Question about Cars & Trucks
Air conditioning is jammed on in my car after console buttons being hit hard and buttons not operating correctly
Posted by Anonymous on
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Located Someone With a Set Of A/C Gauges 134A Freon,
Make Sure Your A/C System Has Enought Freon In It, There Is a Low Freon Pressure Switch
In The Electrical System, Usually, 50-60 PSIG or Less On The Gauges, Will Indicate Low Freon, When Freon Is Low The Compressor Is Dis-engaged To Prevent Compressor Damage.
1] Low Freon
2] Bad Low Pressure switch
3] Blowen Fuse[s]
4] Electrical Problem[s]
[a] Digital Climate Controlled ?
Climate Control Self Diagnose From Button's On Unit, OEM Manual Explains This,
If Yor Auto Has Digital Climate Control.
5] Bad Compressor DC Coil
Note: Does The Compressor Engage, Click-On When Button Is Pressed, But Getting
Only Warm Air?
Is One Of The Compressor Aluminum Tube's Cold, Be Careful Other Is Really Warm/Hot,
If Cold and or Sweating, Dripping Water [Normal], You Are Blending Hot Air w/Cold
Air At The Heater Blend Box, Making Warm Air.
If This Is So, If A Vaccum Controlled Temp Unit, Check For A Vaccum Hose Bad,
Should Be Either 1or 2 Vaccum Lines Going Into Firewall To Feed The Controller
Unit, If OK, Might Be a Bad Blend Box Diaphram, [Control's A/C air, Blocks Off
heater Coil Hot Air].
If Your Auto Is Vaccum Controlled, Can You Changed From Bottom, Dash,
Defrost Air Flow?, Yes, No Vaccum Lost Feeding Controller, Still Might Have
Bad Diaphram Blending Hot Air w/Cold If Your Have Cold Alum-Tubing In
If Digital Climate Controlled, Might have Diaphram's, Vaccum Controlled or
electrical Servo's Controlled vs Diaphram [Vaccum] Controlled.
This Might Help, Hopefully, This Is Just For Starter's, There More To Some System's
and Without The OEM Mgr's Manual[s] You/Be Would Be Lost, especially w/Electrical.
Later, God Bless
Posted on Jul 10, 2009
have the same problem with mine.The relay is behind the panel on the passenger side down where the heater is.There are 3 relays in the same spot.The magnectic relay was the top one on mine.I replaced it but clutch still did not engage.
Posted on Aug 01, 2009
Firstly, you need to remove the rear splash shields from within the rear wheel arches and also the tail lights. Then remove the scrivets from the lover edge of the bar. Next remove the scuff plate at the boot opening and fold the carpet back. There are four nuts which hold the bar on, undo these and then lift the sides of the bar up and pull out. The bar has large clips on the side which hold it in place.
Posted on Aug 22, 2009
SOURCE: ba falcon heater
Just had the same thing happen to my BA. No hot air. I'm a bit of a handyman so I had a go myself. 8 Hours is a reasonable estimate. You have to remove the steering column and entire dashboard to get the bugger out. Not a job I would attempt again.
Posted on May 01, 2010
Tips for a great answer:
Jan 01, 2017 | Cars & Trucks
Mar 11, 2016 | Cars & Trucks
Jan 27, 2016 | 2005 Ford Falcon 4.0
Mar 14, 2015 | Cars & Trucks
Feb 10, 2014 | 2005 Ford Falcon 4.0
Jan 01, 2013 | Cars & Trucks
Apr 08, 2012 | 2005 Ford Falcon 4.0
Mar 02, 2012 | 2005 Ford Falcon 4.0
Dec 19, 2010 | Ford Futura Cars & Trucks
May 24, 2018 | Fiat Cars & Trucks
148 people viewed this question
Usually answered in minutes!