Question about Isuzu Rodeo

Open Question

Where is ecu located in isuzu rodeo 3.0tdi 2005

Posted by Anonymous on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 13 Answers

SOURCE: 1997 Isuzu Rodeo

on the side of the block on the passenger side....u can see it through the wheel well

Posted on Feb 15, 2009

  • 319 Answers

SOURCE: where is air cabin filter located on 99 isuzu rodeo?

its usually behind the glove compartment in the blower box. you will have to pull the GB door down all the way to access it

Posted on Mar 19, 2009

  • 1 Answer

SOURCE: the location of the ecm fuse on 98 isuzu rodeo

ECM fuese are located in the fusebox in the engine compartment-left sidefacing the vehicle.

Posted on May 01, 2009

  • 450 Answers

SOURCE: 1990 holden rodeo /isuzu pick-up temp sender

from memory it is in inlet manifold some were in front middle section bottom, (underneath) 4ZE1?
single wire possibly yellow

Posted on Jun 25, 2009

  • 450 Answers

SOURCE: What does power drive do?

extend shift points to higher RPM, hold gear for deceleration (engine braking)

Posted on Jul 01, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Isuzu rodeo manual

Really the best place. Works instantly,, like within minutes, your work to get manual will be done. And very easry too Complete manuals. You should try from here only!!!!!!!!!!!!!!! 2003 2004 2005 2006 2007 2008 Holden Rodeo Holden Colorado Isuzu Max TF...

Dec 08, 2017 | Isuzu Cars & Trucks

1 Answer

I changed the ecu in my 2000 isuzu rodeo v6 2wdr do I have to flash the knew ecu

yes you do ! to clear all of the perameters. you can call the dealership, for exact details on how to flash ecm. good-day !

Apr 06, 2012 | 2000 Isuzu Rodeo

2 Answers

I have a 2000 Isuzu Rodeo 3.2L v6, If I swap the ECU does the vehicle have to be taken to the dealership to have the new ECU reflashed?

HI and welcome to FixYa!

You don't have to take it in. Just remove the positive battery connector of the vehicle and install the new ECU. It will relearn the car itself and please take a few runs.

Hope this helps and thank you for using FixYa! Have a good one!

Feb 23, 2011 | 2000 Isuzu Rodeo

1 Answer

Where is the ecu located in the 1999 isuzu rodeo?

If it is a 4 cylinder, it's underneathe the radio. If it's a V6, it's in the engine compartment behind the air filter housing.

Aug 18, 2010 | 1999 Isuzu Rodeo

1 Answer

Can i take a 2000 rodeo motor and put it into a 2001 rodeo without changing the ecu

yes motors are same for both years if V6 they both are 6VE1 engines
just leave engine ECU in original vehicles

Aug 13, 2009 | 2001 Isuzu Rodeo

1 Answer

95 Isuzu Rodeo. It will drive fine for a little

Check on the engine ground stud under the air intake tube.

This stud is well hidden under a lot of black electrical tape.

There are few wires ground to this stud.

THIS IS the ground for the ECU.

Take off the nut and check/clean all rings.

This is the grounding point for the ECU.

Next time you has the same problem,check the ECU and see is the LED is lite up.

NO power to ECU = no lite LED

ECU is near your left foot when you site on the drive seat.

Jul 10, 2009 | 1995 Isuzu Rodeo

1 Answer

I have a 1998 Isuzu Rodeo, it is reading the PO401 and PO 336. I have changed the EGR Value and the crankshaft sensor (3) times, and when it is cold (below 40) the rodeo won't start, and I put an electic...

I would be looking for a ECU at scrap yards; it sounds a lot like the error codes themselves are in 'error' since you have done your duty replacing those items. The fact that warming the cab seems to help, kind of points to something in the cab and the ECU could be under your dashboard.

If you locate one, ask them if they will mark it somehow and refund your money if it makes no difference. Without having specialized equipment, it will be tough to diagnose the computer.

Apr 28, 2009 | 1998 Isuzu Rodeo

1 Answer

The location of the ecm fuse on 98 isuzu rodeo

ECM fuese are located in the fusebox in the engine compartment-left sidefacing the vehicle.

Feb 19, 2009 | 1999 Isuzu Rodeo

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

470 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts


Level 3 Expert

79847 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14411 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides