MY 91 CAMRY STANDERED DIED WEN I WAS TRYIN 2 GET IT OUT THE SNOW
I GOT STUCK IN THE SNOW N WAS ROCKING THE CAR 2 GET OUT THE RPMS DIDNT EXCEDE 6000 N THE CAR JUST DIED. IT WILL TURN OVER BUT WNT START I THOUGHT IT WASNT GETEN GAS SO I PUT DRY GAS IN IT N TRYED STARTEN IT WIT STARTER FLUID IT TRYED 2 START BUT JUST DIED
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Lamp failure sensor it sit in thetrunk next or the hinge
the harness falls down and gets stuck and short out the
wire harness repair harness replace little yellow box
it start with 89373 ,make sure you have the the right
sensor easy to locate please reply let me know if
that helps thank you
not sure what to tell you without seeing it for myself so all i can do is give you some ideas to check,make sure you dont have a rock or rocks stuck up front by your axles,also if you have been driving through heavy snow it could be froze up front,if you had a warm garage to push it into to check these that would help,and if your shifter isnt stuck hopefully your tranny didnt go bad,but check your rack and pinion as well
u should check ur transmission fluid to see if it is dark (burnt) if so ur gonna b outa luck u most likely burnt it up. fluid will also have a strong burnt smell if it is black. trannys build up alot of heat wen trying to get unstuck in snow an ice. diminished air flow through radiator or trans cooler wen stuck also adds more heat to the unit,especially wen running it hard on ice. they get hot really fast
You maybe need to adjust the idle speed, on top of the intake manifold, near where it says EFI, there a small black rubber plug, pull it out, turn off everything in the car, then turn the screw in where the plug was to change the idle speed. Or it could be that you need a new Idle Control Valve