Question about 2006 Chevrolet Colorado

Open Question

How to replace an o2 sensor on a chevy colorado 2006 4 cylinder

Posted by Anonymous on

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 11 Answers

SOURCE: how to replace 2006 chevy colorado thermostat

find where top hose comes from the radiator into the engine block, then drain some of the coolant out and remove hose and thermostat from the block. remember which way the termostat sits in the block and install new one. its always a good idea to flush your cooling system before putting in a new thermostat. if the old one was plugged up, the gunk thats in your system will just plug up the new one in time too. you can get a bottle of radiator flush from most auto parts stores.

Posted on Aug 23, 2009

c17hydro
  • 2984 Answers

SOURCE: how do i change out the knock sensor on a 2006 chevy colorado

You didn't list your engine size so please pick the applicable to your motor size:

Removal & Installation 2.8L & 2.9L Engines To Remove:

  1. Lift the vehicle high enough to gain access to the knock sensor (KS) through the left front wheelhouse.
  2. Remove the left front wheel and wheelhouse liner.
Knock sensor (KS) (A), Engine harness (B), Knock sensor (KS) connector (C)


e44e83f.gif
  1. Disconnect the knock sensor (KS) connector.
  2. Detach the knock sensor (KS) from the engine block.
To Install:
  1. Attach the knock sensor (KS) to the engine block.
    • Tighten the bolt to 18 ft lbs (25 Nm).
  2. Connect the knock sensor (KS) connector.
  3. Install the left front wheelhouse liner and wheel.
  4. Fully lower the vehicle.

Posted on Sep 03, 2009

  • 1608 Answers

SOURCE: how do i replace an o2 sensor in a 2005 chevy

If you did not get an o2 sensor code or you didn`t get the codes read then I would not be replacing anything.The light is on for a reason and in order to find out why you have to get the codes read.Auto Zone or most parts stores will do this for free.Save your self some money and before you buy and replace the o2 sensor make sure that is the problem.There are 2 o2 sensors on this vehicle.Hope this helps.Good luck.

Posted on Mar 16, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have changed the plugs and wires ignition coil and cleaned the fuel injectors on my chevy aveo 2006 and it still had misfire codes on cylinder 2 and 3. what could it be? My check engine light burned out...


Try to disconnect the positive terminal on the battery for a minute to reset th computer. If the codes come back, then there is still a problem which usually is ignition or fuel (or bad O2 sensor). The car could run fine with a sputtering fuel injector but give misfire codes.If injectors don't give out a mist the cylinder doesn't burn the fuel all the way. If you replaced the ignition coil pack then get the injectors cleaned professionally or rebuilt.

If the injectors aren't working at peak capacity, then the air/fuel ratio will be off and the O2 sensor will try to compensate for the richness or leanness of the ratio by adding more fuel or cutting it. That could show up as a misfire.
SO you might have to go to a mechanic and have them check fuel pressure and test the fuel injectors for good spray pattern

Mar 05, 2015 | 2006 Chevrolet Colorado

1 Answer

Replaced thermostate and coolant sensor now i have code po 171 to lean bank 1


You may have a engine vacuum leak, check for leaks with a bottle of propane gas and a length of rubber tube like fuel line, if you find a leak the engine idle will change. If no leaks are found the O2 sensor may be defective.

Nov 05, 2012 | 2006 Tracrac Chevy Colorado - Standard bed...

1 Answer

Does 2006 Chevy Colorado 5 cylinder engine have timing belt


Hello Geek beak.

No belt, the Colorado uses a timing chain setup.
If you have further questions regarding this, please ask me here.

Thank you for using FixYa.

KL

Jan 28, 2011 | 2006 Chevrolet Colorado

1 Answer

How do i replace an o2 sensor in a 2005 chevy Colorado. I have the yellow engine light on solid. I was told that this is an indication that sensor #1 has to be replaced.. I wondered how to replace it and...


If you did not get an o2 sensor code or you didn`t get the codes read then I would not be replacing anything.The light is on for a reason and in order to find out why you have to get the codes read.Auto Zone or most parts stores will do this for free.Save your self some money and before you buy and replace the o2 sensor make sure that is the problem.There are 2 o2 sensors on this vehicle.Hope this helps.Good luck.

Mar 16, 2010 | 2005 Chevrolet Colorado

1 Answer

How do i change out the knock sensor on a 2006 chevy colorado


You didn't list your engine size so please pick the applicable to your motor size:

Removal & Installation 2.8L & 2.9L Engines To Remove:
  1. Lift the vehicle high enough to gain access to the knock sensor (KS) through the left front wheelhouse.
  2. Remove the left front wheel and wheelhouse liner.
Knock sensor (KS) (A), Engine harness (B), Knock sensor (KS) connector (C)


e44e83f.gif
  1. Disconnect the knock sensor (KS) connector.
  2. Detach the knock sensor (KS) from the engine block.
To Install:
  1. Attach the knock sensor (KS) to the engine block.
    • Tighten the bolt to 18 ft lbs (25 Nm).
  2. Connect the knock sensor (KS) connector.
  3. Install the left front wheelhouse liner and wheel.
  4. Fully lower the vehicle.

Sep 03, 2009 | 2006 Chevrolet Colorado

Not finding what you are looking for?
2006 Chevrolet Colorado Logo

Related Topics:

199 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...