Question about Jeep Grand Cherokee
Cant find the releases to remove the glove box
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
i actually removed my 2 front seats very easily as a novice. There really is only i think 4 bolts that need to come out 2 in front and 2 in back. If i can remember correctly i believe it was a larger metric size. Although i dont have power seats, if you do just look for the clip connector and disengage
Posted on Jul 07, 2008
Fuse # 20, located in the Junction Block (interior, drivers side). This is a ten amp fuse.
Read the information at the above site. The TSB (technical service bulletin) may be of interest to you.
Posted on Nov 20, 2008
You need to remove all the skrews from the door. Normaly there is one in the handle of the door, one behind the in door lach handel and one under the bump out for the arm rest on the door. Than you need to take a flat head skrew driver slowly priying the panel off. There are plastic clips on the backside of the panel it is ok if you brake a few.
Posted on May 01, 2009
yah direct ignition coil pack does away for the need a a distributer cap and rotor.much higher energy ignition system where the computer tell when to fire.if that helps.not hard to change.as long as you change them one at a time so you don't screw up the order.
Posted on Nov 28, 2009
First, if the noise is from the upper part of the engine and is more of a tapping than a knock, likely you have a problem in the valvetrain, most often a bad lifter or worn rocker arm. If the noise is low, deep inside, the noise is from a bearing. This is generally accompanied by lower than normal oil pressure. Regardless of the underlying cause, correcting the cause will not stop the knock. To do that correctly, the engine needs to be removed and all crankshaft bearings and the crankshaft itself need to be replaced (crank can sometimes be "undercut" and thicker bearing shells can be used depending upon the amount of wear.) If caught very early, sometimes only one bearing can be replaced in-car, but in 99% of all cases I have ever seen, most will fail again, sometimes more severely if done this way.
Posted on Dec 10, 2009
Tips for a great answer:
Oct 24, 2013 | 2001 Jeep Grand Cherokee
Sep 11, 2013 | 2001 Jeep Grand Cherokee
Aug 07, 2012 | 1997 Jeep Grand Cherokee
Feb 11, 2011 | 2001 Jeep Grand Cherokee
Oct 19, 2010 | 2001 Jeep Grand Cherokee
Aug 17, 2010 | 1993 Jeep Grand Cherokee
Jan 09, 2010 | 2005 Jeep Grand Cherokee
Sep 03, 2009 | 2001 Jeep Grand Cherokee
Jan 27, 2009 | 1995 Jeep Grand Cherokee
Nov 17, 2008 | 2001 Jeep Grand Cherokee
Jul 17, 2018 | Jeep Cars & Trucks
368 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: