Question about Subaru Cars & Trucks

Open Question

2004 subaru forester alarm reset

Reset alarm

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: 2004 Subaru Forester

If the '04 has the same setup as the '00, then there should be a switch on the top of the steering column that will turn the parking lights on or off even if the key is removed. Hope this helps.

Posted on Feb 16, 2009

Ad
emissionwiz
  • 76846 Answers

SOURCE: My 2005 Subaru Forester's alarm system is going

yes a low or defective battery will cause the alarm to go off, if the battery was low chances are it is starting to fail, replace it before it strands u..

Posted on May 08, 2009

  • 1348 Answers

SOURCE: How do I reset factory alarm on a 2000 Subaru

you HAVE to get a remote and unlock the car.the dealer may be able to turn it off with the obd2 system,you have to call subaru.

Posted on Jul 13, 2009

  • 119 Answers

SOURCE: subaru forester heater

take back to the dealer,hopefully the will find that the blend door cable is off or not adjusted properly

Posted on Jul 14, 2009

motor1258
  • 6674 Answers

SOURCE: 2004 subaru forester, 99,000 miles. Check engine

Drop in to an Autozone, or Pep Boys, or similar big parts store & they will usually scan for codes free. This will hopefully eliminate all the guess work, or at least point everyone in right direction for better diagnosis. If not obvious from codes what the problem is, get back to us and we'll help you out.

Posted on Aug 23, 2009

Testimonial: "Thanks for the great suggestion . I'll have Autozone read the codes on Monday. Thanks again!"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2004 Subaru forester turns over but won't start. Battery is fine, replaced coil pack still no luck


you need to check for fuel pressure next.
Could be many things, but a fuel pump or fuel pressure regulator would be prime suspects.

Dec 28, 2016 | 2004 Subaru Forester

1 Answer

How to replace rear differential carrier bearing without removing differential?- 2004 subaru forester


I can't see how that is possible given what needs to be removed to access the bearings. The rear diff is not very difficult to remove from the car

Aug 09, 2014 | 2004 Subaru Forester

1 Answer

2004 subaru forester battery keeps going dead, the only thing I see on is the alarm light


You have a voltage draw. Usually something like a trunk light, interior light, or glove box light.
If you can use a meter or a test light...disconnect your battery ground, and put the light or meter between the cable end and the battery. A normal draw will be a very slight light of the bulb, or a small milli-amp reading. A big draw will give a bright light or higher amp readings, so now you remove fuses, one at a time to break it down to what may be causing the draw.

Aug 17, 2009 | 2004 Subaru Forester

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

61 people viewed this question

Ask a Question

Usually answered in minutes!

Top Subaru Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6924 Answers

Are you a Subaru Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...