Question about 2005 Jaguar S-Type

Open Question

Sun shade removal on jaguar s type

How to remove and replace the Sunshade (sunroof shade) without dropping the headliner on a 2005 jaguar s- type?

Posted by on

  • Bill Jan 15, 2013

    Basically, is it possible to remove the sunroof shade without dropping the headliner? If so, what are the basic steps?

×

Ad

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1986 Answers

SOURCE: remove rear door panel on x type jaguar

You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door

Posted on Aug 14, 2009

Ad
  • 1810 Answers

SOURCE: how to replace headlight bulb on a 2003 jaguar s

push bar clip towards light it is on a hang up bracket one you press in then you push left then right 1 way or the other will pop the clip

Posted on Jan 06, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Sunvisor removal on 2002 envoy


Here is a parts source. http://www.justparts.com/buy/parts/Query/?q=gmc+envoy+sun+visor

The following are GM directions.

1. REMOVE THE WINDSHEILD GARNISH MOLDING.

2. RELEASE THE FRONT ASSIST HANDLE FROM THE HEADLINER. (TO DO THIS YOU MUST POP OFF THE COVER ON EITHER SIDE AND YOU WILL SEE A RETAINER CLIP ON THE OUTER EDGES OF EITHER SIDE. INSERT A SMALL PICK OR FLAT HEAD
SCREW DRIVER AND PRESS THE CLIP TOWARDS THE INSIDE OF THE HANDLE. THEN PRESS THE END OF THE HANDLE OUTWARD AND PULL IT SHOULD RELEASE.)

3. RELEASE THE UPPER PORTION OF THE CENTER PILLAR TRIM PANEL

. 4. OPEN AND ROTATE THE SUNSHADE PARALLEL TO THE SIDE WINDOW.

5. INSERT A SMALL TOOL INTO THE BEZEL ACCESS HOLE.

6 PUSH UPWARD ON THE TOOL WHILE ROTATING
THE SUNSHADE PARALLELL TO THE WINDSHEILD. THE SUNSHADE PIVOT ARM BEZEL SHOULD APPEAR TO BE RECESSED INTO THE BEZEL.

7. APPLY OUTBOARD PRESSURE TO THE SUNSHADE WHILE THE SUNSHADE IS PARALLEL TO THE WINDSHEILD.

8. PULL THE SUNSHADE DOWNARD WHILE MAINTAINING OUTBOARD PRESSURE TO THE SUNSHADE. YOU WILL NOTICE A SEPARATION BETWEEN THE HEADLINER AND THE SUNSHADE BEZEL.

9. IN ORDER TO REMOVE THESUNSHADE FROM THE HEADLINER, CAREFULLY GRAB THE HEADLINER AT THE WINDSHEILD PILLAR AREA AND APPLY DOWNARD PRESSURE WHILE GENTLY ROCKING THE SUNSHADE UP AND DOWN.

10. REMOVE THE INBOARD RETAINER SCREW.

11. REMOVE THE INBOARD RETAINER FROM THE HEADLINER.

12. IF THE VEHICLE IS EQUIPPED WITH LIGHTED SUNSHADES REMOVE THE ELECTRICAL CONNECTORS FROM THE HEADLINER Take off the two front plastic pieces located at the front of the rails and slide the cross bars off.

You unscrew the two bolts and gently take the visor off the mount. There will be a wire attached that has a plastic male/female connection that can be pulled apart. Do this gently. The wire is the power connection for the vanity light located within the visor.

Jun 14, 2017 | Cars & Trucks

2 Answers

How to install replacement sunroof motor on a 1999 Pontiac grand prix


Important: This sunroof system is timed from the factory in order to allow the actuator to shut off automatically when the sunroof window reaches a certain position. Use extreme care when removing the actuator from the sunroof module. This may cause the timing to be thrown off. This may damage to the sunroof. Anytime the actuator needs to be removed from the module, ensure that the sunroof window is in the fully closed position.
Remove the sunroof window. Refer to Sunroof Glass Panel Replacement .
Slide the sunshade fully rearward. Move the sunroof window to the vent position. Remove the sunroof screws (two on each side). Remove the sunroof window from the module.
Place the sunroof module in the fully closed position. Remove the headliner. Refer to Headlining Trim Panel Replacement in Interior trim.
Tools Required ?€¢
J 38778 Door Trim Pad and Garnish Clip Remover


?€¢
J 2772-C Headliner Installer

  1. Remove the sunshades. Refer to Sunshade Replacement .
  2. Remove the overhead console, if equipped. Refer to Roof Console Replacement .
  3. Remove the sunshade retainers. Refer to Sunshade Anchor Replacement .
  4. Remove the power sunroof switch, if equipped. Refer to Sunroof Switch Replacement in Roof.
  5. Remove the sunroof trim lace, if equipped. Refer to Sunroof Seal/Molding Replacement in Roof.
  6. Remove the dome light, if equipped.
  7. Remove the coat hooks. Refer to Coat Hook Replacement .
  8. Remove the assist handles. Assist Strap Replacement
  9. Remove the rail lamp. Refer to Roof Side Rail Lamp Replacement in Lighting.
  10. Remove the windshield side garnish molding. Refer to Windshield Pillar Garnish Molding Replacement .
  11. Remove the upper quarter trim panels. Refer to Rear Quarter Upper Trim Panel Replacement .
  12. Remove the center pillar upper trim panel. Refer to Center Pillar Upper Trim Panel Replacement .
  13. Pull down on the door opening weatherstrip seal on both the front and the rear doors.
  14. Remove the 2 rear retainers (2) using J 38778 Door Trim Pad and Garnish Clip Remover. Disconnect the headliner electric harness at the right side of the rear window shelf. Rotate the right front seatback to a horizontal position. Remove the headliner from the vehicle through the right front door.
Disconnect the electrical connector from the actuator.
Important: Before removing the actuator, ensure that the pins J 41718 are tight and holding the cable.
Thread the J 41718 into the front sunroof window screw hole in order to retain the cable adjustment. Remove the sunroof actuator screws. Remove the sunroof actuator from the module. Did you look for a video on youtube ?

Feb 27, 2015 | 1999 Pontiac Grand Prix

1 Answer

2002 Bonneville Sunroof. Fabric on sunshade was loose, was able to pull shade forward, glued fabric but the shade will not go back. Seems to be hitting something in the back. Can you help?


Hi


Inspect the sun roof of your Pontiac Bonneville to make sure it's seated evenly on your vehicle, not raising or lifting at one corner. Lifting indicates the presence of debris on the tracks, or a damaged seal around the sun roof.

Remove the trim on the interior of your Pontiac Bonneville and allow the interior material to drop. Use compressed air to blow dust and debris from the tracks that move your sun roof. Treat the tracks using 3-In-One Lubricant.

Check the Pontiac Bonneville's drain tubes for clogging. Two of these run down the front of your vehicle to the bumpers. Two run to the back, most often by your tail lights. Clear the tubes using compressed air and replace them.

Clean the sun roof's rubber seal with a damp, lint-free cloth. Inspect the seal as you clean


Please get back to us if you have further query else please accept the suggestion.
Thank you for contacting fixya.com



Jul 19, 2011 | Pontiac Bonneville Cars & Trucks

1 Answer

Sliding shade is stuck and won't slide. Glass is down in 1 corner, not flush with roof


the shade may be related to sunroof not closeing completely, the most common reason is the track is broken , this is the most common reason for when the sun roof doesnt close or jams when opening or closing its always the track breaks, the way to check this is to easy the headliner needs to be dropped and removed and then the glass from sunroof removed then unbolt track and drop down into car and check the track linkage and arms and track and see whats broken, note there are no replacement parts only motor or cable, as far as the parts that always break like an arm on the track this is not replaceable the track needs to be replaced, hope this helps , good luck.

Feb 06, 2011 | 2005 Chrysler 300

1 Answer

Sun roof won't open, but i hear the motor turning


Check for any obstruction in the rail.

Also, can check this procedure to test your components...
Power Sunroof - REMOVAL & INSTALLATION (click over pic for zoom)

Motor
See Figure 1
  1. Remove the sunroof switch panel by pushing it to the side and disengaging the pawl, then pulling it downward.
b5908ae.jpg

Fig. 1: The sunroof switch panel is retained by a metal clip
  1. Remove the sunroof switch bracket.
  2. Unplug the sunroof motor wiring harness connectors.
  3. Remove the sunroof motor mounting screws.
Disassembly of the sunroof motor is not recommended.

To install:

  1. Lightly lubricate the drive gear with grease and install the sunroof motor to the sunroof assembly.
  2. Plug in the electrical harness connectors to the sunroof motor.
  3. Operate the sunroof to verify proper operation.
  4. Install the sunroof switch bracket and the sunroof switch panel.

Sunroof
See Figures 2 and 3

abc86a3.jpg

Fig. 2: Exploded view of the sunroof assembly on 1993-94 vehicles

515e4a7.jpg

Fig. 3: Exploded view of the sunroof assembly on 1995-97 vehicles-1998 models similar
  1. Tilt up the sunroof lid.
  2. Remove the lid side trim.
  3. Remove the lid bolts and the lid assembly.
  4. Remove the rear drain mount screws and the drain.
  5. Remove the shade assembly holders from the sunroof frame.
  6. Remove the shade assembly.
  7. Remove the sunroof switch, interior accessories and headliner.
  8. Remove the switch bracket.
  9. Remove the motor assembly, spacer and clip.
  10. Remove the wind deflector mount holders from the sunroof frame.
  11. Remove the wind deflector.
  12. Disconnect the drain hose.
  13. Remove the sunroof brackets.
  14. Remove the sunroof frame assembly.
  15. Remove the link and wire assemblies.
To install:
  1. Tilt up the sunroof lid.
  2. Install the link and wire assemblies.
  3. Install the sunroof frame assembly.
  4. Install the sunroof brackets.
  5. Connect the drain hose.
  6. Install the wind deflector.
  7. Install the wind deflector mount holders on the sunroof frame.
  8. Install the motor assembly, spacer and clip.
  9. Install the switch bracket.
  10. Install the sunroof switch, interior accessories and headliner.
  11. Install the shade assembly.
  12. Install the shade assembly holders on the sunroof frame.
  13. Install the rear drain mount screws and the drain.
  14. Install the lid bolts and the lid assembly.
  15. Install the lid side trim.

Hope helps (remember rated this help).

Jun 03, 2010 | 1996 Nissan Maxima

1 Answer

95 GRND CHEROKE sunroof supports have come loose and it leaks.


The bigest problem with this model jeep sunroof is the cable conduit in the rear of sunroof is broken loose. can be accesed by removing the headliner. But the tracks are accessed from the sunroof opening after removing the glass. the part department at the dealership can give you a breakdown basicly the only replacable parts are the tracks, Price about $200.00 each.

Oct 03, 2009 | 1995 Jeep Grand Cherokee

1 Answer

Headliner on sunroof cover needs repair


No you do not have to drop the headliner!! Remove the glass and it comes out through the opening. Before you recover the sunshade you must sand the rubbery messy layer that the germans coat the piece with or you will never get the glue to hold for very long.

Aug 22, 2009 | 2000 Mercedes-Benz S-Class

1 Answer

The sliding panel under my sunroof is broke. Any suggestions? The Sunroof motor is working.


The sunshade clips are probably broken. Need to remove the glass panel. Note the position of the panel the frt and the rear. If not properly reinstalled you might get wind noise. Once you have the panel removed unscrew the clips from the sunshade. Carefully remove the shade and install the new clips.

May 26, 2009 | 2002 Volkswagen Jetta TDI

1 Answer

1998 Audi A6 sunroof is will close only half way.


make it go back to the open position,look down the side of the tracks in the roof that the sun shade slides in and you will probable find the guides for the sunshade are jamming up the tracks. only way to replace them<4 one in each corner> is to remove the glass section and then close sunshade that will give access to the 4 guides which are available from dealer as a kit

Mar 24, 2009 | 1996 Audi A6

Not finding what you are looking for?
2005 Jaguar S-Type Logo

Related Topics:

283 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jaguar Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

yadayada
yadayada

Level 3 Expert

76682 Answers

SPEEDY CAR WORK SHOP...

Level 2 Expert

489 Answers

Are you a Jaguar Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...