Question about 1991 Dodge Spirit
It could be your radio memmory which stays on like all cars but most likely its a bad battery or worst case its your alternator take it to a auto zone or any shop that checks your car for free : )
Posted on Jan 14, 2013
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: replacing front fender
My son went around a curve one night and hit a tree stump that was in the middle of the road. It put the front bumper under the truck, busted the radiator, the framing brace that supported the radiator and the A/C condenser. There was even wood in the frame from the impact. He also needed to replace a fender from a previous accident. After getting everything installed on the engine, they had a problem putting the fenders back on.
The passenger's side fender fit perfectly except where the hood was hitting in one spot. The fender was about 2 to 3 inches too high and the guys were threatening to take a hammer and beat it down. But after getting a stronger light and searching the frame of the truck from all angles, they found out there was still one bolt that needed to be removed. Once it was removed, the fender went on smoothly. They didn't get to use the hammer like they were threatening!
Posted on Nov 08, 2008
You have a draw and a draw pulling more than a couple hundred milliamps.This will drain the battery in an objectionably short amount of time.. All the things you mentioned and more can cause this draw. The best diagnostic step towards isolating your draw is with meter that reads Volts DC or better yet a test light.(I think) ..disconnect B+ positive battery cable. Install meter or lamp in series with disconnected cable and battery post. You do have some smal draws like computer memories,clocks etc which will show a low amount of voltage hence a very dim test light. If you are drawing heavy ,obviously the meter will show a full blown 12 volts and the lamp bulb will be very bright. Remove fuses,unplug relays,dis-connect devices while watching the voltage or lamp.You should begin to isolate offending item once the circuit has been detected, Generally pulling all fuses individually will tell you at least which circuit is pulling the amps.
Posted on Aug 22, 2009
Tips for a great answer:
May 11, 2012 | 1991 Ford Mustang
Feb 24, 2012 | 1995 Dodge Spirit
Oct 10, 2011 | 1991 Dodge Spirit
Mar 05, 2011 | 1995 Dodge Spirit
Jan 03, 2011 | 1991 Ford Explorer
Dec 15, 2010 | 1991 Ford Explorer
Dec 11, 2010 | 1991 Ford F150
Aug 13, 2010 | 1993 Dodge Spirit
Jul 13, 2008 | 1991 Toyota Supra
33 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: