Question about Ford Cars & Trucks

Open Question

Wiring diagram for 2003 Ford Windstar - Ford Cars & Trucks

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Molson02536
  • 3854 Answers

SOURCE: installing chip and want to double check wiring. Need to find IAT/MAF sensor diagram for 2003 Ford Ranger

Save your money, the chip is a ohm resistor at Radio Shack for under $2.00. It splices in to you IAT wire harness located at the intake tube between the air filter housing and throttle body.
Problem with this system is, that you can not adjust anything and have to run a constant 91 octane just to make sure you do not have a Detonation. The ECM will catch the Detonation from the knock sensor and compensate for it by retarding the timing which in turn lose of HP till next start up.
If you like and don't mind the check engine light on once and awhile, you can do the same by just disconnecting the IAT wire harness which give the ECM a 0 resistance thinking it's -20 out side and turn the timing up and lengths the injector pules.
When i was running a Nitro in the Toy before i sold it, i had installed a 10K ohm Potentiometer which you can buy at radio shack for under $5.00 i believe, I just spliced it in to the IAC wire harness so if i wanted to play with the Nitro I'ld turn the resistor up making the engine think it's 185 degrees F and would ****** the timing so i would not hurt the engine. But if i wanted to get more timing i would just turn the knob to drop the resistance to get more time since the engine thinks it's -20 out side.
Hope this helps. Keep me posted if you need more info. Best thing is to do a dyno tune and you can change everything right down to the Shift points.

Posted on May 29, 2009

smartr10U
  • 1305 Answers

SOURCE: need wiring diagram for 2001 ford windstar radio

2001 Ford Windstar Car Stereo Radio Wiring Diagram
Car Radio Constant 12v+ Wire: Green/Violet
Car Radio Switched 12v+ Wire: Yellow/Black
Car Radio Ground Wire: Black/Light Green
Car Radio Illumination Wire: Green
Car Stereo Dimmer Wire: N/A
Car Stereo Antenna Trigger: N/A
Car Stereo Amp Trigger Wire: N/A
Car Stereo Amplifier Location: N/A
Front Speakers Size: N/A
Front Speakers Location: N/A
Left Front Speaker Positive Wire (+): Orange/Light Green
Left Front Speaker Negative Wire (-): Light Blue/White
Right Front Speaker Positive Wire (+): White/Light Green
Right Front Speaker Negative Wire (-): Dark Green/Orange
Rear Speakers Size: N/A
Rear Speakers Location: N/A
Left Rear Speaker Positive Wire (+): Light Brown/White
Left Rear Speaker Negative Wire (-): Light Brown/Yellow
Right Rear Speaker Positive Wire (+): Light Brown/Green
Right Rear Speaker Negative Wire (-): Brown/Pink

Posted on Sep 12, 2009

gandergmm
  • 145 Answers

SOURCE: wiring diagram for ford windstar 1998

i assume its a 3.8L
http://host-comp.com/281774/va102115.pdf

Posted on Sep 30, 2009

  • 176 Answers

SOURCE: need free wiring diagram ford windstar 1999

Your local Napa parts store can print you out the wiring diagrams. There are alot....., so narrow down which ones before you ask.

Posted on Nov 08, 2009

ZJLimited
  • 17970 Answers

SOURCE: i need a picture or a diagram of a 2003 ford

2003 FORD WINDSTAR - V6 3.8L 232ci GAS FI N 4

Belt Routing Diagram Multiple Accessory, w/A.C.
80154fa.jpg

Hope this help (remember rated this post).

Posted on May 15, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Backup lights are 12 volt constantly, so how do I install my backup camera that only needs 12 volt when put in reverse. 2003 Ford Windstar SEL


All I can do is give you access to the wiring diagrams at this site and you can look up the best place to wire in the camera. http://bbbind.com/free_tsb.html

Dec 03, 2016 | 2003 Ford Windstar

1 Answer

I need a radio wiring diagram for a 2003 ford windstar


Which diagrams do you need?...if it is to install an aftermarket deck, get an adapter so u dont cut into the factory wiring harness..the adapter plugs into the factory plug and allows u to solder the aftermarket radio wires to the other side of it.I have attached a link to where u can get the adapters...unfortunatly this wont allow me to send u my radio schematics that are in PDF format.
Car Stereo Installation Parts for2003 FORD WINDSTAR

Mar 08, 2015 | 2003 Ford Windstar

1 Answer

I need a wiring diagram for 2003 ford windstar


Go to the URL posted, create an account (its free) then add the Windstar as "my vehicle"..after thats done, click on left side where it says "vehicle repair guide" and when that pops up, scroll down to wiring diagrams...if that doesnt work, go to Advance Auto or Autozone and you should be able to get the diagrams and print them off. (I use Part Source up here in Canada)
Save 20 On Online Ship To Home Orders Of 100 Or More

Mar 08, 2015 | 2003 Ford Windstar

1 Answer

Need wiring diagram for 2003 ford windstar radio


We don't have wiring diagrams available due to copyrighting. You can access the factory wiring diagrams here.

Oct 10, 2012 | 2003 Ford Windstar

1 Answer

2003 ford windstar fuse box diagram, ecm fuse


On this website, you find fuse box diagram and description for Ford Windstar 2003

Ford Windstar Second Generation mk2 2003 fuse box diagram Auto Genius

Aug 30, 2010 | 2003 Ford Windstar

1 Answer

I need a picture or a diagram of a 2003 ford windstar serpentine belt


2003 FORD WINDSTAR - V6 3.8L 232ci GAS FI N 4

Belt Routing Diagram Multiple Accessory, w/A.C.
80154fa.jpg

Hope this help (remember rated this post).

May 15, 2010 | 2003 Ford Windstar

1 Answer

I need the serpentine belt routing diagram for a 2003 ford windstar


Click on the following free direct Link. It has the correct Serpentine Diagram for your 2003 Ford Windstar 3.8L V6.

Let me know if this helped, or if you have additional information questions. Feel Free to contact me at FixYa.com!

http://www.2carpros.com/car_repair_information/year/2003/make/ford/model/windstar/2003_ford_windstar_drive_belt_routing_diagram.htm

Apr 10, 2010 | 2003 Ford Windstar

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

103 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5471 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...