Question about Isuzu Trooper

1 Answer

Need instruction on cv shaft replacement

Wish to know how to replace the cv shaft

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    Night Owl:

    An expert who has answered 10 or more questions between 12 midnight and 6am on the same day.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 26 Answers

Most front wheel drive cars are the same,remove large outer nut on axle/hub with air impact or breaker bar,disconnect tie rods ,ball joints,etc so half shaft can be pulled straight out,usually with a firm jerk or pry gently where axle enters carrier housing

Posted on Jan 12, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
Nitrotrike
  • 589 Answers

SOURCE: CV joint replacement

Generally no tool is required. If you use a "pickle fork" you will risk damaging the dust boot.

Have you tried whacking the spindle right near where the ball joint stud comes through? This will take a few good shots to break it loose.

Be careful not to hit the threads!

Posted on Jun 25, 2008

justuscc
  • 360 Answers

SOURCE: Replacing Outside Driver's CV Joint Boot

yes but youl have to give it a good whack with a "brass hammer" so you dont mar or damage the joint

Posted on Sep 18, 2008

mas66
  • 104 Answers

SOURCE: CV Joint Axle Replacement

It's not an easy job, and a very messy one! If you have never done CV's before, I suggest you take it to a CV specialist, as they will do it quickly and cheaply in comparison to the hardship you will have to go through doing it yourself. These vehicles are common for the axles rusting into the hubs and siezing in there, and often the whole hub needs to be removed and the axle heated and pressed out. The new CV's often don't come with a tone wheel for the ABS system and you may need to swap the old tone wheel onto the new CV joint, and measure the alignment of it with the sensor when refitting.

Posted on Oct 21, 2008

yotaguy
  • 232 Answers

SOURCE: Half shaft replacement....

There's no need to replace the entire shaft, inspect th CV joint,make sure it's still well greased and replace the torn boot,they make a quick replace boot,they are easy to install and alot cheaper.
http://shop.oreillyauto.com/ProductList.aspx?parttype=741&ptset=A&searchfor=CV+Boot+Kit+-+Quick+Boot+Style

Posted on May 25, 2009

stevenhurc
  • 450 Answers

SOURCE: how to replace front cv shafts ?

remove inner cv boot, just on inside edge is circlip which holds inner bearing joint into outer housing remove circlip and separate joint outer housing does not come out of front diff unless you drop or remove whole front diff assembly
will have to remove whole stub axle hub assembly to remove drive shaft from outer wheel stub axle (hub) assembly

Posted on Aug 06, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Have gear oil leaks under transmission in two holes next where the axel meets on each side


Keith the seals will need replaced, take into a shop and have a tech give estimate for repair. Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
half shaft seal replacement Google Search
How To Install Replace Front CV Axle Shaft 2002 09 GMC Envoy and XL XUV
Part 1 How To Replace Front Axle Shaft Seal RH Front Chevy GMC
CV axle replacement Subaru Outback 2000 Legacy Forester Install Remove...


May 04, 2016 | Cars & Trucks

1 Answer

Cv joint replacement


Replace the half shaft its a pain but worth it

May 03, 2013 | 2000 Ford Focus

2 Answers

Cv joint but the plastic thang that go around it


One would have to remove the half shaft to service the cv joint properly.

CV-Joints Overhaul Check the CV-boot for wear tccs7030.jpg

Removing the outer band from the CV-boot tccs7031.jpg

Removing the inner band from the CV-boot tccs7032.jpg

Removing the CV-boot from the joint housing tccs7033.jpg

Clean the CV-joint housing prior to removing boot tccs7034.jpg

Removing the CV-joint housing assembly tccs7035.jpg

Removing the CV-joint tccs7036.jpg

Inspecting the CV-joint housing tccs7037.jpg

Removing the CV-joint outer snapring tccs7038.jpg

Checking the CV-joint snapring for wear tccs7039.jpg

CV-joint snapring (typical) tccs7040.jpg

Removing the CV-joint assembly tccs7041.jpg

Removing the CV-joint inner snapring tccs7042.jpg

Installing the CV-joint assembly (typical) tccs7043.jpg

prev.gif next.gif

Oct 08, 2010 | 2004 Oldsmobile Alero

2 Answers

When I turn corners in my 03 aviator it makes a loud clicking noise rather I turn left or right. What can it be?


axle CV joints. Check 4 boots for tears. Also grab shafts and tug--check for play in joints. Replace axles that have play in CV joints. Let us know if you need instructions.

Oct 06, 2010 | 2005 Lincoln Aviator

1 Answer

Clicking sound in right front wheel, feel like it is the wheel bearing. Need advise on how to repair


If this is a front wheel drive car then the sound is the Constant Velosity (CV) joint, usually happens when the CV joint boot tears and let in road debris. You can remove the shaft and knock the joint off the shaft clean and replace boot and refill with grease, you will need a CV Boot Kit for your car, or you can replace the shaft. Hope this helps, let me know.

Aug 08, 2010 | Ford F-150 Cars & Trucks

1 Answer

I need to know if special tools are needed to replace the drivers side CV joint on my 2000 Ford Windstar.


I would buy a rebuilt axle half shaft from your parts store and replace. It is cheaper than CV, boot. grease, and seal And, you have new CV's on each end of axle half shaft, not 1.

Aug 04, 2010 | 2000 Ford Windstar

1 Answer

Need instructions to replace front passengers side cv joint


Do yourself a favor and replace the whole cv shaft. Quicker, eaiser and not much money. First get the car in the air and remove the wheel. Then pop the lower ball joint. This is done by unbolting it from the knuckle and using a ball joint seperator fork and a hammer. Then remove the spindle nut on the end of the cv shaft. You push down on the lower A arm pulling the ball joint out of the knuckle and push the cv shaft out of the hub. Once these are dislogged, you can movel the strut and hub out of the way and pull the cv shalt out of the trans axle. Push the new one in and reverse what you did.

Aug 08, 2009 | 1996 Chevrolet Cavalier

3 Answers

My front differential is leaking!


I cannot see it, but I am guessing that you need to replace your axle seal. To do this,you have to pull your CV shaft out. Remove the tire, remove the caliper from the top of the rotor. Using a hammer on the back, remove the rotor. Take off the spindle (axle) nut, separate the axle (CV shaft) from the hub. Replace seal. It should pop right out. Good luck!

Aug 05, 2009 | GMC Sierra 1500 Cars & Trucks

1 Answer

Half shaft replacement....


There's no need to replace the entire shaft, inspect th CV joint,make sure it's still well greased and replace the torn boot,they make a quick replace boot,they are easy to install and alot cheaper.
http://shop.oreillyauto.com/ProductList.aspx?parttype=741&ptset=A&searchfor=CV+Boot+Kit+-+Quick+Boot+Style

May 25, 2009 | 2004 Ford F150

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

85 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14381 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...