Question about 2007 Ford Explorer Sport Trac

1 Answer

Reset srs light after replacing seatbelt

2007 sportrack limited 4.6l replaced passenger side seat belt when I took out seat belt SRS light and when I replaced with new the light still remained light I get code B1085, B2290, B1676 I know they refer to the seat belt limiter, I even had the battery changed due to one dead cell and had the battery out for a half hour after replacing seal belt any suggestion

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 937 Answers

To reset the SRS light on an Acura Integra, pull down the SRS service connector. Unplug this connector so you have access to jump the harness. Start with the ignition OFF. Jump the SRS plug. Turn the ignition ON. The SRS light will come on then off.------------------------------------------------------------------------------
autel maxidas ds708

Posted on Jan 14, 2013

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 193 Answers

SOURCE: Charging Light On After Replacing Alternator/Battery1999Windstar

Hi, I can't tell you exactly what is wrong because there is too much involved at this point, what with 2 shops working with it, but I can give you some advise on what else to check. On the alternators and the wiring that supports them a small volt charge is taken off one of the slip rings, where the brushes ride, for the purpose of turning out the light. As I remember, this is a yellow wire that runs back to the dash.

To the alternator, it would be one of the wires that plug into the side of the alternator case.
jetski

Posted on Nov 27, 2008

  • 564 Answers

SOURCE: 1996 Ford Explorer - Eddie Bauer 4WD - Replace Power Seat Switch

the switch pops in or out just pull on it unless you see screws it should just pop right out theres no need to worry about the srs.

Posted on Nov 14, 2009

  • 2 Answers

SOURCE: How do you fix a stuck seatbelt in front seat

this is a simple repair many dont know. remove or pull off plastic pillar post cover, seatbelt probably twisted inside. twist it back around so it runs flat and lube slightly with a light lube spray on metal gearing. i had the same problem w mine pk

Posted on Jan 20, 2010

  • 4 Answers

SOURCE: How do i take apart my seatbelt assembly?

since it's a safety item it's highly recommend against any type of service.. if you can get the assembly out from behind the trim panel or under the back seat if it's the rear...remove the side that has the belt wound up and the gear showing. More then likely the pin and weight have gotten caught in place and the belt tightened up without any slack to let the pin release. this pin falls into place when the brakes are applied and inertia set the pin in place to stop the seat belt from unwinding. wind the belt in the tightening direction, pull pin out of gear mechanism and reinstall....best bet would be buy new

Posted on Feb 21, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to Reset airbag light


  • Most likely you replaced the clock spring and air bag module right? Well when the srs deploys you also have seatbelt pre-tensioners that are part of the whole retractor assembly and cannot be repaired. Ie either side retractors are not working right , then you need to replace according to chrysler corp.

Oct 09, 2014 | 2006 Dodge Durango Limited

1 Answer

2006 honda accord seatbelt deployed and now my srs light is on how can I reset


If you're talking about the airbag, (seat belt deployed makes no sense,) you have to have the dealership replace the airbag and charge before it will pass inspection...

They'll clear the SRS light.

Mar 09, 2014 | Honda Cars & Trucks

1 Answer

Seat belt light flashes after seat belt is on


The new 2013 Bentley Mulsanne Mulliner has the same thing.I know on the Bat Mobile it means the ejector seat is not fully charged.

The only generic answer I can conclude with information you provide is ;

1) The passenger seat of a newer general motors car

2) The seatbelt light does not light up when the seat is not occupied

3) The passenger side Airbag (SRS) has been turned OFF

4) While occupied , the seatbelt light on the insrument cluster lights steady

5) when the seatbelt is active (buckled with a passenger) the light flashes.

6) anybody?

Mar 31, 2013 | Cars & Trucks

1 Answer

How do i deactivate srs so i can replace front seatbelts on 2005 yaris


Disconnect the battery negative terminal.
1. Wait at least 90 seconds after the ignition switch is
turned off and the negative (-) terminal cable is
disconnected from the battery before starting the
operation.
(The SRS is equipped with a back-up power source, so
if work is started within 90 seconds of disconnecting
the negative (-) terminal cable of the battery, the SRS
may be deployed).
2. Do not directly expose the steering pad, front
passenger airbag assembly, center airbag sensor
assembly, front airbag sensor, front seat inner belt
assembly, seat position sensor, occupant
classification ECU, front seat side airbag assembly,
side airbag sensor, curtain shield airbag assembly,
rear airbag sensor or front seat outer belt assembly to
hot air or flames.

Feb 26, 2013 | 2005 Toyota Yaris 1.3

2 Answers

Endeaver srs light is on after replacing battery how can I reset also the passenger seatbelt light stays on


The light is on because the SRS computer detected excessively low voltage, likely right before your battery failed/was replaced.
To clear the light you will need to take it to a dealer or a repair shop with a Mitsubishi-compatible SRS scantool.

This happens so frequently, I never charge customers for clearing SRS lights that are related to battery changes (code will be IG low voltage A and B).


Oct 03, 2009 | 2006 Mitsubishi Endeavor

2 Answers

SRS light


Here's a quick check list for most common cost of SRS / Air bag problem.

Dirty contacts on driver and passenger seat belt buckles

Dirty contacts on seat belt connectors (under seats)

Dirty contacts on driver and passenger sides weight sensors (under seat)

Seat covers

Weight on passenger seat
(Example: grocery package trigger SRS / Air Bag light on the way home.)

I recommend you to pass an vacuum over the contacts and use CRC electronic parts cleaner to rule out connectivity problem.

I DO NOT recommend disconnecting the negative battery connector to clean the code(s).

Without the code(s) the dealer will takes "BILLABLE" time to reproduce the problem.

======

Please rate my answer if it is useful to you.

Cheers,

Mustgo

Aug 19, 2009 | 2000 Acura TL

2 Answers

It is inspection time and my srs light in my 2001 mitsubishi eclipse is on what is this? i assume srs is something to do with airbags , or restraints not sure but could this be caused by a bad sensor or...


You are right, SRS is to do with the airbags (Secondary Restraint System, the seatbelts being the first!)

It is almost certainly a bad sensor or a fault with an airbag squib (the thing that fires the bag.)

I would advise against DIY fault-finding. Let a professional look at it using proper diagnostic equipment.

Hope this helps!

Jun 20, 2009 | 2001 Mitsubishi Eclipse

2 Answers

Srs light needs to be reset


Here's a quick check list for most common cost of SRS / Air bag problem.

Dirty contacts on driver and passenger seat belt buckles

Dirty contacts on seat belt connectors (under seats)

Dirty contacts on driver and passenger sides weight sensors (under seat)

Seat covers

Weight on passenger seat
(Example: grocery package trigger SRS / Air Bag light on the way home.)

I recommend you to pass an vacuum over the contacts and use CRC electronic parts cleaner to rule out connectivity problem.

I DO NOT recommend disconnecting the negative battery connector to clean the code(s).

Without the code(s) the dealer will takes "BILLABLE" time to reproduce the problem.

======

Please rate my answer if it is useful to you.

Cheers,

Mustgo

Apr 15, 2009 | 2000 Volvo S70

2 Answers

02 honda accord v6 SRS light on


SRS = Safety Restraint System. Work all your seatbelts, make sure they snap in & release properly. If you have the system where it detects someone in seat without belt on, may be a sticky switch under seat,may be able to fix it just by sitting in seat then getting out of it, or hitting seat cushion with hand, look for things like that. Also check owners manual for location of possible air bag fuse blown. If you can't cure it, stop at shop or dealer & have it checked, just in case it is airbag not working.

Apr 12, 2009 | 2002 Honda Accord

1 Answer

Replace seat belt


take off trim along lower door jamb, remove cover between doors. unbolt torques type bolt holding upper seat belt.same with the lower or floor connection bolt. need to buy large torques bit!! attn.. theres a elect. conn. to reconnect on the new or used belts, srs light may half to be reset at dlr. good luck !!

Dec 08, 2008 | 1994 Volvo 940

Not finding what you are looking for?
2007 Ford Explorer Sport Trac Logo

784 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

fordexpert

Level 3 Expert

5537 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...