Question about Cars & Trucks

Open Question

How to remove door handle rear side vw caddy 2006

I need to paint rear door left side and need to know how to remove handle ?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

SOURCE: TRYING TO REMOVE A REAR DOOR OUTER HANDLE

Lower hole in the door jamb loosten allen screw until the cap comes off. Upper hole there is a #20 torx slightly down and inboard of the hole, you need a really long torx bit and pull the handle out slightly. It also helps to pull weatherstrip loose so you can see it.

Posted on Aug 06, 2008

Ad
  • 328 Answers

SOURCE: How do you remove the door panel on a 1997 GMC 1/2 ton trucks?

http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c1528008f768
Hope this helps!

Posted on Feb 16, 2009

c17hydro
  • 2984 Answers

SOURCE: need to remove left rear door panel

  1. If equipped, remove the window crank handle by using a retaining clip removal tool.
  2. Remove the door handle bezel by inserting a flat trim removal tool between the door panel and handle bezel to release the locking tabs.
  3. Remove all door panel electrical connectors .
  4. Remove the door panel push pins and trim screws. Lift the door panel up and out to release the door panel locking tabs.

Posted on May 22, 2009

  • 316 Answers

SOURCE: Interior trim panel removal instruction

Normal 0 . Disconnect your negative battery cable. Locate and remove the screws that hold your interior door handles in place (they may be hidden by snap in, or snap on clips). Remove the interior door handles, then disconnect the wire clips to the switches. Your panel is held in place by snap in clips; use a small pry bar to pull them from the door (try to get as close to, or directly under the clips to prevent them from tearing out of the door panel). Once the clips are pulled, pull the panel upward to remove it from the door.
Install in reverse.


If you don't have power windows you will have to remove the manual window crank. It is held in place by a clip on the back side of the base. To remove the clip, you will need a small hook (kind of like a knitting needle). Put the hook in behind the base, and grab the clip and pull it off. To replace it, slide the clip back on the window crank, and snap it back on the door.

Posted on May 31, 2009

  • 1986 Answers

SOURCE: need to remove inner rear passenger side door

On the inside trim, you can remove screws (these screws may be covered by filler pieces or may be visible, or they may require you pry a plastic piece off that covers the screws) that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you need to pull back the weather seal and then you can access the bolts securing the outer handle

Posted on Nov 05, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Drivers door won't open from outside


remove door panel,peel back water barrier on top left side,remove 10mm bolt on back of door handle,in top of door jam remove 10mm bolt and Phillips screw right below bolt,carefully pull out door handle and remove rod from it,contact Volu parts in Atlanta Ga at 1-888-280-4057 and order white plastic pivot arm,they will know what you need. remove metal drift pin from handle by squeezing with pliers lightly!!! and pulling remember most handle parts are plastic and old be careful. the only door handle new is OEM and over 100.00 and you have to paint to match car.

Jan 26, 2013 | 1998 Volvo V90

1 Answer

How to remove and replace rear door handle on 2003 lincoln ls. I know how to remove door panel - skip this portion. Just need to replace door latch (rear-left side)


unhook the linkages and any elec connectors then the three bolts on outside of door thats how u do the latch. which is it latch or handle?

Aug 22, 2010 | Lincoln LS Cars & Trucks

3 Answers

Vw caddy 2006 heater blower switch only works on 4 , it does not blow on 1,2,3 ps it is a caddy van ,,,,i had to put corrado cause it didnt have caddy on there site


I have the same problem on my Caddy /07. Switch only works on #4. Seems they should have supplied switches without faults. Any one know how to remove the dash switch?

Jul 01, 2010 | 1994 Volkswagen Corrado

1 Answer

Dismount door panel VW Golf


To remove the external door handle is not nessecery to dismount the door panel. Just follow my instruction: Open the door. Above the latch you will find small round plastic cover 1 inch of diameter.Remove it.There is screw T35 or T40 head/judish star/.Unscrew.Than slide the handle to the right about 1cm.Carefully pul out left side.That is it.

Jan 14, 2010 | 2001 Volkswagen Golf

1 Answer

Need to remove inner rear passenger side door


On the inside trim, you can remove screws (these screws may be covered by filler pieces or may be visible, or they may require you pry a plastic piece off that covers the screws) that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you need to pull back the weather seal and then you can access the bolts securing the outer handle

Nov 05, 2009 | 2006 Honda Pilot

3 Answers

1997 buick park ave 4 door right front door handle won,t work from the outside


Order the exterior door handle AND the clip that attaches the rod to the exterior handle from your local dealership ( any part in the salvage yard will have at least as much wear as the one U are replacing ) Also order a can of touch up paint matching your car. After you have the parts and have painted the new exterior handle, roll down the window and remove the interior door panel. ( instructions have been posted at 'replace door lock buttom' ) Two nuts, one on each side, hold the broken handle in place and must be removed ( DON'T loose them ). Loosen the rod from the clip at the top to allow a bit more room, But take note on the way it is attached ( you will need to reattach the rod to new handle ) To install new mechanism put the new clip on the rod, carefully place the gasket and the new handle in place and install nuts to secure. Test the door handle and make sure it works. Reinstall interior door panel.

Jul 06, 2009 | 1997 Buick Park Avenue

1 Answer

Need to remove left rear door panel


  1. If equipped, remove the window crank handle by using a retaining clip removal tool.
  2. Remove the door handle bezel by inserting a flat trim removal tool between the door panel and handle bezel to release the locking tabs.
  3. Remove all door panel electrical connectors .
  4. Remove the door panel push pins and trim screws. Lift the door panel up and out to release the door panel locking tabs.

May 22, 2009 | 2006 Chevrolet Silverado

2 Answers

2005 toyota sequoia rear door latch lever broke need help in finding it


purchase a paint roller tool where the roller part is only about 4" or so long. tear off the soft roller. bend the bar another 45 degrees so the angle from the handle to the part that had the roller on it is about 135 degrees. make sure all 4 doors are unlocked.
get on your knees and look on the right side of the handle where it goes into the door. you will see where you will insert the paint roller. now stand up. facing the door hold the paint rollerhandle in your right hand so it is sticking straight out from the door horizontally . insert the business end into that hole vertically. you will then feel for the "pad" which you are going to depress inside the door. when you feel it, turn the handle you are holding to the right slightly because you are now gong to push on that pad towards the front of the car. in order to do that, you need more clearance and that is why you are moving the handle. use your left hand to stablize your tool at the bend. at the same time put some of your weight on the door as if you were pushing it closed. you will hear it unlatch. lift the door as if the door handle worked. voila. the door is open.

May 12, 2009 | 2006 Toyota Sequoia

1 Answer

How do you replace the driver's side door handle on a 1991 vw?


on this car there should be a black strip cover on the inside of door handle. take small screw driver and remove it starting from near lock cylinder, pry very gently and cover should come off, then gently peel the cover towards the front of the car until it is off. phillips screw is located in the rear of the door and at the front of the handle.

Mar 21, 2009 | 1991 Volkswagen Jetta

4 Answers

Door handle broken (rear left)


broken right rear door handle on 2002 chev impala

Sep 09, 2008 | 2002 Chevrolet Impala

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

650 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...