Question about Toyota Tundra

Open Question

How do i change starter on 2008 toyota tundra 5.7 v8

Start and one click. battery is good and so are the terminals.

Posted by Anonymous on


3 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 232 Answers

SOURCE: timing belt of toyota tundra 2001, V8 motor 4.7

Here's the diagram you need4582d6e.gif

Posted on May 09, 2009

  • 274 Answers

SOURCE: I need to replace starter

No you do not need to remove the plenums. The starter is removed and installed from underneath the truck of from within the wheel well if the wheel is removed. You should go buy a Haynes or Chilton repair manual for $20 they are indisposable to do it yourselfers and will give detailed step-by-step instructions with pictures.

Posted on May 12, 2011

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Recently my truck couldn't start. It made a clicking/ticking noise when I tried to crank it. The battery got jumped and it started. Turned it off then it started again. Another time it didn't start. Moved...


Aug 29, 2013 | 2003 Dodge Dakota Club Cab

1 Answer

Car make rapid clicking sounds when attempting to start

Thats usally a bad battery or bad battery cable connections. If the battery is garunteed to be good and charged, then start looking for a loose terminal or heavily corroded terminals.

Dec 30, 2011 | 1998 Ford Mustang

2 Answers

Getting one click sound when trying to start truck

Dead Battery. Try jump starting, then run it by any good parts store and have charging system tested and battery "load tested". Most parts stores (Autozone, Advance, etc..) will do this FREE

Apr 04, 2011 | 2006 GMC Yukon Denali

1 Answer

Car will not start. A clicking noise when trying

It's either a dead battery or loose/rusty battery terminals, try to pour hot water on battery terminals and then tighten them if loose, if still it doesn't start and keep clicking and if you had the battery for more than 4 years then install a new battery (you can get a good one for around $50, don't buy expensive ones they do the same job). Hope it helps and please don't forget to rate the answer it helps me with my general ratings, thanks!

Apr 11, 2010 | 2000 Mercury Grand Marquis

2 Answers

93 wrangler won't start. no clicking when key is

If the battery is brand new then yes, the starter assembly/starter solenoid (located on top of the starter) is bad.

Oct 31, 2009 | 1995 Jeep Wrangler

4 Answers

I have a 96 chrysler lhs it wont start

Hi I'm litoshop if your getting a clacking noise then yes it's the starter if you can reach the starter tap it with a hammer and try to start if it starts then you can rebuild or replace the starter good luck. if this information has been useful please let us know thank you.

Aug 14, 2009 | 1996 Chrysler LHS

2 Answers

O4 armada wont start. battery good terminals

sounds like the terminals at the starter may be bad. thats the sounds you would normally get from a dead battery, but if the batt and terminals are good then check the connection at the starter. if the connection at the starter is good then you probably need a new starter.

Aug 06, 2009 | 2004 Nissan Armada

1 Answer

The battery is good but there is no click or any noise when start

First, establish that there is 12v at the battery (with a volt meter) then remove terminal ends and clean contact surfaces. Check that there is 12v at the main starter terminal and 12v at the starter trigger wire with the key turned to the start positon. If not, check starter relay, neutral safety switch and ignition switch. Make sure battery ground wire on engine is also clean and secure.

Jun 19, 2009 | 1997 Plymouth Neon

4 Answers

When I turn the key, all I hear is the clicking sound. Battery appears to be okay, had it checked a month ago by Sears. A jumpstart doesn't work either.

It's the starter. You can probably get it started by finding a long steel rod, or a long garden rake stick(with the rake removed)...get under the hood, find the starter, and tap hard on the starter while someone in the truck is trying to start it. I mean really bang on the starter! It should start, but you will have to change the starter eventually.

Give it a try.


Jun 03, 2009 | 1996 Toyota Land Cruiser

4 Answers

Battery good, wont turn over, just a click when try to start

it is most likley starter relay or starter.with vehicle in park and e-brake on have someone tap on the starter with hammer while your trying to start.if starter starts to crank then you know the starter is on the way out.if starter does not crank it may already be shot.srarter relay is on fire wall check power + ground.

Oct 26, 2008 | 2000 Ford F250 Super Duty Crew Cabs

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

1,492 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts


Level 3 Expert

76051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8265 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides