Question about 2004 Chevrolet Monte Carlo

Open Question

How to change the blower motor resistor 2004 monte carlo

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 147 Answers

SOURCE: 2004 monte carlo blower resistor

I may have a book on that car and I can find out for you but if the resistor is bad the fan should work on high..

Posted on Sep 23, 2008

  • 1 Answer

SOURCE: 2000 monte carlo blower motor works 1 thru 4 5 not working

I had similar problem. There is a small electrical card that is behind the blower motor up into the unit. it is the part that the wires plug into. It has traces on the card that, when you select a speed, will allow current to flow to the motor. The trace that was for the #5 setting had opened up. I had to solder a wire across the trace. got my #5 back. This resistor card shoud be availble at GM dealers if you do not have the know how to fix it.

Mike

Posted on Sep 23, 2009

  • 56 Answers

SOURCE: blower motor works one speed

If it only blows on high the fan swicth needs to be replaced

Posted on Aug 22, 2010

  • 1608 Answers

SOURCE: 2002 monte carlo blower motor doesn't work

Go on the passengers side under the dash you will find the blower motor.You may have to remove the insulator panel to see underneath.Usually a couple of screws or plastic push pins.There`s a connector that goes from the blower motor to the blower resister.The problem is usually the resistor.You will need to check the connector out very carefully because they get hot and melt.If this is the case you need to replace both the resistor and the connector.Most dealerships stock these parts. Hope this helps.Good luck.

Posted on Dec 05, 2011

  • 190 Answers

SOURCE: a/c blower motor doesnt come on 2004 Chevy Monte Carlo

POSSIBLE FAN RELAY OR MOTOR IS BAD

Posted on Sep 27, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

Blower for heat only works on high. How to get 1-4 to work?


I agree with Dan.... The blower motor resistor is the problem

Jan 19, 2016 | 2000 Chevrolet Monte Carlo

1 Answer

Blower moter does not work ( 2004 monte carlo )


Check for power to heater motor, if you have power then you will need a new heater motor. The heater motor is located under the dash on the passengers side. You can try tapping on the motor and sometimes it will start up (short term fix). There is also a resistor in behind the heater motor but normally the fan will work on one speed if the resistor is the problem.

Mar 04, 2013 | 2004 Chevrolet Monte Carlo

1 Answer

Blower motor won't shut off on a 2005 chevy monte carlo


Your post is not making sense. If the blower motor wasn't shutting off, how would replacing it cause anything to change? Clearly, there is a problem with the power supply TO the motor. If you want the motor to turn off, you need to check WHY the power to the motor is not cut off when the switch is turned to the off position. Probably a bad switch. Or it could be the blower motor resistor even, albeit a lot less likely.

Feb 24, 2013 | 2005 Chevrolet Monte Carlo

1 Answer

Blower motor problems


There are three fuses involved.
A 10amp and 15amp that powers the control, and a 30amp that actually powers the blower motor control processor and the motor itself.
Do you have power on all three circuits ?

Feb 21, 2013 | 2004 Chevrolet Monte Carlo

1 Answer

Blower motor only works on high setting on my 2001 monte carlo


Hello, you will need to replace the blower resistor to correct this problem. the resistor is mounted under the passenger side of dash. it is mounted next to the blower motor. it is held in place with two 5.5 mm screws

Dec 10, 2011 | 2001 Chevrolet Monte Carlo

1 Answer

I have a 2004 chevy Monte Carlo and the heater fan won't kick in. What do I do?


The first thing I recommend is checking the fuse, then the electrical connections. If the fuse is good then I'd check the blower power wires, usually near the bottom of the glove box, making sure they are properly seating in their socket. You can further troubleshoot at this connection to see if voltage is getting to the blower motor. Use a DC volt meter, or a 12 volt tester light. The switch, relay, and blower resistor are other components in this circuit. Best of luck!

Jan 31, 2010 | 2004 Chevrolet Monte Carlo

1 Answer

2000 monte carlo blower switch works on only #5


Not the board. It's you blower motor resistor. It melted.

Dec 29, 2009 | 2000 Chevrolet Monte Carlo

1 Answer

2004 monte carlo blower resistor


I may have a book on that car and I can find out for you but if the resistor is bad the fan should work on high..

Sep 23, 2008 | 2004 Chevrolet Monte Carlo

Not finding what you are looking for?
2004 Chevrolet Monte Carlo Logo

Related Topics:

120 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...