Question about 2002 Chrysler Voyager
Flasher relay too fast
Posted by Anonymous on
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
usually codes for the braking system will be under body or chassis. most of the time over the counter scanners will not have access to these modules. your problem could be anywhere from the abs module to one of the wheel speed sensors going bad. you can test the wheel speed sensors to see if they are working correctly by jacking the vehicle up and checking one wheel at a time. wheel speed sensors give out an a/c voltage when the reluctor ring on the axles passes by the sensor.
before you run the tests it would be a good idea to make sure the wheel speed sensors are clear of any debris where the sensor picks up the signal from the reluctor wheel.
using a digital multimeter set it to read a/c voltage on a 2v scale or lower is possible millivolt scale will usually work
disconnect the connector at the wheel speed sensor and touch the DMM to the terminals on the sensor itself ans spin the wheel, see if the DMM reads the voltage change as you spin the wheel. repeat these steps for each sensor. *the voltage should steadily rise and fall as the wheel speeds up and slows down respectively. if the voltage is all over the place its usually a good sign that the sensor is bad.
if all sensors seem to be working properly you can trace the wiring from each sensor to see if there is a short or break in the wiring.
without the proper scan tools testing the module is near impossible unless you can find the schematics for the module and start testing inputs and outputs.
hope this helps!
Posted on Feb 17, 2009
the relay is located in the power distribution box under the hood the relay will be a square black or gray cube just pull out and make sure you rerplace it with the same type relay. refer to your owners manual for any questions regarding the fuses and relays
Posted on May 08, 2009
Your battery terminals are not tight enough. If the leads on top of your battery are just a little loose, then you loose your dash lights and gauges. They come right back when you tighten your battery terminals.
Posted on Aug 17, 2009
Tips for a great answer:
May 12, 2017 | Hyundai Cars & Trucks
Feb 15, 2016 | 2002 Chrysler Town & Country
Sep 27, 2015 | Chrysler Cars & Trucks
Sep 18, 2015 | Chrysler Cars & Trucks
Apr 28, 2015 | Cars & Trucks
Mar 20, 2015 | Cars & Trucks
Jan 20, 2015 | 2011 Kia Optima SX
Jan 25, 2014 | GMC Sierra 1500 Cars & Trucks
219 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: