Question about 2005 GMC Yukon
The keyless entry system has the following main components:
• The transmitters
• The passenger door module (PDM)
The PDM communicates with the body control module (BCM) through the keyless entry serial data circuit. When you press a button on a transmitter, the transmitter sends a signal to the PDM. The PDM sends a request to the BCM and the BCM performs the appropriate function.
Posted on Jul 20, 2017
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
I would remove the remote start some cars wont register the remote start with the computer then the computer can do some crazy things its a biglist of problems it can do
Posted on Mar 05, 2009
Have your dealership test the remotes for you, they will also use a "Tech-2" to re-program it and should not charge you to do so. "I know mine does not" The "puddle" lamps come on when you un-lock the doors with the remote."If they are enabled in the options on your dash information center or "DIC". "See owners manual for info on that". As far as the DRL's make sure your bulbs are good because they are known to blow out. But the remote should not have anything to do with those.Hope that helps a little?
Posted on May 05, 2009
1. Close all doors
2. Insert key into ignition
3. Hold down the power UNLOCK button on the driver's door panel, continue to hold down
until instructed to release in step 9.
4. Perform steps 5 through 8 in a fairly rapid succession.
5. Turn the ignition to the ON position (as far as you can go without starting the engine.)
6. Turn the ignition to the OFF position.
7. Turn the ignition to the ON position (as far as you can go without starting the engine.)
8. Turn the ignition to the OFF position.
9. Release the power UNLOCK button on the door panel. The vehicle should respond by
door locks locking and unlocking automatically. (If locks do not cycle after you let go,
not before you let go of the unlock button, then the vehicle has not entered programming
mode and you must start procedure over. Remove key from ignition, open drivers door
and return to step 1 ). If the locks do cycle automatically then proceed to step 10.
10. Hold down the LOCK and UNLOCK buttons on the remote until the doors lock and
unlock. This may take up to 30 seconds.
11. Repeat step 10 NOW for each additional remote. (Including any existing remotes).
12. Turn the ignition to the ON position to exit the programming mode.
13. Test remote(s).
Posted on Mar 06, 2010
Tips for a great answer:
Oct 05, 2016 | 2005 Dodge Dakota
Jul 29, 2014 | GMC Envoy Cars & Trucks
Jan 30, 2014 | GMC Cars & Trucks
Aug 09, 2011 | 2005 GMC Yukon
May 16, 2010 | 2004 GMC Envoy
Apr 23, 2010 | 2007 GMC Yukon Denali
Mar 22, 2010 | 2001 GMC Yukon
Nov 15, 2009 | 2007 GMC Yukon
May 18, 2009 | 2005 GMC Envoy
Jul 26, 2008 | 2002 GMC Envoy
82 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: