Question about 2006 Chevrolet Trailblazer
Replacing licence plate lamp
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
There's no need to take the whole back panel off to do it, the light cover on the bulb twists out, and it might take some elbow grease to twist it, then the bulb is easy to change.
Posted on Jun 10, 2008
There are not two rods, there are two clips one under fender weild and one right above the light on top of the cover. Pull up on these two clips and pull the light forward a couple of inches and remove the dust cover. You have to take the air filter cover off to be able to reach in and replace the light. It took me about 10 min to figure these out but hope it helps out.
Posted on Jan 14, 2009
SOURCE: license plate light replacement
The license plate lights are in the ledge above the license plate. 2 screws keep the lens cover in place. Remove the screws, and the cover comes off. Just pull the lamp out (wedge base) and replace.
Posted on Apr 18, 2009
I just had the same problem. I took the cover off, saw the white bulb base, twisted it to take it out, but it popped back inside the door. I got it out, but it wouldn't pull through, so I twisted it back in place and went to Autozone to get new bulb. Once I saw the new bulb, it was obvious, just the bulb itself pulls out. There's so little room to work, I couldn't get it with just my fingers - - maybe rubber gloves would have worked, but I used pliers, lightly, wiggled it a little and it popped right out. I had a similar issue once with the taillight bulb and had to break the bulb and then grip the remaining filament wires with pliers to get it out, so that was my backup plan, just in case.
Hope this helps others.
Posted on Apr 19, 2009
the light can be replaced from the back side of the light housing . go under the back side of bumper under the truck behind lisence plate you will see the where the wire goes to the light . grab the housing not the wires and twist about a half a turn and pull gently. it should come out and then remove the light bulb and replace with new
Posted on Jan 29, 2010
Tips for a great answer:
Oct 01, 2015 | 2001 Pontiac Sunfire
Jan 29, 2015 | 2003 Chevrolet Chevrolet TrailBlazer
Feb 26, 2014 | 2004 Mitsubishi Endeavor
Oct 11, 2010 | 2004 Chevrolet TrailBlazer
Sep 05, 2010 | 1999 Cadillac Eldorado
Feb 11, 2010 | 2005 Chevrolet Silverado 1500 2WD
125 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: