Question about 1988 Mazda B2200

Open Question

B2600 meter fuse keeps blowing - 1988 Mazda B2200

Posted by Anonymous on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I have a 2007 Toyota tacoma 4WD double cab my shifter lights my heater lights and tail lights keep blowing a fuse traced them all and there is no bad ground or any thing


do you have acell phone or other charger plugged in or multiple chargers?? i seen so many that draw way to much and keep blowing fuses. we've run several hot sockets direct from the battery to provide power for such dont forget to fuse it !

Mar 06, 2015 | 2007 Toyota Tacoma

1 Answer

Replace 15 amp fuse to a 30


NO,NO,NO ! Fuses are electrical protection for the cars wiring installing a higher amp-age fuse takes longer to blow so your wiring gets hotter and starts to melt the insulation and shorts to other wires eventually burning up the harness. With a amp meter test the circuit to see how much power is needed to keep the circuit going if over rated (15 amp circuit taking 20 amps) then install a cycling circuit breaker 10 amp this will blow and cool and blow again continually then with a magnetic amp meter (Gauss meter) you can locate your short the source voltage causes the amp meter to jump as the fault occurs when you pass it meter will stop working.

Apr 22, 2014 | 2002 Ford Escape

1 Answer

The engine in my mazda b2600 1994 sometimes makes short cut offs in seconds time.i cant find the reason,please help me


comon proble is ignition switch. try moveing key slightly towards off. if vehicle dies, that could be your problem.

Dec 15, 2012 | 1988 Mazda B2600 Cab Plus

1 Answer

I have a 1999 mazda b2600 it keeps coughing and splattering . I have changed the leads plugs dizzy cap o2 sensor and i bought a second hand air flow meter can anybody please help me out ? Thanks and its a...


egr position sensor aka the dpfe is often the culprit, its mounted on the firewall and has an electric connector and vaccum lines going to it.

Dec 05, 2012 | Cars & Trucks

2 Answers

What is wrong when your ignore and meter fuss keeps blowing


Not 100% on the first part of the question...but fuses blowing makes me think faulty wiring is to blame. Check for frayed or damaged wires.

Mar 14, 2011 | 1995 Geo Tracker

1 Answer

Keeps blowing the prime fuse under hood,gas gage won't read,heated seats won't come on,after truck starts,blows that fuse each time.Problem just started.


this problem is most likely caused by a fuel pump with high amp. draw on start up.use a amp meter.then replace fuel pump.

Oct 23, 2009 | 2003 Chevrolet Silverado 1500

1 Answer

Car dying out on acceleration


try having the air flow meter just behind the filter checked i hav a 94 proceed had similar problem and the air flow meter was the cause

Feb 26, 2009 | 1988 Mazda B2600 Cab Plus

1 Answer

Keeps blowing 15a efi fuse 1991 toyota pickup 2.2 re


there's a short somewhere causing that amperage to go up

Dec 12, 2008 | 2004 Toyota Corolla

2 Answers

Meter fuses keep blowing out on 1996 nissan altima


you have a short to ground somewhere. Look for worn wires, loose connections, any work recently done.

Dec 09, 2008 | 1993 Nissan Altima

1 Answer

Meter fuse 95 probe


you no doubt have a direct short in your wiring, or a bare hot wire is touching or rubbing a ground. check all wires that go to your meter. you don't say which meter it is. amp,water,oil,or battery.

Jun 27, 2008 | 1995 Ford Probe

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

35 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8531 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...