Question about 2002 Ford Escape

Open Question

How to drain radiator on 2002 ford escape - 2002 Ford Escape

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
fknstart
  • 404 Answers

SOURCE: removal of rear brake drum 2002 ford escape

make sure handbrake is off take wheel off hit the drum with a mallet not steel,as it will brake,hit on outter diametter face of drum, try and rotate as you twist off

Posted on Jan 05, 2009

Ad
  • 1150 Answers

SOURCE: Steps to remove radiator in 2002 Ford Escape?

http://www.autozone.com/autozone/repairinfo/common/repairInfoMain.jsp?leftNavPage=productsHowTo&partCode=0900c15280213faa&title=Radiator&targetPage=productInformation
Try this web site. It takes you to Auto Zone "How To" site. This one covers the 4 cylinder as you did not indicate the engine size.

Good luck and hope this helps.

Posted on Apr 20, 2009

chuck943
  • 783 Answers

SOURCE: ford escape 2002 firing order

V6 1-4-2-5-3-6 back bank pasenger side right to left cylinders 1 2 3
front bank passenger side right to left 4-5-6
4 cly 1-3-4-2

Posted on Jun 23, 2009

01fordeb
  • 1033 Answers

SOURCE: Have 2002 Ford Escape, Where's the Radiator Cap??

This is where you fluid goes. If I were you, I would stay away from those sealants. But yes you can put the sealant in the reserve, but it;s best if you drain half the water out, pour in coolant and then re-fill. This gives it a better chance to flow throughout the system. Sometimes these sealants can cause more harm than good in the long run.

Posted on Apr 26, 2010

  • 70 Answers

SOURCE: cruise control ford escape 2002. ford escape

If the cruise lamp comes on and the cruise does not set i would advise inspecting the cruise cable and make certain it is not broken, if ok the the servo has likely failed.

Posted on May 29, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I am having difficulty locating it. I need to know how to locate and replace a thermostat on a 2002 ford escape


Follow the top radiator hose down to where it connects to the engine. You should find a dome shape item or a couple of smaller bolts that attach to the engine to the side of the radiator hose and the thermostat will be inside the housing. You will need to drain the radiator, remove the bolts holding the thermostat housing to the engine and remove the old stat and put in a new one be sure to make note of how the stat is facing when you remove it and put the new one in the same way. then reconnect the thermostat housing making sure the gasket is in place so it won't leak, then refill the radiator slowly so you don't cause an air lock in the radiator, with cap still off start the engine and allow it to warm up until the stat opens and then you will need to add more antifreeze to the system. Double check for any leaks. Turn on the heater and make sure you have good heat and you should be good

Jan 11, 2016 | Ford Cars & Trucks

1 Answer

Replace thermostat '02 ford escape 3.0l


1. Drain the engine cooling system.
2. Remove the air cleaner intake pipe.
3. Release the clamp and disconnect the upper radiator hose from the thermostat housing.
4. Remove the bolts and the thermostat housing.

o To install, tighten to 10 Nm (89 inch lbs.) .

5. Remove the thermostat and the O-ring seal.

o Discard the O-ring seal.

6. To install, reverse the removal procedure.

o Install a new O-ring seal and lubricate it with clean coolant

7. Fill and bleed the cooling system.
25486479-lh4p3qx2aut5mcwq32hs4n0f-5-0.gif

Feb 26, 2015 | 2002 Ford Escape

1 Answer

2002 ford escape xlt location of the transaxle


all drain plugs are closest to the bottom of any drain pan

Sep 21, 2014 | 2002 Ford Escape

1 Answer

Where is horn on 2002 ford escape.


CHECK BEHIND RADIATOR GRILLE.

Jun 12, 2011 | 2002 Ford Escape

1 Answer

How to drain coolant on 2005 ford escape v6


The easy way, remove the lower radiator hose from the radiator while you have the cap off.

Feb 21, 2011 | 2005 Ford Escape

1 Answer

LOOSING ANTIFREEZE FROM MY 2002 FORD ESCAPE AND CAN FIND WERE IT IS GOING. BUT CHECK MY TRANSPISSION FLUID AND IT IS OVER FULL AND IT LOOKS LIKE PINK FOAMY FLUID.


transmission cooler in the radiator seems to be leaking, its a heat exchanger that transfers trans. fluid heat with coolant, ret the rad replaced and and the transmission flushed not just drained and filled cause when you drain a trans you do not empry the torque convertor so have it done my a reputable shop

May 26, 2010 | 2002 Ford Escape

2 Answers

Have 2002 Ford Escape, Where's the Radiator Cap??


This is where you fluid goes. If I were you, I would stay away from those sealants. But yes you can put the sealant in the reserve, but it;s best if you drain half the water out, pour in coolant and then re-fill. This gives it a better chance to flow throughout the system. Sometimes these sealants can cause more harm than good in the long run.

Apr 26, 2010 | 2002 Ford Escape

1 Answer

Oil pan drain plug


The drain plug is on the back side of the aluminum oil pan, your going to have to use a 15 mm socket to remove the oil plug. 
Good luck and here is a link to changing the oil for your escape if your have not done it before. http://fordescapefixit.com/oil.html

May 29, 2009 | 2002 Ford Escape

1 Answer

Steps to remove radiator in 2002 Ford Escape?


http://www.autozone.com/autozone/repairinfo/common/repairInfoMain.jsp?leftNavPage=productsHowTo&partCode=0900c15280213faa&title=Radiator&targetPage=productInformation
Try this web site. It takes you to Auto Zone "How To" site. This one covers the 4 cylinder as you did not indicate the engine size.

Good luck and hope this helps.

Apr 20, 2009 | 2002 Ford Escape

Not finding what you are looking for?
2002 Ford Escape Logo

Related Topics:

77 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

fordexpert

Level 3 Expert

5530 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...