Question about 1990 Honda Accord

3 Answers

Why does me clut ch pedal stay down on floor

1990 honda accord The pedal used to be slow to come back up but now has permanently stayed on the floor

Posted by on

3 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 103 Answers

Your accord has a hydraulic clutch system. The reason you pedal isn't coming back up is it is low on fluid. You will need to add DOT3 Brake fluid to the brake reservoir, or the clutch reservoir if there is one. sometimes manufacturers use the brake reservoir to do both. The clutch resirvoir is right next to the brake reservoir and is smaller. you may need to bleed the system after topping off. Thanks, and don't forget to vote

Posted on Jan 23, 2009

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Look dude it sounds like you have air in your line all you have to do is bleed it and thats simple the vaulve is at the front of the motor

Posted on Jan 27, 2009

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 31 Answers

There is a separate reservoir for the clutch. If it is really low, you should probably take the extra step to check for leaks at the clutch master cylinder (you'll see a trail of fluid down the floor from where the push rod comes through the firewall) or at the slave cylinder on the front of the transmission housing. If these have never been replaced, it is probably time. Bleeding the system can take a lot of time; it may take 20 - 30 time of actuating the pedal and bleeding at the slave cylinder.

Posted on Jan 26, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why does the clutch petal stay stuck to the floor in my 94 honda accord?


They will usually have a bad slave cylinder or clutch master cylinder. See if you see any leaks at those parts. The clutch master cylinder may leak on the back side so you may have to look underneath the dash to see it. Fill with fluid and pump pedal, have someone look while pushing on pedal. It will be wet from the leaking fluid.

May 28, 2015 | 1994 Honda Accord

1 Answer

Car wont stay started unless foot on gas pedal


This could be a lot of things. IT could be the injectors or the fuel pump pressure, it could be the air intake, vacuum leak, etc.

Dec 02, 2013 | 1990 Honda Accord

1 Answer

What can cause slow acceleration on a 90 honda accord ex


A whole list of things!!!!!! Start by checking the Vane Airflow Meter/Mass Airflow Sensor, then the Throttle Position Sensor. You need to find someone who is familiar with the Honda Diagnostic process to access your ECU and retrieve the codes for a more definitive diagnosis. It will save you a lot of headache, and money in the long run.

Jan 25, 2012 | 1990 Honda Accord

1 Answer

I have a 1992 Honda Accord, I left my car at the airport parking for 5 days in the cold weather (between -10 to 12 degrees), and normally my car is parked in the garage at night. When I returned, the...


it sounds like the clutch master is bad it will look something like the brake master cylinder on the fire wall.you can try bleeding it there before replacing the clutch master loosen the lineup have have someone pump the pedal a couple times if you get agood shot of fluid have the person hold the pedal to the floor and tighten the line back up then bleed the system at the bleeder.

Jan 17, 2011 | 1992 Honda Accord

1 Answer

1990 honda accord wont stay running


Possibly a bad ground just below the distributor, but, sounds more like a bad fuel pump/filter.

Oct 06, 2009 | 1990 Honda Accord

1 Answer

1991 Honda Accord Brake Lights Stay on


Hi,
Usually there is a spring loaded switch that is activated by the brake pedal arm (under the dash). It registers on the pedal arm and when the pedal is depressed the switch is activated, causing your brake lights to illuminate.
The switch may have been bumped out of position. Hopefully this is a quick and easy fix for you...
Good luck!

Sep 22, 2009 | 1992 Honda Accord

1 Answer

1990 Honda Accord High Idle and No Brakes in Warm Weather


sounds like vacuum loss related to brake booster. can you hear a vacuum leak ?



shack

Apr 18, 2009 | 1990 Honda Accord

Not finding what you are looking for?
1990 Honda Accord Logo

533 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...