger side coming up, over the alternator, then down and under the belt tensioner (smooth pulley), then up and over A/C compressor, then down and around P/S pump, up and around water pump, down around crankshaft pulley.

Posted on Jun 03, 2009

  • 295 Answers

SOURCE: When is it time to tune-up a 2004 Dodge Ram 1500

30,000 mile plugs but it doesn't meen they need replacement I work for chrysler I would wait till about 50 or 60 thousand remeber just because there is not a problem doesn't meen they should not be replace at the recommened intervals. they are considered a wearable item. when you do the plug do the wires. words of advise when doing the ignition wires do ONE WIRE AT A TIME it will save u from a big headache. Good luck.

Posted on Jul 01, 2009

  • 1 Answer

SOURCE: 2007 dodge Ram 1500 hemi fuel cap sensor comes on

I have the same problem. It started with engine code 0440 (evap system malfunction). I changed the gas cap and now getting the "loose cap" light plus the 0456 (evap leak very small) and 0457 (gas cap loose/off)

Anyone know where the sensor is located?

Posted on Jul 05, 2009

  • 83 Answers

SOURCE: how do i change the power steering pressure switch

From the Factory Service Manual, you can get one relatively cheap from www.promanuals.net. Here is a link to your 2004 Dodge Ram Service Manual.

The power steering pressure switch is installed in
the power steering high-pressure hose (Fig. 9).

(1) Disconnect electrical connector from power
steering pressure switch.
(2) Place a small container or shop towel beneath
switch to collect any excess fluid.
(3) Remove switch. Use back-up wrench on power
steering line to prevent line bending.

1425db0.jpg

Posted on Oct 05, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

12 dodge 1500 hemi has two burnt wires coming from underhood fuse box into harness. one wire goes to the wipers. the other is unknown. no fire or fuel. it will turn over. what do I check next?


2004 DODGE RAM 1500 - Electrical System Problem - Auto ...

www.arfc.org/complaints/2004/dodge/ram_1500/.../problem.aspx
2004 Dodge Ram 1500 problem with Electrical System. ... MY TRUCK ALSO HAS THE STALLING PROBLEM WHEN COMING TO A STOP AND ACCELERATING. ... FLAW OF THE ENGINE FUSE BOX AS THE CONNECTORS ARE EXPOSED .... HOOD WAS OPEN NOTICED BURNED WIRE ON ALTERNATOR HARNESS.
images for 12 dodge 1500 hemi wiring

Jan 07, 2016 | Dodge Cars & Trucks

3 Answers

Looking for the fuel regulator on a 2004 dodge ram 1500 5.7 Hemi. Everywhere says it's on top of the fuel pump, but it is not. Any ideas?


fuel regulators are normally found on the fuel manifold and have a line going back to the tank of the inlet side of the pump

Jan 16, 2015 | 2004 Dodge Ram

1 Answer

2004 dodge ram hemi losing fuel pressure


i need to change my oxigenpipe for a dodge 04 1500 but i dont now where to find it

Jan 30, 2012 | 2004 Dodge Ram 1500

1 Answer

I have a few error codes for my 2004 dodge ram hemi 1500 4x4. they are po172, po300, and po304.


The p0172 is due to an O2 sensor in the exhaust seeing too much oxygen, the po300 is a missfire present and p0304 is cylinder #4 missfire, check plug and wire to #4 and repair, this should also take care of the p0172, if a cylinder is missing it is just pump air into the exhaust thus causing the code p0172.

Jan 13, 2012 | Cars & Trucks

1 Answer

Is the number 7 fuel injector on the left or right side on a 5.7 hemi?


On 2004 Dodge RAM 1500 5.7 liter Hemi V-8 VIN "D" check this diagram...

zjlimited_795.gif

Hope this helps; remember to rating this answer and leav us a testimonial comment. Thank you for using FixYa.

Oct 13, 2011 | 2005 Dodge Ram 1500

1 Answer

What is a p0307 code on a dodge truck 1500 5.7 hemi 2004 the truck is missing on one cyl.


P0301-P0308....2T catalyst........2004-05 Ram...Cylinder 1-8 Misfire Detected Conditions: Any time engine is running and the adaptive numerator has been successfully updated. When more than 1.5% (300M, Magnum), 2% (Durango, Ram), 2.5% (Durango LEV, Ram LEV), misfire rate is measured during 2 trips, or with 10-30% misfire during 1 trip. 3 good trips required to turn off MIL. Possible Causes: ASD relay output 2 circuit fault Injector control 1 circuit fault Coil control 1 circuit fault Ignition wiring, spark plug, or ignition coil fault Fuel pump inlet strainer plugged Restricted fuel supply line Fuel pump module fault Fuel pressure leakdown fault Fuel injector is damaged or has failed Engine mechanical problems exist PCM has failed. Hope this helps you. Thank You for using fixya.If you like this solution please rate it....Thank You, iluv2fish....Ray

Jun 24, 2010 | 2004 Dodge Ram 1500

1 Answer

Looking for firing and coil order 2004 hemi 5.7


For ALL 2004 Dodge RAM (1500, 2500, and 3500) (2WD and 4WD) 5.7L V8 Hemi:

.........Firing Order:
Coil...1-8-4-3-6-5-7-2
Plug..6-5-7-2-1-8-4-3

This should have been located at the top of the your Intake Manifold.

Let me know if this helped...

Apr 15, 2010 | 1998 Dodge Ram 1500 4WD

1 Answer

2003 dodge 1500 5.7 stalls when cold coming to a stop


I have a 2004 Dodge Ram 1500 with 5.7 Hemi and it was running dead somethimes. I had a fuel system service performed on it and it cured it.

Jan 23, 2009 | 2004 Dodge Ram 1500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

140 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7688 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...