Cls 350 2006 model ... the battery went flat and the trunk cant open even with the key from the smart key ... how i can reach the battery at the trunk
SOURCE: how do you change oil in 2006 mb cls and reset
Practice now is to do a Top Side oil change. This means the engine oil is vacuumed out of the oil pan via the dip stick tube with an oil extractor..
Why ? Because this is quicker, doesn't need a hoist or pit and you don't have to remove the fiddly under covers to get to the drain plug..
Mercedes deliberately places the bottom of the dip stick to withing 1/16" th on an inch of the bottom of the oil pan.
Most if not all engines no have no dip stick, just a cover plug.
Oil level is checked with the cluster and scanner.
Setting is usually around 53mm on the scanner read out.
Oil filter is to the center right of the engine under a screw on plastic cover.
Mercedes special tool needed to unscrew it or generic tool available at auto parts stores.
Oil filter kit comes with large O ring for cover and oil filter element.
To reset FSS you turn to your handy owners hand book and read about the Oil Service Reminder Reset.
It explains how to use the steering wheel buttons and the 'R' button on the left of the cluster.
.
SOURCE: How do you reset maintenance indicator on a 2006
u can check cls manual or take it to a dealer.
SOURCE: I have a 2006 CLS 500...44,500 miles...due for
service details are given in a booklet that comes along with cls. u'll get all the information there.
SOURCE: how to reset the srs
Before resetting the SRS I would advise to take note of the error. You would need an OBD scan tool for you to get the errors and to reset the SRS.
On the fuse box found on the driver side of the car you should see the port for the OBD tool. Connect the OBD tool. Turn the key to the 'Run' position (the one before 'start'). List down the codes and make necessary repairs with the shop. This also resets the SRS if you wait for the light to go off before disconnecting the OBD scan tool.
SOURCE: what is the meaning OBD to reset SRS for CLS 500
You need a on board diagnostic scanner plugged in to locate fault
SRS is safety restraint system, fault is usually seat belt sensor
A good local auto electrician will locate the problem
Main dealer will cost a lot of money
Good luck Barry
Testimonial: "thanx"
167 views
Usually answered in minutes!
×