Question about 2004 Volkswagen Golf

Open Question

Polo 1.4 tdi wipers stop on windscreen - 2004 Volkswagen Golf

Posted by Anonymous on

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

emissionwiz
  • 75814 Answers

SOURCE: why my windscreen wipers on my polo stopping up on the windscreen

Your wiper has what is called a parking circuit, this sets the wipers to the bottom of the windshield when the power or ground is turned off, in order to fix this issue u will need to replace that part, it may be part of the wiper motor, not for sure on VW's.

Posted on Feb 21, 2009

Obertelli
  • 3006 Answers

SOURCE: Hi, the rear windscreen wiper on my 2003 VW polo

The most common reason for this is a blown fuse, so using your vehicle owners book locate and check the fuse first. (if you don't have one then buy a Haynes manual for your car, the cost will pay for itself with the first repair you do). Modern automotive fuses not only have the current rating clearly marked numerically, but are colour coded and the fuses are designed so that you can easily see if they're blown when you pull them out to check. Most modern vehicle fuseboxes have a few spare fuses included and often have a small plastic tool to assist with pulling them out.

Normally a blown fuse needs further investigation as they should only fail if there's been a problem which would otherwise cause fire or other damage, but if wipers are operated inappropriately then it can cause enough load to blow the fuse. Sometimes the wiper spindles can become worn allowing water to get in and corrode the internal parts; this will cause the spindles to bind or even seize up and also cause the wiper motor to draw sufficient current to blow the fuse.

Inappropriate use includes operating the wipers when the screen is dry, trying to use them to clear snow, ice or debris, operating them if the blades or arms are damaged.

If your problem turns out to be more than a straightforward blown fuse then please add a comment to my answer and I'll try to give you more specific advice. If my answer has solved your problem then please return the favour by rating my answer.

Posted on Sep 24, 2009

  • 5 Answers

SOURCE: 1999 1.4cl auto VW Polo, windscreen wipers stopped working

Look into changing the ignition switch...sounds odd I know, but we had similar issue and that was the problem.
Good luck!

Posted on Feb 25, 2010

sambo59
  • 74 Answers

SOURCE: When i turn the widow

Change the viper blade mechanism.I think the motor is still OK.

Posted on Jun 21, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Intermittent problems with our windscreen wipers - what can it be?


You could have corrosion in your fuse box. Alternatively get a good battery from someone and drive with it in your car for a day or two. It could be that the battery can't handle multiple electronic device at the same time. Go have a look at the VW Polo site perhaps they may have encountered your problem http://volkswagen-polo-highline.blogspot.com

Feb 11, 2013 | Volkswagen Beetle Cars & Trucks

1 Answer

How do I replace the windscreen wiper motor on an audi a4 2.5 tdi


How to change a wiper motor & repair wiper mechanism on 2004 Audi A4 2.5 TDI

First time you must diagnose why windscreen wipers going slow and/or stopping.
In order to find out the cause of wipers stopping you can try follows:

1. Carefully extract the wiper arms from their axles (two pieces). In some cases you need to use an extracting tool. Heed of the windscreen !!!
2. Disassemble the plastic covers from the bottom of the windscreen.
3. With the bonnet up you can start the engine, (transmission in "N" or "P" position and parking brake on). Now you must switch on the control lever of the wipers, and go to the engine compartment. If the wiper motor runs let the wiper motor running for a few minutes and switch off. Go to the step 4. If the wiper motor do not runs you must check first the electrical feeding of the motor. It is necessary to unscrew three bolts of the mechanism and disconnect the electrical coupling (difficult assurance). If the electrical feeding is OK you must replace the motor - steps 5, 6, 7. If not you must check electrical connections, the control switch of wipers and electric cables.
4. Now you must check the two bearings of wiper mechanism with your hand. In the most cases the left bearing is out of order (is very hot). This is the most encounter fault of the wipers running at Audi.
5. For have enough space to manipulation the wiper motor together with their mechanism you must extract the plastic cover of the engine computer box, and extract also the box screws. Then you can move slowly the engine computer box, just for a few milimeters.
6. You must disconnect the electrical coupling of the motor (difficult assurance), unscrew three bolts of the mechanism and extract together with the motor. You must move them slowly between windscreen and engine computer box until the wiper motor go out together with the mechanism. This is the most difficult operation!
7. Now you can repair the bearings, replace entire wiper mechanism or replace the wiper motor. It is not very simply, but it works.
Heed of the windscreen !!!
Refit all in reverse order.

Mar 30, 2011 | 2004 Audi A4

1 Answer

My 2004 audi a4 windscreen wipers move across the windscreen very slowly then stop.they will then start up again and move slowly.sometimes they dont start first time and when they do their is only 1 speed-...


First you must diagnose why windscreen wipers going slow and/or stopping.
In order to find out the cause of wipers stopping you can try follows: 1. Carefully extract the wiper arms from their axles (two pieces). In some cases you need to use an extracting tool. Heed of the windscreen !!! 2. Disassemble the plastic covers from the bottom of the windscreen. 3. With the bonnet up you can start the engine, (transmission in "N" or "P" position and parking brake on). Now you must switch on the control lever of the wipers, and go to the engine compartment. If the wiper motor runs let the wiper motor running for a few minutes and switch off. Go to the step 4. If the wiper motor do not runs you must check first the electrical feeding of the motor. It is necessary to unscrew three bolts of the mechanism and disconnect the electrical coupling (difficult assurance). If the electrical feeding is OK you must replace the motor - steps 5, 6, 7. If not you must check electrical connections, the control switch of wipers and electric cables. 4. Now you must check the two bearings of wiper mechanism with your hand. In the most cases the left bearing is out of order (is very hot). This is the most encounter fault of the wipers running at Audi. 5. For have enough space to manipulation the wiper motor together with their mechanism you must extract the plastic cover of the engine computer box, and extract also the box screws. Then you can move slowly the engine computer box, just for a few milimeters. 6. You must disconnect the electrical coupling of the motor (difficult assurance), unscrew three bolts of the mechanism and extract together with the motor. You must move them slowly between windscreen and engine computer box until the wiper motor go out together with the mechanism. This is the most difficult operation! 7. Now you can repair the bearings, replace entire wiper mechanism or replace the wiper motor. It is not very simply, but it works.
Heed of the windscreen !!!
Refit all in reverse order.

Sep 06, 2010 | 2002 Audi A4

2 Answers

Windscreen wipers only go half way


wipers stop halfway up windscreen

May 24, 2010 | 1999 Volkswagen Passat

1 Answer

1999 1.4cl auto VW Polo, windscreen wipers stopped working


Look into changing the ignition switch...sounds odd I know, but we had similar issue and that was the problem.
Good luck!

Feb 19, 2010 | 1999 Volkswagen Passat

1 Answer

Audi avant estate 1.9 tdi 1996 windscreen wiper control, only fast setting working


First you must diagnose this problem. In order to find out the cause of wipers stopping you can try follows: 1. Carefully extract the wiper arms from their axles (two pieces). In some cases you need to use an extracting tool. Heed of the windscreen !!! 2. Disassemble the plastic covers from the bottom of the windscreen. 3. With the bonnet up you can start the engine, (transmission in "N" or "P" position and parking brake on). Now you must switch on the control lever of the wipers, and go to the engine compartment. If the wiper motor runs let the wiper motor running for a few minutes and switch off. Go to the step 4. If the wiper motor do not runs you must check first the electrical feeding of the motor. It is necessary to unscrew three bolts of the mechanism and disconnect the electrical coupling (difficult assurance). If the electrical feeding is OK you must replace the motor - steps 5, 6, 7. If not you must check electrical connections, the control switch of wipers and electric cables. 4. Now you must check the two bearings of wiper mechanism with your hand. In the most cases the left bearing is out of order (is very hot). This is the most encounter fault of the wipers running at Audi. 5. For have enough space to manipulation the wiper motor together with their mechanism you must extract the plastic cover of the engine computer box, and extract also the box screws. Then you can move slowly the engine computer box, just for a few milimeters. 6. You must disconnect the electrical coupling of the motor (difficult assurance), unscrew three bolts of the mechanism and extract together with the motor. You must move them slowly between windscreen and engine computer box until the wiper motor go out together with the mechanism. This is the most difficult operation! 7. Now you can repair the bearings, replace entire wiper mechanism or replace the wiper motor. It is not very simply, but it works. Heed of the windscreen !!! Refit in reverse order. Please Rate my Response! Thanks!

Sep 24, 2009 | 2004 Audi A4

1 Answer

Hi, the rear windscreen wiper on my 2003 VW POLO has just stopped working. Can you help? Cheers Emma. (For some reason it wouldn't let me select polo from the pick list for VW cars.)


The most common reason for this is a blown fuse, so using your vehicle owners book locate and check the fuse first. (if you don't have one then buy a Haynes manual for your car, the cost will pay for itself with the first repair you do). Modern automotive fuses not only have the current rating clearly marked numerically, but are colour coded and the fuses are designed so that you can easily see if they're blown when you pull them out to check. Most modern vehicle fuseboxes have a few spare fuses included and often have a small plastic tool to assist with pulling them out.

Normally a blown fuse needs further investigation as they should only fail if there's been a problem which would otherwise cause fire or other damage, but if wipers are operated inappropriately then it can cause enough load to blow the fuse. Sometimes the wiper spindles can become worn allowing water to get in and corrode the internal parts; this will cause the spindles to bind or even seize up and also cause the wiper motor to draw sufficient current to blow the fuse.

Inappropriate use includes operating the wipers when the screen is dry, trying to use them to clear snow, ice or debris, operating them if the blades or arms are damaged.

If your problem turns out to be more than a straightforward blown fuse then please add a comment to my answer and I'll try to give you more specific advice. If my answer has solved your problem then please return the favour by rating my answer.

Sep 24, 2009 | 2003 Volkswagen Golf

1 Answer

Why my windscreen wipers on my polo stopping up on the windscreen


Your wiper has what is called a parking circuit, this sets the wipers to the bottom of the windshield when the power or ground is turned off, in order to fix this issue u will need to replace that part, it may be part of the wiper motor, not for sure on VW's.

Feb 21, 2009 | 2004 Volkswagen Passat

Not finding what you are looking for?
2004 Volkswagen Golf Logo

Related Topics:

21 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

yadayada
yadayada

Level 3 Expert

75807 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...