Question about 1997 BMW 328

1 Answer

2002 bmw 745i disable alarm

Will not crank, fuel pump comes on, radio comes on, P,R, N, D on dash gauge flashing

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • BMW Master
  • 1,013 Answers

It could be that your battery doesn't have enough voltage to turn over the engine (that requires a lot more current than running the other accessories). Check the voltage of the battery when you try to turn it over- it shouldn't go below 11 volts. If so, you likely need a new battery.

Posted on Jan 14, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 208 Answers

SOURCE: i need to change my oil and filter on a BMW

The oil filter is located underneath the vehicle next to the drain plugand accessed through a removable trim cover. If I remember correctly the drain plug is a 7mm allen. The oil filter has a drain plug in it to predrain before removing the filter cap. I do not recommend removing the plug because it strips out sometimes. Instead you need to use a socket and loosen the cap slowly. Your engine will take 8qts bmw syn 5w30 oil. I like the factory oil because it is proven extended life oil. When reinstalling the drain plug make sure to replace the crush washer. Also, make sure to replace the oring on the oil filter cap and lube before reinstalling.

Posted on Mar 18, 2009

tse22
  • 103 Answers

SOURCE: brake warning light is on for 2002 bmw 745i.

The brake pads have sensors in them, when the pads get worn down to the sensor the light comes on letting you know its time to replace. this happens well before the pads are completely gone to reduce wear on the rotors. You should have the brakes replaced and the sensor also.

Posted on May 17, 2009

Atyourdoor
  • 93 Answers

SOURCE: BMW 745i airbag light. Told to replacing airbag clockspring

Hello , check the airbag contact sensor behing the grill assembley . They are located to the left and right of the grill almost to the headlight assemblies. Check the wires to them for corrosion and damage. Check the fuse as well. There should be an air bag testing wire or fuse in the fuse panel. DO NOT UNPLUG THE AIR BAG SENSORS OR HIT THEM !!

Posted on Aug 22, 2009

  • 1 Answer

SOURCE: bmw 745i 2003 water leaks out from front of motor

I had this same problem in my 02 745i... It's leaking from the internal coolant pipe... a $.05 rubber ring is going to cost you 3-5k easily.

Posted on Feb 20, 2010

  • 87 Answers

SOURCE: HOW TO CHANGE THE OIL AND FILTER ON A BMW 745I BMW

open drain plug and let out oil.
oil filter unscrews and new one goes inside

Posted on Jul 22, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

No spark or injector pulse car will crank but not fire 1993 efi g200 daihatsu charade


There is no cranking signal to the computer first check all fusses and make sure when the ignition is on that you have a check engine lite on the dash that lights up when the key is on then you need to check for a signal out of the crank sensor if you do have it then you have to check it at the computer next a fast way to tell if the computer is getting a cranking signal is to turn the key on fuel pump relay will prime the system do not turn the key off and exit the fuel from your gauge into a can so there is no pressure showing on the gauge as long as you did not turn the key off now crank the engine if fuel pressure comes back then the computer is seeing a cranking signal

Apr 08, 2016 | Daihatsu Cars & Trucks

1 Answer

Car will not crank will crank if I jump relay. But not start. Gauges on dash don't work. Warning lights come on one at a time. Never did that before


Sounds like engine not getting fuel. Have pressue check run on fuel pump. Check to see if fuel pump circuit breaker or fuse is good

Sep 13, 2015 | 2005 Jeep Liberty Sport

1 Answer

I repace fuel pump ,spark plugs,crankshafts,,battery,. stil no start only crank.check for fuel pressure no fuel pressure,also sheck for spark no spark ,no power on coil ether.please help 2002 nissan...


Your first problem is no power to the coil/s. This could be the ignition switch or wiring from there to the coils. With ignition on, you should have 12 volts to the coil/s. The ECM grounds it out with help from the crank sensor. If you turn the ignition switch on and have the dash gauges and hear relays kick in, then check for bad/broken wires. Several things come on while in the run position. Like radio, blower fan, lights/gauges in the dash. If they don't come on, first would be checking the switch, then wires. You need a volt ohm meter, electrical shcematics.

Dec 21, 2014 | 2002 Nissan Pathfinder

1 Answer

Where is the fuse for my alarm on my 1998 ford expedition


Yes the PATS (Passive Anti Theft Sytem) will disable your fuel pump. If you have a second key try that first, in case it is the chip in the first one.

Jul 23, 2014 | 1998 Ford Expedition

5 Answers

2001 GMC Jimmy wont start


Try pouring a little gas into the throttle body and starting. If it runs and dies, most likely a bad fuel pump. I already had to put two of them on my 1998 jimmy. Good luck!

May 17, 2014 | 2001 GMC Jimmy

2 Answers

Anti theft wont let me start car


The problem may not be with anti-theft but with a bad fuel pump,cam/crank sensor etc. Also, you may try unlocking the drivers door with the key. On most cars that is the standard method for disabling the security system.

Mar 06, 2014 | Isuzu Cars & Trucks

1 Answer

95 bmw 525i no dash lights no tach no tremp gauge and fuel gauge pegged way past full


Why was the battery missing to begin with? I would start by checking all fuses under dash and Central hub. Check for burned in-line fuses,if any, coming off of battery cables.

Jan 16, 2014 | Cars & Trucks

1 Answer

Bmw 745i problems


check your fader switch from front to back >>>>>>>>>>>mutebuttonon radio not switched on ...alternatively radio output or amplifier in car if fitted

Jan 13, 2014 | Cars & Trucks

1 Answer

Turns over but won't start, fuses are all good, brand new CKP sensor, plugs and wires are new, fuel pump humms, when the key is turned to on, battery gauge on the dash is normal when cranking, I have all...


Find the duel rail. Locate purge valve(like a tire valve) unswrew cap on it have one person crank the key and the other person holding in the valve. If gas comes out? Pump is ok if not then may need replaced but check the power to the pump first

Sep 19, 2013 | Cars & Trucks

Not finding what you are looking for?
1997 BMW 328 Logo

Related Topics:

123 people viewed this question

Ask a Question

Usually answered in minutes!

Top BMW Experts

Frankie B

Level 2 Expert

65 Answers

Fred Sops

Level 2 Expert

272 Answers

Doberman

Level 2 Expert

254 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...