Question about 2005 Chevrolet Malibu Maxx

Open Question

Where are the screws that hold the blower motor, and what type are they?

I am trying to replace my blower motor in my 2005 Chevy Malibu it stopped working,

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 82 Answers

SOURCE: Blower motor or resistor?

If it was the motor that went out then it would not blow at all. The resistor is the culprit that starts killing off speeds. It should be about $25 to $30 at an aftermarket store like autozone or advanced auto parts.

Posted on Jan 09, 2009

MacGyver911
  • 42 Answers

SOURCE: I have a 2001 Chevy

Replace the blower motor resistor. Remove the shroud below glove box, 2 screws and a snap-pop fitting. Be careful of the courtesy light. Remove the blower moter and disconnect the purple/black power connector to it - - you'll need this extra room to work with. 2 more screws, same size, 6.5mm on mine, 7or 8mm on some others, that holds the blower motor resistor in place. This replacement part is less than 40 bones at most parts store. Unplug, replace, re-install, test and you're on your way with about 2 hours of slow paced effort in your own driveway. Typical cost at a garage - up to $400, what a sham.

Posted on Mar 19, 2009

  • 118 Answers

SOURCE: How do i change the Blower motor resistor on a 2005 chevy impala?

The blower motor resistor is located behind the glovebox mounted in the fan housing box under the dash.

Posted on Jul 20, 2009

  • 753 Answers

SOURCE: 2005 Chevy Malibu Maxx cd changer error

You will need to have the radio reset or checked out at the dealer.Ther could be a cd stuck in it.Or the radio/CD player may have be on when the battery power got to low.

Posted on Jan 11, 2010

steve_e_uk
  • 1675 Answers

SOURCE: 2000 chevy malibu keeps overheating

hi this could be caused by a couple of things, thermostat not opening is one of the main one, fan heater switch on the radiator is another, and obviously water leak is another, the first one thermostat, can replaced relatively cheaply, for a few bucks, you could do it yourself if you have the correct tools, to find out if it is thermostat, fill water first, run motor till it starts to get hot, feel the hoses on either side of the radiator ( top and bottom hoses be careful not to burn yourself in the process) if one is very hot, and the other is warm to cold, that will be the thermostat, second, the radiator fan switch, fill water, run motor, watch temp Gage, if by the time it has reached over half way on the temp Gage and the rad fan has still not cut in then this is normally a sign the switch on the radiator is u/s and needs replacing ( check fuse for fan to and relay this will also stop fan from working ) also to check for leaks, fill water, ( try not to spill any ) then if available a large cloth or sheet under car, run engine ( making sure first the other items have been checked ) and just observe for dripping water hope this helps

Posted on Feb 22, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Replace blower motor 2005 malibu


Hey Kenny,here's a guide to replace blower motor,if blower is not working or just on certain speeds,if could be your blower motor resister,here's a link to the resistor.I would straight wire motor to see if it works,if it does then resister could be bad,have to replace to see if it is bad on the resister.Here's the part.

Jan 13, 2013 | 2005 Chevrolet Malibu Maxx

1 Answer

Where is the blower motor resister on 2002 Chevy Malibu


it is located under the dash on the passenger side close to the blower motor

Jan 01, 2011 | 2005 Chevrolet Malibu

1 Answer

How to replace blower motor system pack on 2001 chevy malibu


first, remove the lower right dash insulator panel from below glove box. slide bcm aside for access to blower motor.(slide to right). remove 3 screws from blower housing, pull blower motor and fan straight down. if putting in a new motor, use cage from old blower. the resistor for fan speeds is located beside motor. good-luck!!

Jul 29, 2010 | 2001 Chevrolet Malibu

1 Answer

2005 malibu - heat/ac has 4 levels for fsn, level


Your blower speed resistor has gone bad and needs to be replaced. You can pick one up at Auto Zone or Parts Source with the step by step instructions to getting the resistor replaced with common tools.

It is located under the glove box, way in the back of the passenger foot area. You'll need to remove 2 screws with a 7mm socket, and remove the plastic cover that covers the blower motor and another component box that I think controls the passenger airbag. After removing the plastic cover you'll need to side that passenger airbag module to the right so it pop off its mounting bracket and move it out of the way. That will give a better view of the blower motor. I highly recommend you also remove the blower motor itself because the Blower Motor Resistor is located behind it. I think you'll need a 5mm or 5.5mm socket to remove the 3 screws that hold in place the blower motor and 2 more screws for the Blower Motor Resistor... It's a cramped location to work in but if you have all the tools and enough lighting then it shouldn't take more than 30-60 minutes to do. The Blower Motor Resistor costs about $19-$25. Good luck

Nov 30, 2009 | 2005 Chevrolet Malibu

1 Answer

Replace blower motor resistor unit on 99 Malibu ?


the blower motor resistor is below glove box. remove panal under box. slide the pcm out of the way, resistor is beside blower motor. unplug wiring, take out screws holding it in then pull straight out to remove.

Jul 10, 2009 | 1999 Chevrolet Malibu

2 Answers

Where is the blower motor resistor on a 2003 Chevy Malibu


Remove the shroud below glove box, 2 screws and a snap-pop fitting. Be careful of the courtesy light. Remove the blower moter and disconnect the purple/black power connector to it - - you'll need this extra room to work with. 2 more screws, same size, 6.5mm on mine, 7or 8mm on some others, that holds the blower motor resistor in place. This replacement part is less than 40 bones at most parts store. Unplug, replace, re-install, test and you're on your way with about 2 hours of slow paced effort in your own driveway. Typical cost at a garage - up to $400, what a sham.

Mar 18, 2009 | 2003 Chevrolet Malibu

1 Answer

Location of the Heat resistor in a 2003 Chevy Malibu?


Under the glove box, behind the blower motor itself. Remove the shroud below glove box, 2 screws and a snap-pop fitting. Be careful of the courtesy light. Remove the blower moter and disconnect the purple/black power connector to it - - you'll need this extra room to work with. 2 more screws, same size, 6.5mm on mine, 7or 8mm on some others, that holds the blower motor resistor in place. This replacement part is less than 40 bones at most parts store. Unplug, replace, re-install, test and you're on your way with about 2 hours of slow paced effort in your own driveway. Typical cost at a garage - up to $400, what a sham.

Feb 24, 2009 | 2003 Chevrolet Malibu

2 Answers

I have a 2001 Chevy Malibu LS 6-cylinder and my heater blower stopped working. I checked the fuses and they are all good, I assume the motor for the blower is bad. I believe the blower is a 1997 - 2003...


Replace the blower motor resistor. Remove the shroud below glove box, 2 screws and a snap-pop fitting. Be careful of the courtesy light. Remove the blower moter and disconnect the purple/black power connector to it - - you'll need this extra room to work with. 2 more screws, same size, 6.5mm on mine, 7or 8mm on some others, that holds the blower motor resistor in place. This replacement part is less than 40 bones at most parts store. Unplug, replace, re-install, test and you're on your way with about 2 hours of slow paced effort in your own driveway. Typical cost at a garage - up to $400, what a sham.

Dec 17, 2008 | Chevrolet Malibu Cars & Trucks

2 Answers

Heater


Good call emissionwiz. It's right behind the blower motor, under the glove box area. Remove the shroud below the glove box, 2 screws and a snap-pop fitting. Be careful of the courtesy light. Remove the blower moter and disconnect the purple/black power connector to it - - you'll need this extra room to work with. 2 more screws, same size, 6.5mm on mine, 7or 8mm on some others, that holds the blower motor resistor in place. This replacement part is less than 40 bones at most parts store. Unplug, replace, re-install, test and you're on your way with about 2 hours of slow paced effort in your own driveway. Typical cost at a garage - up to $400, what a sham.

Nov 21, 2008 | 2003 Chevrolet Malibu

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

30 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7710 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...