Question about 2006 Chevrolet Equinox LT
Causing water to get in dashboard on driver n passenger side..n causes my reduce power light n traction control light to come on..
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
It is either condensation water from the A/C unit that should go out a drain tube to the outside (only if A/C or Defrost is on) or a leaky heater core. If it is a heater core you can usually smell a coolant smell and the water will be warm and your windows will fog up inside. Heater core is more common. Joe ASE Master Tech
Posted on Mar 05, 2009
2004 TB 60,000 miles. i was just told that the leaking fluid in my passenger side floorboard was do to a clogged up A/c hose. An A/C works by drying/ removing the moisture from the air inside the vehicle and cooling it. The accumulated fluid is usually evacuated under the vehicle which is what you see when people are stopped at a red light and there is dripping under their car. when a hose is blocked there is a vent that from some reason flows directly into the passenger side floor board. If you can not manually knock loose the block your probably going to have to take it to a mechanic.
Posted on Jun 14, 2009
Because the brakes were changed, either one of the sensors were broken when removing brakes or it has set a code. Go to your local autoparts store and have them reset the code. See if it comes back on. If it does you will need to look at the ABS sensors on each wheel and replace if damaged
Posted on Sep 29, 2009
SOURCE: reduced engine power on
The traction control uses the speed sensor in the transmission and the wheel speed sensors to determine wheel spin. If a wheel spins braking is applied to it so that the power can be transferred to the other wheels. At some point the ECU detected a gross disagreement between the sensors and so as a precaution has entered into a limp home mode. On some systems if the fault is in error it can be cleared by putting the car into drive and moving forward a meter, putting in reverse and going a back a meter and doing this three times. If one or other of the sensors are faulty this process will not allow the error to be cleared. You need to check or have checked the error codes and the speed sensors.
Posted on May 28, 2010
Tips for a great answer:
Nov 27, 2017 | Cars & Trucks
Jan 23, 2013 | 2005 GMC Canyon Crew
Dec 25, 2010 | 2006 Chevrolet Equinox
Sep 07, 2010 | Chevrolet TrailBlazer Cars & Trucks
May 10, 2010 | 2005 Chevrolet Colorado
Jul 03, 2009 | 2005 Pontiac Grand Prix
Sep 26, 2008 | 2006 Chevrolet Equinox
36 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: