Question about 2003 Ford E250

Open Question

My brake lights dont work on my E250 van, high up light does work, installed new bulbs, new multi function switch, still no good

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
jrod1125420
  • 161 Answers

SOURCE: Ford Focus side brake lights

i have had this problem before with fords and the solution i found was to take out the door chime and clean up the conacts and then instal it again just how it was in there.....first i would disconnect the negative side of the battery before you do this because when i did it i got zapped. after you connect it try the brake lights and tell me what happens.

also #2 check for a bad ground wire (any black wire attached to the body or frame usually with a green screw) check for corrosion. if corrosion is present take off that wire and scuff up both sides of where the screw and the eyelet connect with the body then connect again.

Posted on Sep 30, 2008

Ad
csmock132
  • 4669 Answers

SOURCE: No Brake Lights, unable to switch from park to drive

It is not the multifunction switch. The power feed goes thru the brake switch before the multi function. You have no power the the brake switch because your shift interlock is not allowing you to shift it. I'll look up the wiring diagram and repost with a solution.

Posted on Apr 25, 2009

  • 155 Answers

SOURCE: 2006 ford escape brake lights don't work. the

Replace the brake switch located on the brake pedal shaft.

Posted on Jun 08, 2009

  • 70 Answers

SOURCE: 97 Ford E250 Running lights and dash lights not working

best bet is get a WIRING DIAGRAM. you should have current (12 volts) on both sides of the fuse that works the tailights.if not there is probably a broken wire or a shorted wire leading up to the fuse. you kinda need the wiring diagram so u can see in which order the current "flows" which will help point u in the right direction.

Posted on Sep 06, 2009

  • 65 Answers

SOURCE: 2006 ford e250 van\r\rear tail lights dimmed and now dont work(.)

check the fuses and relays under the hood next to the battery. if they still dont work it might be in the wiring or if it has a tow package it might be in the trailer wiring

Posted on Feb 09, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Brake lights & Hazzard lights don't work; fuse ok... High mounted center brake light works... Turn signals work...suspect problem is multifunction lever Power drain to battery constant...2...


As for the brake lights push brake pedal down while pushing on and wiggling the hazard switch.If the brake lights come on then replace the multi-function switch.

Aug 10, 2011 | 1997 Oldsmobile Bravada

1 Answer

1982 chevy van no brake lights everything else works new brk lite switch dont no what to do now HELP


Check for power in and out of the switch with brake pedal depressed.If ok check to see if your hazard lights work you could have a faulty turn signal switch your brake lights feed through the T/S switch.Also make sure your bulbs are good.

Dec 23, 2009 | 1992 Chevrolet C/K 2500

2 Answers

Two out of three brake light are not working


In this case, if it is the High Mount brake light that is working and the two lower lights that are not working it could be the Multi Function switch in the steering column. Easy test, Have a friend stand behind the car while you step on the brake pedal. Once the one light does come on, pull back on the turn signal stalk as if to switch from high beams to low beams, if the lights then come on, it is probably your multi function switch.

Nov 02, 2009 | 1996 Chevrolet Monte Carlo

2 Answers

Mazda 626 1991 back brake ligths not working


Is the fuse for the brake lights OK?
Check for power to the brake light switch at the brake pedal and for power coming from it with brake pedal depressed.

Sep 06, 2009 | 1991 Mazda 626

1 Answer

No Brake Lights 1993 Chevy Astro Van


Check the ground wire & leads, if not try the multi-function switch in the column

May 29, 2009 | 1993 Chevrolet Astro

1 Answer

Malfunctioned; unplugged, plugged back in, seems OK. Yes?


In my professional opinion, you have separate problems (if your description is accurate and haven't left anything out). # 1, the high mounted brake lamp is not part of the multi-function switch circuit (it's separate) - ONLY BRAKE LIGHTS.
#2 the other problem could very well be the multi-function switch because it controls the tail lamp relay in the Engine Compartment Junction box (under hood electrical box). When the parking lights are turned on, that high mounted 3rd brake lamp is NOT supposed to come on. It should only come on when the brake pedal is depressed. My professional experience/opinion, you either have the wrong bulb (single filament) in one of the brake lamp sockets in the rear of the vehicle, or one of those dual-filament brake lamp bulbs is shorted internally. You can verify this by pressing the brake pedal and see if the dash/cluster lights come on.

May 10, 2009 | Hyundai Accent Cars & Trucks

2 Answers

The brake lights wont work


connect a length of wire from switch to bulb on the positive `s . if this works then there is a break in the loom

Nov 08, 2008 | 1999 Mazda 626

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

57 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5520 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...