Question about 2001 Dodge Stratus

1 Answer

Blower stopped in 2001 Dodge Stratus

Blower just stopped working for heat

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.


    An expert that got 20 achievements.


    An expert that got 10 achievements.

  • Dodge Master
  • 45,403 Answers

Check fuse. If ok there are resistors in the blower housing that give the different speeds to the motor when you select speeds at the switch. They regularly fail (burn out)

Posted on Jan 13, 2013


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 494 Answers

SOURCE: Where is the Blower motor resistor located in a

Since this resistor get hot as it does it's job it needs to be cooled. Usually it is below or behind the glove box, has three or four wires to the unit and is screwed to the air box, two or more screws......

Posted on Feb 13, 2010

  • 1 Answer

SOURCE: 99 dodge intrepid blower motor not working

No. Pull out right front inner fender well cover and motor is on firewall. Four bolts max.

Posted on Mar 03, 2009

  • 2 Answers

SOURCE: Blower Motor Resistor - 2001 Dodge Grand Caravan

I had the same thing happpen with mine. The unit is located behind the glove box and is just left of the fan held in place with two screws. I bought a new resistor from radio shack and installed it in the unit.

Posted on Jun 06, 2009

  • 6918 Answers

SOURCE: My 2001 dodge durango - blower does not work on high

Yes there is a high blower motor relay just for that speed.It may be mounted near the blower motor,behind the glove box,or under the hood.

Posted on Sep 23, 2009

  • 6982 Answers

SOURCE: what would cause the heater blower motor resistor

If you have a poor ground on the blower motor or very worn blower itself, it can cause the resistor to become hotter than it was designed for. Less common causes are restriction in air flow in the heater box (resistor is air cooled) or gross overcharge condition from a bad regulator.(generally this would show up in other powered components as well though)

Posted on Nov 18, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My 2010 Dodge Avenger the blower was only working on the to low and medium prop mob up with penny work for a while to penny fell out won't work now

2009 dodge avenger blower motor works on low, medium ...
Nov 2, 2013 - 2009 dodge avenger blower motor works on low, medium low,medium high but not high. Resister has ... SOURCE: Dodge 2001 Stratus - A/C fanonly blows on High ... working. Jan 04, 2010 ' 2003 Dodge Durango · 1 Answer ...

Oct 29, 2015 | Dodge Cars & Trucks

1 Answer

2002 Dodge Stratus heat/air blower motor only runs on high #4 setting

this is an indication that the blower motor resistor is bad and needs to be replaced. the system is designed to always work on high if the resistors go bad.

Nov 02, 2014 | 2002 Dodge Stratus

1 Answer

Where is located the fan speed control stratus 01

Could be your blower motor resister,it's located by blower motor,easy to remove.Click here to see blower motor resistor.

Dec 26, 2012 | 2001 Dodge Stratus

1 Answer

How do you take the dash apart on 2001 dodge stratus ? the fan blower has stopped working and i was told there is a relay under the dash.

dont really have to take the whole dash apart, its on the passenger side above the footwell area it is a blower motor resistor attatched to the housing not too aweful far from your blower motor

Jul 26, 2010 | 2001 Dodge Stratus

1 Answer

2001 Dodge Stratus SE Heater

Replace the Blower Motor Resistor.It will be located in or near Blower motor box.

Jan 18, 2010 | 2001 Dodge Stratus

1 Answer

Hvac control

It sounds like the blower resistor has gone bad and also check your fuse and relay to the blower. When the resistor go's bad it's a direct feed to the 12 volt junction box under the hood and if the blower stop working the fuse or the relay has gone bad. At worst the resistor and blower motor needs to be replaced. You can buy both at Auto Zone and they will have the step by step instruction to get the job done with common tools. Good luck and keep me posted, be glad to answer any questions you may have friend. 

Jul 02, 2009 | 2001 Dodge Stratus

1 Answer

Fan not blowing heat out

I have a 2001 Dodge Stratus.... the same exact thing happen to me. First it only worked on high #4 and then it stopped all together. I just fixed it today. It is the BLOWER MOTOR RESITOR. I actually changed it myself. It is inside the car under the glove box. There is a little cover you can take off. You will need a tool to take off the 2 screws once the cover is off. And then unplug the old one and install the new one. Really easy. The RESISTOR will cost you about 40 bucks.

Feb 05, 2009 | 2001 Dodge Stratus

2 Answers

98 dodge stratus no heat and temp. gauge dosen't move

thermostat is stuck open replace it and it should work

Jan 22, 2009 | 1998 Dodge Stratus

3 Answers

Heater switch only has hi speed

This was wrong with my 01 Stratus and it was the blower motor. Between the part and the labor to have it fixed, it was around $130.

Nov 26, 2008 | 2001 Dodge Stratus

3 Answers

A/c on Dodge Stratus

Just had the same problem with my 2001 dodge stratus the blower motor was squeling really loud had to replace that then it only worked on 4 also first it was 3 and 4 then only 4. It actually was the blower motor resistar. If you do replace this it has a TSB(Technical Service Bulletin) Your going to have to opening the opening of the resistar a little bit more to get it in. Actually just replaced it today and now all the speeds work.

Jun 09, 2008 | 2001 Dodge Stratus

Not finding what you are looking for?
2001 Dodge Stratus Logo

141 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts


Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6918 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides