Question about 2008 Dodge Grand Caravan

1 Answer

Motor sounds to loud as i accelerate 2008 dodge grand caravan

Motor sounds to loud almost like in low gear but changes gears

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 249 Answers

What is your model number is then we can get started then

Posted on Jan 14, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
egstriker23
  • 44 Answers

SOURCE: How do you reset the

-Turn the key to the run position (where all the dash lights come on)
-Immediately push the accelerator pedal to the floor 3 times, taking about 1 second for each push
-The pedal has to go all the way to the floor and all the way back up.
-After the third pump, turn the key to the off position

It may take a couple of tries to get it right. It's basically a rhythm: key on...push...push...push... key off.

Hope this helps!

Posted on Oct 13, 2010

  • 350 Answers

SOURCE: Loud ticking/knocking/rattling sound when I start/accelerate

hi is it miss-firing as it sounds like a knocking noise can be anything but if you can feel it on the accelerater pedal then the noise sounds like its on the inlet valve side which would transfere the noise up the throttle body where the accelerater is located it could be something as simple as a tappet come loose to a burned valve you need to have a look do a compression test and take the rocker cover off see if theres anything come loose yates210456

Posted on Oct 13, 2008

  • 2 Answers

SOURCE: air conditioner blower motor resister on dodge grand caravan

in my 2004 grand caravan it's behind the glove box and left of the blower motor. disconnect the wires first then remove the 2 screws to pull out the resistor unit. First make sure you have removed the negative of your batterie. I had the same pm that prevented the blower motor to operate in any speed. I hope this will help

Posted on Dec 25, 2008

udesh99
  • 97 Answers

SOURCE: Backfires in manifold on motor on acceleration. runs ok low speeds

Nornally reson for backfire is when intake Valve open Internal combustion in Cylinder. Pls Check Your Ignition Timing & Valve Timing. ( I think Your Timing Advancer is Defect )

Posted on Jun 01, 2009

techbuster
  • 5081 Answers

SOURCE: Heater blower motor replacement -1997 Dodge Grand Caravan

Remove the cover plate on the passenger side of the heater box, 3-4 screws.
Unplug the motor assembly, remove 3-4 more screws that hold the motor in place and pull it down from its position. Get an aftermarket motor and installed it in the original housing with the original squirrel cage.
Installation is the reverse of removal.

Posted on Nov 23, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2008 dodge grand caravan and the check engine light came on, when I had it checked it said ers low voltage or low power I don't remember.


Putting the code in with your question would be much better than three different phrases. If it really is an electronic range selector, it sounds like problems with the transmission. If it came back, it means your transmission needs to be inspected, and repaired if necessary. If you don't, you may find yourself in 'limp-in' mode at the worst possible time. In this condition, the transmission controller puts it in second gear and it will not shift up.

Nov 02, 2016 | 2008 Dodge Grand Caravan

1 Answer

Misfire on #5 cyl


2005 Dodge Grand Caravan 3.8L engine misfire on cylinder 5.

answers.edmunds.com > Edmunds Answers
Aug 14, 2012 - MIL on; cylinder 5 misfire; most noticeable at idle in gear ... This could be caused by an EGR valve that is sticking partly open and not closing ...

OBD-II Trouble Code: P0305 Cylinder 5 Five Misfire Detected

www.obd-codes.com/p0305
A P0305 code means that the the car's computer has detected that one of the engine'scylinders is not firing properly. In this case it's cylinder #5.

ODB Code P0305- Misfire in #5 Cylinder - 2008 Dodge ...

repairpal.com > ... > Grand Caravan > 2008 Dodge Grand Caravan
Feb 22, 2011 - ... do something with a misfire in the #5 cylinder of my V6 4.0L engine. ... ODB Code P0305- Misfire in #5 Cylinder on 2008 Dodge Grand Caravan .... My2005 dodge grand caravan jerks when it shifts into gear what could it be.

My Dodge Grand Caravan has a Cylinder 5 Misfire,? ' Yahoo An


Dec 05, 2015 | 2005 Dodge Grand Caravan

1 Answer

2008 Dodge Grand Caravan will start but won't go into gear


Check fluid level in transmission and shift linkage if all is good it has internal transmission problems.

Oct 28, 2014 | 2008 Dodge Grand Caravan

1 Answer

Wont go into gear. gear shifter wont move. 2008 grand caravan


paw pin in tranny is stuck. check the ground wire on the brake pedal or do like me and remove the paw pin and use the ebrake when you park.

Dec 13, 2010 | 2008 Dodge Grand Caravan

2 Answers

2008 dodge caravan cannot remove key


Make sure the gear select is in park ,you may have to turn key on,and push brake pedal down,then move gear to low drive,then up to park real hard,and then try to remove the key,also try wet graphite spray(napa auto parts has this),if this was at all helpful,please rate,thank you.

Jul 30, 2010 | 2008 Dodge Grand Caravan

1 Answer

Makes a loud whining noise and is slipping when


Verify that your trans fluid is at the correct level. When if at all was the trans last serviced?

If fluid is low, try bringing it up to proper level with Valvoline ATF+4 fluid. You need to used either fluid from a dealer, or the valvoline brand which is approved by Dodge.

May 19, 2010 | 2001 Dodge Grand Caravan

2 Answers

2008 dodge grand caravan - wont engage park


check fuel pump and relay, remove cap listen for whirling sound in tank, listen for click under hood for realy

Sep 20, 2009 | 2002 Dodge Caravan

Not finding what you are looking for?
2008 Dodge Grand Caravan Logo

171 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...