Question about Cars & Trucks

Open Question

Removing complete door and wiring loom from 2005 fiat punto mk3

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: Fiat Punto

hi i have recently bought a 1200 fiat punto sporting and it driving my nuts every time i go to try fill it up the petrol backs up and comes out all over the floor can you tell me what causes it and if their is a cure as its inconvient and an embarressment

Posted on Jul 30, 2008

Ad
  • 289 Answers

SOURCE: lighting problem fiat punto

Then there will be some wrong connection of wire
between the indicator and the break light.
thanks..

Posted on Feb 01, 2009

bunnydawg
  • 5158 Answers

SOURCE: Fiat Punto indicators

you need to change the flasher unit .... also check fuse # 24 on the fuse panel inside the vehicle. the flasher unit should be just under the dash on the steering wheel side... i have alot of information on that vehicle but i couldn't find where exactly the flasher unit is located.

Robert

Posted on Feb 17, 2009

  • 51 Answers

SOURCE: fiat punto acceleration problems

nikki,

I had a similar problem with a 98 sporting. It turned out to be firstly the clutch had worn down to almost nothing and the fuel filter hadn't been changed in a good while so it got clogged. I would do the filter first. (located just under the drivers side near the rear wheel.

Posted on Apr 27, 2009

  • 1986 Answers

SOURCE: fitting a wing mirror on the passenger side of a fiat punto

On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can access the bolts that secure the mirror onto the door

Posted on Sep 29, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i remove a fiat punto drivers seat


Theres only 4 bolts that hold the seat down 5 or 6 mm allen key bolts Dont forget the wire under the seat for the air bag. Move the seat fully forward take out the rear bolts, move fully back and do the front. Refitting is as easy
.

Mar 10, 2015 | 2005 Fiat Punto 1.2

1 Answer

How do i remove the clutch in a 2007 fiat punto 1.9 turbo diesel


get a workshop manual if doing diy, but I would seriously suggest a garage

Feb 14, 2015 | 2005 Fiat Punto 1.2

1 Answer

Where is the jack point for a fiat punto 2005


look for arrow(s) next to tire under door, there will be a stiff ridge of metal with notches on either side

Jan 12, 2015 | 2005 Fiat Punto 1.4

1 Answer

How do you remove the passenger side rear door panel in a 2006 Fiat Punto


1 Prise out the trim cap and undo the screw securing the exterior mirror inner trim panel of door
2 Where a manually-adjustable exterior mirror is fitted, prise the rubber cover off the adjustment lever, then unscrew and remove the locking collar using pointed-nose pliers.
3 Pull the panel from its location to disengage the retaining clips. Disconnect the loudspeaker wiring connector and remove the panel.
4 Lift off the trim caps, undo the retaining screws, then remove the door interior handle surround.
5 Carefully prise off the loudspeaker grille then undo the three loudspeaker retaining screws. Withdraw the speaker from the door and disconnect the wiring connectors.
6 Undo the three retaining screws in the loudspeaker aperture, and the single screw in the oddments pocket just below the aperture.
7 Lift out the loudspeaker protective cover and withdraw the loudspeaker wiring from the base of the cover.
8 Prise out the trim cap and undo the screw securing the rear of the trim panel to the door frame of Fiat Punto car.
9 Undo the screw at the upper front corner of the panel, and the remaining four screws securing the lower edge of the panel to the door frame.
10 Using a suitable forked tool inserted between the door and the trim panel of Fiat Punto, release the press-stud clips located around the edge of the panel, then lift the trim panel upward.
11 Pull the panel from the door, noting that the lower window aperture weatherstrip is integral with the trim panel and must be released from tie door as the panel is withdrawn.
12 If work is to be carried out on the door internal components, it will be necessary to remove the plastic sealing sheet from the inside of the door. Start at one comer of the sheet and carefully peel it away, using a sharp blade to split the sealant bead, if necessary.
13 Store the detached sealing sheet such that it cannot become contaminated with dust; this will allow it to be re-used later.
Source (with illustrations) - Door inner trim panel removal and refitting FIAT Punto
11_26_2014_6_35_50_pm.jpg

Feb 22, 2013 | Fiat Grande Cars & Trucks

1 Answer

Head bolt torque settings


Torques Punto 1100 year 1995

1st round: 20 Nm
2nd round: 30 Nm
3th round: add a quarter

4th round: ad another qourter

sequence:
8 6 2 5 10
7 3 1 4 9

This is the 'Fire' engine, also placed in the Uno and Panda.

Oct 08, 2012 | 2005 Fiat Punto 1.2

1 Answer

My fiat punto loses power when driving uphill


I have a 98 punto sporting nd today it started running like it was misfiring but wen i accelerate slow its fine but wen u accelerate as normal it spits and splutters :'( any suggestions??i have change fuel filter nd injectors ????

Sep 22, 2012 | 2005 Fiat Punto 1.2

1 Answer

Dashboard not working on fiat punto


By no power, do you mean no lights or absolutely no instrument activity? Could be just a bulb or fuse that needs replacing, if you have no instrument activity at all, I would suggest you disconnect/reconnect the battery, if problem persists - might help, and if all else fails then it is possibly a loose or badly connecting wire, take it to an auto electrician, the wiring looms are tricky and it could take a while to find the culprit.

Jun 26, 2012 | 2001 Fiat Punto

2 Answers

Boot wont open on fiat evo punto 2011


does anyone know what number fuse is for the boot? it wont open also the passenger window. many thanks

Mar 17, 2012 | 2011 Fiat Punto Evo

2 Answers

Fitting a wing mirror on the passenger side of a fiat punto


On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can access the bolts that secure the mirror onto the door

Apr 18, 2009 | 2006 Fiat 124

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

49 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...