Question about 1996 Cadillac DeVille

3 Answers

Licence light replacement 1996 Cadillac Deville

How do you replace the lincense plate light bulb on a 1996 Cadillac Sedan Deville? We realize that it is a sealed beam bulb, but we can not figure how to get it out. Do you have to disassemble the panel that houses the reverse lights and holds the license plate?

Posted by on

3 Answers

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

Remove your license and behind it you will find i think two screws then remove that panel and you should be able to get to it.

Posted on Jan 29, 2009

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

You cannot reach ,or access the lincense plate bulb by going through the trunk .

Posted on Sep 10, 2011

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 3,533 Answers

Open the trunk right behind the panel there should be access to get to the bulb

Posted on Jan 22, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the fuse for the liscence plate bulb on a 1994 Cadillac sedan deville


There isn't one. It is tied into the parking lights. Bad bulb, socket, or wires.

Aug 04, 2015 | Cadillac Cars & Trucks

1 Answer

Replace the license plate light bulb-'99 cad DeVille


Hello,

Please follow the instructions below carefully to change the bulbs in the licence plate of your cad deville;
1.All you have to do is put a flat blade screw driver on the right side of the bulb housing and gently push to the left. This will release the catch holding it in and it will drop out and down on the end of its wiring connector.

2.1/4 turn the bulb and remove. Replace the bulb and just put the housing back into the opening left side first, then just push up on the right side till you hear a click. Takes about 1 min per light. Works for all Deville types from 99-08

Good luck.

Aug 12, 2010 | 1999 Cadillac DeVille

1 Answer

How do you replace brake light 1996 cadillac deville


Ok, get a t15 torx bit screw driver and remove the rear red light assembly by removing the outline plate that holds it in place.

Pull out the assembly rearward, and then determine which bulb is out by having someone operate the brake.

The sockets are generally removed from the back of the red lense by depressing a tab and rotating counterclockwise.

Remove the bulb, by turning and then pulling out the bulb.

Installation is the reverse of the removal procedure.

Apr 23, 2010 | 1996 Cadillac DeVille

1 Answer

Emission problem 1996 sedan deville


I would suggest checking your Oxygen sensor which will light up your service emission light. Check that and let me know Good luck

Dec 28, 2009 | 1996 Cadillac DeVille

1 Answer

Interior dome lights wont activate wh en doors


If none of the interior door lights work, check the fuse, and check the bulb. If they are both ok, then you may have a bad relay or switch but you will have to trace the wiring which is a pain.

Sep 16, 2009 | 1996 Cadillac DeVille

1 Answer

1996 cadillac sedan deville blinker stoped blinking


I assume all lamps are tested to be ok.
1) Check fuse A11 in trunk (10A) is ok,
2) Check turn flash enable relay 'F' in trunk is operated when vehicle Ign on,
3) Check +12V is present on Lt Blu wire on turn flasher module (LHS steering column) when Ign on,
4) if no fault found during above checks, operation of the turn switch should be checked

Find more information about Cadillac Deville Concours Wiring Diagram and Electrical System Schematics here. (v8mr2.com)

Jul 22, 2009 | 1996 Cadillac DeVille

1 Answer

Having problems getting access to my license plate bulbs to replace them


  • well for this you will have to remove the whole license plate holder, first you will need to remove the licence plate and locate & remove the four screws that are holding the part after that you will have to locate about five other screws located inside the trunk then you can remove the part bottom first and you will have acces to the license plate lights and reverse lights.

Apr 26, 2009 | 1995 Cadillac DeVille

2 Answers

License plate bulb on 1997 Cadillac deville


this is straight out of the book ok



  1. Open the rear compartment lid.
  2. Remove the rear compartment lid trim.
  3. Pull back on the rear compartment trim panel.
  4. Unplug the lamp connector from the rear compartment lid wiring harness.
  5. Press the grommet out of the rear compartment lid.
  6. Remove the nuts retaining the lamp assembly to the rear compartment lid.
  7. Remove the bulb.

Mar 07, 2009 | 1997 Cadillac DeVille

1 Answer

Licence light replacement


Remove license plate, remove screws and detach license plate pocket assembly. Rotate bulb holder, pull bulb straight out and replace.

Jan 22, 2009 | 1996 Cadillac DeVille

Not finding what you are looking for?
1996 Cadillac DeVille Logo

594 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...