Question about Cars & Trucks
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
I just did this, successfully, on an 2002 Audi a4 Avant, thanks to the radio manual. Follow these instructions if you have four 4-digit code at the ready:
Turn on the radio's power. When it reads: SAFE, push AS and RDS simultaneously. Then enter the 4-digit code, using the first four buttons used to program stations. Each will go from 0-9. When you have all four numbers entered, push AS and RDS simultaneously again. The radio should now play.
Posted on Dec 24, 2008
IF YOUR ENGINE WON T TURN OVER AFTER YOU FITTED A NEW STARTER MOTOR..I WOULD START WITH THE BATTERY MYBE DEFECTIVE NOT HOLDING FULL CHARGE....THEN CHECK WIRING.....GET BACK TO ME IF YOU NEED MORE HELP !!
Posted on Mar 17, 2009
this is info i pulled but not sure exactly what engine you have...here are a couple though
REMOVAL & INSTALLATION
Fig. After the negative battery cable is disconnected, remove the wire terminals from the starter solenoid
Fig. Remove the lower starter mounting bolts . . .
Fig. . . . followed by the upper bolt, then remove the starter from the transaxle housing
Fig. Lower starter bolt locations-1994 2.0L, 2.0L ABA
Fig. Remove the upper starter bolts
Fig. Mark the location and length of each starter bolt
Fig. When the solenoid is energized the starter drive is pushed out and meshes with the flywheel to crank the engine
The engine must be supported on 1990-97 Passat models as the starter mounting bolts also support the engine-to-transmission mounting surface. If necessary, label the small wires before disconnecting them.
On 1990-97 Passat models:
Release the number 50 electrical connector from the starter.
Remove the starter mounting bolts, while supporting the weight of the starter.
On vehicles with a manual transaxle, there is a bushing where the starter shaft fits into the bell housing. If the shaft or bushing is worn or if the starter has been jamming, the bushing should be replaced. There is a special bushing removal tool available but a small inside bearing removal tool is usually sufficient.
Install the starter into the transaxle.
Posted on Jul 09, 2009
SOURCE: Fan on Audi A4 Avant not working
'Fraid I can only vouch for the A6, but the A4 is very similar and has many common components. On the A6 it's reasonably easy, as the access is from behind the glovebox on the inside and under a filter next to the battery on the outside. Audi's are notorious for having burnt-out/seized heating blower fans, so your diagnose is probably correct... :(
Posted on Sep 18, 2009
Tips for a great answer:
Nov 04, 2010 | 2001 Audi A4
Aug 20, 2010 | 1997 Audi A4
Jun 04, 2010 | 2000 Audi A4
Sep 17, 2009 | 2000 Audi A4
Jul 07, 2009 | 2000 Audi A4
Mar 15, 2009 | 1998 Audi A4
34 people viewed this question
Usually answered in minutes!