Question about 2001 Jeep Grand Cherokee

1 Answer

Fuel Filter? Where is the fuel filter on a 1988 Jeep Wrangler?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,990 Answers

Look underneath inside the Frame Rail.

Posted on Jan 22, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Instructions how to change fuel filter on 2006 jeep wrangler unlimited?


are you sure it has 1???manual states there is no external filter.the factory filter is part
of the fuel pump module & is in the fuel tank.no service is required

good luck

Jun 18, 2011 | 2006 Jeep Wrangler

1 Answer

Where is the fuel filter on the 2006 jeep wrangler?


Your Wrangler does not have an in-line filter. The only fuel system filter is inside the fuel tank on the inlet side of the fuel pump. This filter is not usually serviced.

Jan 23, 2011 | 2006 Jeep Wrangler

1 Answer

Fuel filter location


The 1995 and earlier models employ an in-line fuel filter. The filter is located on the left side frame rail, near the fuel tank. On port fuel injected engines, the system is under pressure even when the engine is off. When the engine is cold place a container under the fuel filter. Remove the metal shield, disconnect the fuel hoses and detach the filter from the frame. Install is the opposite, just make sure the word "OUT" on the filter faces toward the engine.

Apr 11, 2009 | 1991 Jeep Wrangler

2 Answers

Jeep wrangler stalls out


check maf and tps sensor

Feb 18, 2009 | 1988 Jeep Wrangler

1 Answer

1988 jeep wrangler idoling rough


It does sound like a vacuum leak. Get a can of WD-40 and start spraying around the carb. It will rev up, and U can pin point the loose vacuum hose, are crack vacuum hose.

Feb 13, 2009 | 1988 Jeep Wrangler

2 Answers

1988 Jeep Wrangler?


under vehicle, driver side,below seating area,near fuel tank, mounted on frame rail, in fuel line.

Jan 22, 2009 | 2001 Jeep Grand Cherokee

2 Answers

I need to know where the fuel filter is on an 1988 Jeep Wrangler?


I dont know much about Jeeps, but all you have to do is get under the truck and look for the fuel lines.Fuel lines are usually shiney so you can see them easy.They should be run on the same side your gas cap is on.You should see 2 lines,one is a return line and it will not have a filter.I get gas on my driver side and my fuel filter is under the truck almost perfectly centered with the driver side door.Good luck.

Jan 22, 2009 | 2001 Jeep Grand Cherokee

1 Answer

I want to replace my fuel filter in my 1998 jeep wrangler


You have an inline fuel filter on the inside of the frame, infront of the rear tire on the driver's side. It has a metal shield/cover that has like 3 small bolts that have to be removed to take off the plate. Once you take off the plate you can see the filter better. It is metal and fairly easy to change. these do need to be changed, especially the newer models with fuel injection. The filter in the fuel tank is a screen to keep **** out of the fuel pump itself. If you have an older Jeep Wrangler, there are images and instructions on how to change them out located here: http://www.myjeepwrangler.com/fuel-filter.php Here is a clickable link: http://www.myjeepwrangler.com/fuel-filter.php
Hope this helps good luck.

Jan 18, 2009 | 1998 Jeep Wrangler

1 Answer

1988 jeep wrangler 6cylinder,5 speed trans, no a/c


Did you check the fuel filter? Did you check pump pressure? A faulty pump or a partially plugged filter can do this. Obviously filter is the first thing... it's easy to do and is often neglected, likely overdue for service anyhow! There are other things that can also cause your problem but I'd look at the common stuff first!
Good luck

Dec 30, 2008 | 1988 Jeep Wrangler

1 Answer

1988 jeep wrangler no fuel


check your fuel pump relay and your ignition switch those numbers you gave for voltage are not right, please recheck that you have a ground and 12volts at the pump while cranking please rate -jeff

Jul 09, 2008 | 1988 Jeep Wrangler

Not finding what you are looking for?
2001 Jeep Grand Cherokee Logo

Related Topics:

62 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...