Question about 1984 Mercury Grand Marquis

1 Answer

Engine turns over but wont start - 1984 Mercury Grand Marquis

Posted by on

  • ksuharris Apr 17, 2009

    gettin gas and spark, timing is good but i ineed to know if the solenoid is correct

  • Mike Butler
    Mike Butler May 11, 2010

    First you'll need to determine if your getting spark & fuel. Need details on how, or have you checked those 2 things already?

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 491 Answers

Check to see if your geting fuel from fuel pump or pump relay is good. also check for spark to plugs

Posted on Jan 23, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

It turns over but it wont start


Engine cranks but won't start. Troubleshooting tips

www.samarins.com/diagnose/index2.html
In this guide, we are going to look into no-start problems when the car engine cranks,but won't start. If your engine won't crank at all, check the first part No-start: ...‎Why a car won't start - ‎Crankshaft position sensor - ‎Check Engine light

Engine cranks but won't start - YouTube

? 8:03
https://www.youtube.com/watch?v=1L4nB2NdA0U
May 16, 2014 - Uploaded by jimthecarguy
2003 Ford Taurus 3.0 liter 24 valve no start cranks OK.You will not ... Car will not start trouble shooting guide, wont crank, wont turn over, etc.

Problem 5: Engine Cranks But won't Start



Jan 01, 2016 | Cars & Trucks

1 Answer

96 crown Victoria wont start had the problem couple weeks ago guy said the idle control was off now I guess doing it again I cleaned it but still wont turn over


When you say it wont turn over that implies that you can not hear the starter turning the engine over. If you can hear the starter cranking the engine over but the engine will not start try holding the gas pedal to the floor. Be prepared for the engine to start and let off the gas. If the engine stalls when you let off the gas try starting again but feather the gas pedal after it starts. It it stays running with the pedal depressed than I would agree that there is an issue with the IAC and it may need to be replaced.

Jul 31, 2013 | Cars & Trucks

1 Answer

Hot Starting Problem


hard starting problems when engine hot could be restricted air filter.restricted clogged fuel injectors.engine could either be diesel or gasoline.if engine dont start and starter wont turn over engine. could have bad battery ground cable or battery positive cable could have broken place when cable get hot crack increases cause less current engine wont have enough power to turn over.

Apr 30, 2013 | Peugeot Cars & Trucks

1 Answer

1998 terrano immobiliser fault wont start


hi, i have nissan terrano wen i switched on engine light flash and start engine its start then go of.nissan terrano patrol engine

Sep 06, 2012 | Nissan Sentra Cars & Trucks

3 Answers

1992 geo prizm - radiator hose broke and replaced, but car won't start now - ideas?


you said it cranks then you said it wont turn over if it wont turn over you might have get the engine to hot and seized the engine please spesifiy if the engine turns over or not

Jun 09, 2012 | 1992 Geo Prizm

2 Answers

Antitheft wont let engine turn over or start


have you tried disconnecting the battery for 15 -- 30 minutes, it may allow the anti-theft device to reset....

Jul 22, 2009 | 1999 Ford Windstar

2 Answers

My 2001 chrystler concord will turn over but wont start


Check and make sure that the engine is not seized up. Does the engine turn over?

Jun 27, 2009 | 1996 Chrysler Concorde

2 Answers

1997 Gmc Yukon wont start


when you say it wont start will the engine turn over?
if it wont turn over i think you should check your battery connections
if the engine turns over then you need to check your fuel pressure and spark and let me lknow

Jan 02, 2009 | 1997 GMC Yukon

4 Answers

Car shakes when trying to start and doesn't turn over


  1. hold gas pedal to floor while trying to start. do not pump pedal.
  2. holding pedal to floor is how you start a flooded f.i. engine

Nov 12, 2008 | 2000 Lincoln LS

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

172 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

60541 Answers

Fordexpert

Level 3 Expert

5331 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21927 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...