Question about Cars & Trucks

1 Answer

1994 chevy 1500 just rebuilt wont shift past second gear

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 17 Answers

Check kick down is adjusted properly

Posted on Jan 12, 2013

  • 1 more comment 
  • joshua_satte
    joshua_satte Jan 13, 2013

    nope not that

  • joshua_satte
    joshua_satte Jan 13, 2013

    yeeah i can go from first to second manually when i put it in od it revs up i had it rebuilt and it was taken out of the truck and hooked up and it worked properly when iit was put back in same thing! i have replaced speed sensors tps sensor brake switch

  • joshua_satte
    joshua_satte Jan 13, 2013

    the tranny is a 4l60e thought it didnt have a govenor it was electronic

×

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
csmock132
  • 4669 Answers

SOURCE: Transmission won't shift!

Does it just not shift up to 3rd or when it shifts to 3rd it is just like neutral?

Posted on Mar 06, 2009

CHOPSHOP317
  • 3 Answers

SOURCE: 1988 Chevy truck

VACUMN LINE FROM YOUR MOTOR TO TRANS

Posted on Feb 11, 2009

  • 67 Answers

SOURCE: my 1994 ford econoline van is not shifting gears

Hello.
This a repair for a transmission shop. Sounds like the pumps are bad inside the transmission. Thats the worst option I have.
It also can be a poor shift linkage adjustment. And the last solution can be the speed module that tell the transmission when to shift.
Goodluck! I hope this helps!

Posted on Dec 07, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

94 chevy k1500 wont shift past 2nd gear.


its possible the shifters linkage is bent

Mar 17, 2010 | 1994 Chevrolet K1500

1 Answer

My transmission slips going through second gear if i get my foot in it just a little bit, and it doesnt always go into reverse. if i shift into reverse and it doesnt shift, i have to shift to neutral then...


this problem is a common failure associated with your shift solenoinds inside your tranny. of course a shop is not gonna tell you this because by the time you wanna get it repaired it is usually too late and have already cause damage to your clutch pack and internal parts, thats the main reason why a shop wont mess with just replacing your shift solenoid (aka valve bodie)

Feb 18, 2010 | 2000 Chevrolet Silverado 1500

1 Answer

My 94 chevy 1500 may or may not shift into drive


Is your trany full of fluid ? Has it been leaking at all ? May need a kit

Feb 03, 2010 | 1994 Chevrolet K1500

1 Answer

I have a 95' 1500 chevy pickup ... Cluster issue


sounds like you may have a problem with your speed o gear in trans.

Dec 11, 2009 | 1994 Chevrolet K1500

1 Answer

My 1994 chevy 1500 wont go into gear, i can move the shift lever around but it acts like its in park. it happend this morning, i backed out of my parking spot then shifted into park for a second, after...


Soounds like the shop that did the work did not install the shift cable back onto the transmission fullky and it popped off. Look under the truck, drivers side, and you may see a cable dangling. If so that needs to be reconnected to the post on the transmission shift selector on the transmission.it should pop on with a solid push.

Jul 17, 2009 | 1998 GMC Sierra

1 Answer

Transmission doesnt seem to engage, no drive indicator on column


I would take it back to the person that rebuilt it and make them fix it again or get your money back if you can

Jan 20, 2009 | 2000 Chevrolet Blazer

1 Answer

Transmision wont shift out of 2nd gear


Maybe, but won't know till you take it too tranny shop. Even iif it is done a rebuilt is still cheaper than brand new. And, less you drive it now less damage done.

Dec 29, 2008 | 2000 GMC Sierra

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

30 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

79851 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

john h

Level 3 Expert

14331 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...