Question about Ford Mustang

Open Question

1997 ford mustang convertible seat belt won't unlock

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad
  • 184 Answers

SOURCE: I have a 1997 Ford Escort. The rear seat belt is stuck

make sure that the rear seats are properly locked into rear catches as this can stop your seatbels from working if ok then sounds like your seatbelt is faulty req new seatbelt.

Posted on Mar 08, 2009

Ad
johnjohn2
  • 5763 Answers

SOURCE: 1998 ford mustang seat belt jammed will not come

make sure that nothing is stuck inside the belt retracter,if not then i would replace it,you cant open it up or it might not work properly in a crash, try pulling it lightly a few times to see if it frees up.

Posted on May 13, 2010

Gozer
  • 435 Answers

SOURCE: how do i remove the back seat to my 2000 ford

On the seat bottom left and right of center there's a release clip. (see photo) Carefully push the release with a flat screw driver and pull up doing one side at a time.
Once the seat bottom is removed there's 2 bolts holding the seat back in place, remove the bolts and lift the seat back straiting up.


a2d03ac.jpg

Posted on Jun 08, 2010

  • 6 Answers

SOURCE: seat belt won't retract complete, drivers side

have a look to see if its coiled in twisted as you pull the belt out if the buckle doesn't line straight to the female end well its probely retracted in twisted to repair pull the belt out all the way and then realign the belt its quite hard to do so take your time hope this helps.

Posted on Jun 03, 2011

canwoodjc
  • 3301 Answers

SOURCE: My 2002 Mazda Protege driver

first try blowing it out with a air hose,, if that doesn't work, save yourself some money , and just grab one from a junk yard , there are no warranty statements that I could locate for your question

Posted on Sep 06, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

98 mustang convertible not responding


e brake engaged?
check every fuse with a tester.
leaking fluid anywhere? fill reservoir behind back seat and check for a leak so you can seal it.
might have to replace the switch.

Sep 05, 2012 | 1998 Ford Mustang

1 Answer

Seat belt buckle stuck in locked position


Try sliding a thin long metal shim such as a butterknife in between, you may have to "Pickthe Lock",once it unlocks, you'll need to go see "Yard" for a used retainer that has 1 big bolt thru the floor, under the seat

Jul 12, 2012 | 1997 Ford Crown Victoria

1 Answer

My 1993 Ford Mustang convertible won't go up.But the motor is coming on.Also it will go down thou


There must be a hydraulic fluid leak somewhere. Check to see if there is oil filler cap on your hydraulic pump located in the trunk compartment. Fill if necessary with just enough fluid to raise the top. The reason it won't go up is cause it is lacking pressure from the low fluid

Jun 26, 2012 | 1993 Ford Mustang

1 Answer

Rag top / convertible top motor/pump won't work. Needs fluid or motor?


most soft tops are operated with an electric wiper motor could be just a rust problem, check behind the seat or in the boot of the car, these are normally behind a panel, a little Q20 should sort it out

May 09, 2017 | 2000 Ford Mustang

1 Answer

97 ford mustang.the fan won't change positions


First thing I would check is all of your vacuum lines. I had same problem and turned out there was a split in one of my vacuum lines. Once I repaired it, it worked perfectly again.
thanks,
Lee

Jul 26, 2011 | 1997 Ford Mustang Cobra

1 Answer

I need the routing diagram for the serpentine belt on a 1997 Mustang 4.6 liter.


1997 FORD MUSTANG - V8 4.6L 281ci GAS FI N V
Belt Routing Diagram Multiple Accessory

4a2f6ad.jpg



1997 FORD MUSTANG - V8 4.6L 281ci GAS FI N X
Belt Routing Diagram Multiple Accessory
bd5c8ac.jpg


Hope this help (remember rated and comment this).

Mar 29, 2010 | 1997 Ford Mustang Cobra

1 Answer

My seat belt alarm stays on most the time but


The sensor in the bottom buckle is faulty. You can bypass it if you'd like.

Sep 26, 2009 | 2000 Ford Mustang

1 Answer

2001 mustang seat belt locked up and will not let it go forward


2001 mustang coupe

the right back seat seat belt is locked up.

will not retract or let more belt out

Jul 20, 2008 | 2001 Ford Mustang

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

81 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

78289 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

fordexpert

Level 3 Expert

5655 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...